Load Rating. The Consultant shall complete a bridge load rating for inventory and operating conditions for design and Florida Legal Load configurations.
Load Rating. This category of service consists of the analysis of bridges to determine their live load carrying capacities in accordance with the AASHTO Manual for Bridge Evaluation. Inventory and operating ratings shall be calculated for the H and HS trucks and also for Idaho’s Type 3, 3S2, 3- 3 and 121 xxx trucks. Analysis methods may include any of the following: allowable stress, load factor, and load and resistance factor. Deliverables shall be in an electronic format as specified by ITD.
Load Rating. The load rating of the cart shall be raised-relief molded into the lid. Load rating in pounds will be stated in both English and Spanish.
Load Rating. DLZ will conduct a load rating of the bridge in accordance with the Indiana Bridge Inspection Manual. If the load rating for any of the load rating vehicles falls below 1.0, DLZ will meet with the LOCAL PUBLIC AGENCY to discuss options to increase the load rating and make design modifications and plan revisions, accordingly. These design modifications and plan revisions will be performed on an hourly rate basis and are limited to 95 hours. If the design modifications and plan revisions require additional hours, a supplemental agreement will be prepared for the additional effort.
Load Rating. No equipment weighing in excess of the load per square foot which such floor was designed to carry, or which is allowed by law, shall be placed upon the Demised Premises. Tenant shall not make connection to the utilities except by or through existing outlets. Tenant shall not install or use machinery or equipment in or about the Demised Premises that uses water, gas, chilled water or electricity in excess of the capacity specifications for such utility or service as provided to the Demised Premises as a part of Landlord's Work, nor may Tenant suffer or permit any act that causes any use of water, gas, chilled water or electricity in excess of the capacity specifications for such utility or service as provided to the Demised Premises as a part of Landlord's Work. Tenant shall not use the utilities or services provided for the Demised Premises for any purpose other than their intended use. Tenant shall reimburse Landlord for any actual excess expenses or costs that may arise out of a br
Load Rating. No equipment weighing in excess of the load which such floor, roof or other structure or portion thereof was designed to carry, or which is allowed by law, shall be placed upon such portion of the Premises.
Load Rating. Carts must be designed to regularly receive and dump the following amount of waste material, excluding the weight of the cart, without permanent damage or deformation. The load rating must conform with ANSI Standard Z245.30-2008. Approximately 65 Gallon – approximately 224 pounds Approximately 95 Gallon – approximately 330 pounds Contactor must submit a normal printed color sales brochure which shows the exact products being proposed and the corresponding load ratings. Contractor must mark the location of the load ratings on the brochure with bold red arrows so as to aim directly at the load ratings. The load rating in the sales literature must match the specifications and ANSI certification submitted by the Contractor, and the load rating permanently marked on the cart.
Load Rating. The term ‘‘load rating’’ means the determination of the safe vehicular live load carrying capacity within or above the tunnel using struc- tural plans, and information gathered from an inspection. The results of the load rating may include the need for load posting. Operating rating. The term ‘‘operating rating’’ has the same meaning as in § 650.305.
