Isolators Sample Clauses

Isolators. The isolators shall comply to IEC 62271-102 in general. Isolators shall be motor (DC powered) operated. Earth switches are provided at various locations to facilitate maintenance. Main blades and earth blades shall be interlocked and interlock shall be fail safe type. All earth switches shall be motor operated type. Isolator shall be suitable for Bus Transfer Current Switching duty as per IEC standard. High speed earthing switches shall be provided for grounding purpose at overhead line terminations & cable terminations & cable terminations and shall have fault making capability as specified. Earth switch for line isolator shall be of earthing switch class E1 and shall be suitable for induced current switching duty as defined for Class-B as per relevant standard.
Sample 1Sample 2
AutoNDA by SimpleDocs
Isolators. 1,2,1 WALL MOUNTED COOKER PLUG UNIT 1/PHASE No 4 1,2,2 16A S/PHASE AIRCONDITIONER ISOLATOR No 4 1,2,3 30A 3/PHASE AIRCONDITIONER ISOLATOR No 4 1,2,4 30A ISOLATOR and COVER PLATE No 4 1,2,5 60A 3/PHASE STOVE ISOLATOR No 4 1,2,6 20A 3/PHASE ISOLATOR No 4 1,3 HOT WATER CYLINDERS 1,3,1 2KW GEYSER ELEMENT ( HARD WATER) No 3 1,3,2 2KW ELEMENT/THERMOSTAT COMBINATION (HARD WATER) No 3 1,3,3 THERMOSTAT (Short) No 3 1,3,4 THERMOSTAT (Long) No 3 1,3,5 3KW URN ELEMENT No 3 1,3,6 TIMER GYSER DIGITAL DIN RAIL 220-240AC TDDGT No 3 Subtotal ( carried to Subtotal 1,3) 1,4 LV CABLE TERMINATIONS 1,4,1 TURFLON GLANDS: - No. 0 No 100 1,4,2 TURFLON GLANDS: - No. 1 No 25 1,4,3 TURFLON GLANDS: - No. 2 No 10 1,4,4 PRATLEY STEEL GLAND (NO. 2) No 5 1,4,5 PRATLEY STEEL GLAND (NO.4) No 5 Subtotal ( carried to Subtotal 1,4)
Sample 1
Isolators. Isolators shall be arranged to permit safe maintenance of any section of the equipment when the remainder are alive. They shall be suitable for operation while the equipment is alive and designed for them to make or break the charging currents of open busbars and connections or load currents shared by parallel circuits. The minimum total length of air gap between terminals of the same pole with the isolator open shall be designed to provide an impulse withstand level in excess of that specified for the insulation of the substation to earth. Such withstand shall preferably be not less than 15% greater than the withstand to earth and shall in no case be less than the minimum corresponding figure for the isolating distance as given in IEC 62271-102. Where manual operating mechanisms are required operation shall be possible from ground level. Isolator mechanisms shall be so designed that the primary contacts can not be opened by forces due to currents passing through them, and shall be self-locking in both the "open" and "close" positions. The mechanism shall open and close all poles simultaneously. Service conditions require that isolators shall remain alive and in service without being operated and without maintenance for periods of up to two years in corrosive atmosphere over a wide temperature range. In such conditions the contacts will be expected to remain capable of carrying this rated normal and short-circuit currents without overheating or welding. After such periods the maximum operating torque required shall not exceed twice the torque required during type tests and should be within the capabilities of one man (i.e. approx. 340 Nm). When made of steel or malleable iron, operating boxes, handles, rods, tubes and other fittings for outdoor type equipment shall be galvanised. Main bearings, pins etc. shall preferably be of the self lubricating type to reduce routine maintenance to a minimum.
Sample 1

Related to Isolators

  • Devices BNY Mellon will restrict the transfer of Customer Data from its network to mass storage devices. BNY Mellon will use a mobile device management system or equivalent tool when mobile computing is used to provide the services. Applications on such authenticated devices will be housed within an encrypted container and BNY Mellon will maintain the ability to remote wipe the contents of the container.

  • Smoke Detectors At Owner's expense, smoke detectors will be installed on the Property in working condition in accordance with the law prior to the tenant's occupancy. During the occupancy, it shall be the tenant's responsibility to maintain all smoke detectors. Owner will replace smoke detector equipment as needed.

  • Inoculations The Employer agrees to pay all expenses for inoculation or immunization shots for the employee and for members of an employee’s family when medically required as a result of said employee’s exposure to contagious diseases where said officer has been exposed to said disease in the line of duty.

  • Illumination The Engineer shall refer to TxDOT’s Highway Illumination Manual and other deemed necessary State approved manuals for design of continuous lighting and safety lighting for all conventional, high-mast, and underpass lighting. The Engineer shall include safety lighting as part of each design on each flashing beacon and traffic signal. The Engineer shall provide a preliminary layout for initial review and approval by the State. The Engineer shall prepare circuit wiring diagrams showing the number of luminaries on each circuit, electrical conductors, length of runs, service pole assemblies. Underpass lighting must be used on all structures within each project. The Engineer shall integrate existing illumination within the project limits into the proposed design. The Engineer shall coordinate with the State to determine the location of proposed high-mast, conventional, and underpass lighting.

  • Intercept Devices 26.1.1.1 Local and federal law enforcement agencies periodically request information or assistance from local telephone service providers. When either Party receives a request associated with an End User of the other Party, it shall refer such request to the Party that serves such End User, unless the request directs the receiving Party to attach a pen register, trap-and-trace or form of intercept on the Party's facilities, in which case that Party shall comply with any valid request.

  • Vaccinations Contractor understands, acknowledges, and agrees that, pursuant to Article II of the General Appropriations Act, none of the General Revenue Funds appropriated to the Department of State Health Services (DSHS) may be used for the purpose of promoting or advertising COVID-19 vaccinations in the 2024-25 biennium. It is also the intent of the legislature that to the extent allowed by federal law, any federal funds allocated to DSHS shall be expended for activities other than promoting or advertising COVID-19 vaccinations. Contractor represents and warrants that it is not ineligible, nor will it be ineligible during the term of this Contract, to receive appropriated funding pursuant to Article II.

  • Welding Welding and use of cutting torches or cutoff saws will be permitted only in areas that have been cleared or are free of all material capable of carrying fire. Flammable debris and vegetation must be removed from within a minimum 10-foot radius of all welding and cutting operations. A shovel and a 5-gallon standard backpack water container filled and with handpump attached shall be immediately available for use in the event of a fire start. C8.212 – MARKET-RELATED CONTRACT TERM ADDITION (11/08). The term of this contract may be adjusted when a drastic reduction in wood product prices has occurred in accordance with 36 CFR 223.52. The Producer Price Index used to determine when a drastic reduction in price has occurred is stated in A20. Purchaser will be notified whenever the Chief determines that a drastic reduction in wood product prices has occurred. If the drastic reduction criteria specified in 36 CFR 223.52 are met for 2 consecutive calendar quarters, after contract award date, Contracting Officer will add 1 year to the contract term, upon Purchaser’s written request. For each additional consecutive quarter such a drastic reduction occurs, Contracting Officer will, upon written request, add an additional 3 months to the term during Normal Operating Season, except that no single 3-month addition shall extend the term of the contract by more than one year. Contracting Officer must receive Purchaser’s written request for a market-related contract term addition before the expiration of this contract. No more than 3 years shall be added to a contract's term by market-related contract term addition unless the following conditions are met:

Time is Money Join Law Insider Premium to draft better contracts faster.