MEASUREMENT AND TESTS. All measurements hereunder shall be made from static tank gauges on 100 percent tank table basis or by positive displacement meters. All measurements and tests shall be made in accordance with the latest ASTM or ASME-API (Petroleum PD Meter Code) published methods then in effect, whichever apply. Volume and gravity shall be adjusted to 60 degrees Fahrenheit by the use of Table 6A and 5A of the Petroleum Measurement Tables ASTM Designation D1250 in their latest revision. The crude oil delivered hereunder shall be marketable and acceptable in the applicable common or segregated stream of the carriers involved but not to exceed 1% S&W. Full deduction for all free water and S&W content shall be made according to the API/ASTM Standard Method then in effect. Either party shall have the right to have a representative witness all gauges, tests and measurements. In the absence of the other party’s representative, such gauges, tests and measurements shall be deemed to be correct.
MEASUREMENT AND TESTS. The measurement and tests for quality of gas delivered hereunder shall be governed by the following:
MEASUREMENT AND TESTS. 8.1 Buyer shall operate at or near the point(s) of delivery, an orifice meter, or meter(s). Seller, insofar as Seller's leasehold and other mineral rights enable it to do so, will furnish Buyer sites for its metering facilities. Except as otherwise specifically provided to the contrary in this Article, orifice meters or other measurement devices shall be installed and volumes computed in accordance with accepted industry practice. Seller shall have access to such metering equipment at reasonable hours, but the reading, calibrating, adjusting, operation and maintenance thereof may be done only by Buyer.
MEASUREMENT AND TESTS. All measurements hereunder shall be made in accordance with the ConocoPhillips Company Crude Oil and Condensate Quantity and Quality Determination Guidelines attached as Appendix 1. The Product delivered hereunder shall be marketable and acceptable in the applicable common or segregated stream of the carriers involved but not to exceed 1% S&W.
MEASUREMENT AND TESTS. 7.1 Measurement Point - The Gas sold under this Agreement shall be measured at or near the Delivery Point at pressures in existence from time to time and shall be corrected to the unit of measurement, which shall be one (1) MMBtu.
MEASUREMENT AND TESTS. SECTION l:
MEASUREMENT AND TESTS. 2.1 The Meter Operator shall measure the quantities delivered. The measuring equipment shall be constructed, installed and operated as follows:
MEASUREMENT AND TESTS. Quantities of the Product delivered hereunder shall be delivered from tank gauges on 100% tank table basis, or by the use of mutually acceptable automatic measuring equipment. Volume and gravity (API) of said quantities shall be corrected for temperature to 60 degrees Fahrenheit in accordance with the latest – A.S.T.M.-I.P. Petroleum Measurement Tables. Product delivered hereunder shall be merchantable and acceptable to the carriers involved. Full deduction shall be made for all BS&W content as determined by tests conducted according to the latest A.S.T.M.
MEASUREMENT AND TESTS. The measurement and tests for quality of gas received and delivered hereunder shall be governed by the following: 8.1 The volume shall be measured by orifice meters with linear charts, 24-hour rotation, or other mutually agreeable measuring devices installed and operated, and computations made, as prescribed by the American Petroleum Institute and published as Gas Measurement Committee Report No. 3, American Gas Association, as revised and reprinted in September 1969, including any appendices or amendments thereto, or such other method as may be mutually acceptable. 8.2 The unit of volume for purposes of measurement shall be one (1) cubic foot of gas at a temperature base of sixty degrees (60°) Fahrenheit and at a pressure base of fifteen and twenty-five thousandths (15.025) pounds per square inch absolute. 8.3 The arithmetical average of the hourly temperature recorded during each day, and if a recording gravitometer is installed, the hourly specific gravity recorded each day, the factors for the average hourly temperature and specific gravity according to the latest test therefor and the correction for deviation from Xxxxx’x Law applicable during each day shall be used to make proper computations of volumes hereunder. Chart integration and volume computations shall be made by the Party (or its agent) that owns the measurement facilities at the Points of Receipt and Points of Delivery as accurately as possible and within the accuracy prescribed by the manufacturer of the computing equipment used.
MEASUREMENT AND TESTS. 9.1 Measurement Point - The natural gas sold hereunder shall be ----------------- measured at or near the Delivery Point(s) on Tennessee's system at pressures in existence from time to time and shall be corrected to the unit of measurement, which shall be one MMBtu. 9.2
