Junction Boxes. Fiber optic junction boxes shall be as shown in the Standard Details and on the plans. The installation of fiber optic junction boxes shall be consistent with that which is described in the Technical Specifications and all applicable Standard Details.
Junction Boxes. The Contractor inspects and ensures that: all junction boxes are kept closed at all times; junction boxes are cleaned weekly; the hinges and locking devices are maintained and if found defective, repaired immediately.
Junction Boxes. Any junction boxes installed by NEMO shall be outside the County right-of-way and at least 10 feet from the outer edge of such right-of-way, unless explicitly approved by the County on a case-by-case basis. Exhibit D Form of Notice of Acceptance Notice of Acceptance [month] [day], 202[ ] NEMO Wind, LLC [NEMO address] Re: Road Maintenance Agreement by and between Northeast Missouri Wind, LLC, a Delaware limited liability company (“NEMO”) and the Board of County Commissioners of Knox County, Missouri (“County”) dated [month] [day], 202[ ] (“Agreement”) Dear NEMO Wind, LLC: Pursuant to Section 4.2 of the Agreement, we had the opportunity to inspect the Post-Construction Repairs on [all of the Designated Roads] or [those portions of the Designated Roads listed below:]. This letter is to provide NEMO notice of the County’s approval of the Post-Construction Repairs to the [Designated Roads] or [those portions of the Designated Roads set forth above]. Subject to Section 4.4 of the Agreement, NEMO shall no longer be responsible for the maintenance or repair of the [Designated Roads] or [those portions of the Designated Roads set forth above]. [Enclosed please find the original Post-Construction Repair Security, which is hereby released by the County.]2 Capitalized terms used but not defined herein shall have the meanings given to them in the Agreement. Very truly yours, Board of County Commissioners of Knox County, Missouri 2 Include with final Notice of Acceptance. Exhibit E Form of Punchlist (attached) Northeast Missouri Wind Project – Road Maintenance Agreement Punchlist Date: Roads Inspected: Road Inspection Date: Punchlist
Junction Boxes. Junction Boxes shall be of high impact resistant, UV resistant Polycarbonate material. Junction boxes located in the units shall be distributed in order to place them as near as possible to the center of their associated instruments. The degree of protection shall be at least IP 65 using closed cell neoprene gaskets with detachable lids and stainless steel captive screws. They will be built in accordance with safety requirements and will be fitted with cable glands (bottom mounted). Cable glands shall be brass, double compression type with PVC protective shrouds. Junction boxes will be fitted with an extension earth terminal.
Junction Boxes. No. Specification Description
Junction Boxes. Junction boxes shall be sized in accordance with the requirements of the National Electric Code Article 314.28 and applicable tables of Chapter 9, and manufacturer recommendations determined based on the size and number of conduits attached to the junction box. The junction box size shall be a minimum of 24” high X 24” wide X 10” deep
Junction Boxes. 23.1 Check the condition of the junction box and tightness of terminations.
Junction Boxes. The array junction boxes shall be dust and waterproof made of UV resistance plastic. It shall have suitable cable entry points fitted with cable glands of appropriate sizes for both incoming and outgoing cables. Suitable markings shall be provided on the bus bar for easy identification and cable ferrules shall be fitted at the cable termination points for identification. The array junction box shall have suitable surge protection.
Junction Boxes. Provide stainless steel 4X lockable junction boxes when surface-mounting. Provide cast- iron junction box when box is shown mounted in the concrete. Supply liquidtight strain relief connector fittings to portable cord.
Junction Boxes. Junction boxes shall not be installed in wet xxxxx irrespective of the DSEAR zone classification. If junction boxes are required they shall be mounted upon suitable up stands or in a below ground junction box chamber within a suitably IP rated enclosure.
