Insurance Services Office form number Sample Clauses

Insurance Services Office form number. (CA 00 01) covering BUSINESS AUTO COVERAGE, symbol 1 “any auto”; or the appropriate coverage provided by symbols 2, 7, 8, or 9.
Sample 1Sample 2Sample 3See All (4)
AutoNDA by SimpleDocs
Insurance Services Office form number. (CA 00 01) covering BUSINESS AUTO COVERAGE, symbol 1 “any auto”; or the appropriate coverage provided by symbols 2, 7, 8, or 9. Workers’ Compensation Workers’ Compensation coverage, as required by the Industrial Insurance Act of the State of Washington, as well as any similar coverage required for this work by applicable federal or “Other States” state law. Stop Gap/Employers Liability Coverage shall be at least as broad as the protection provided by the Workers’ Compensation policy Part 2 (Employers Liability) or, in states with monopolistic state funds, the protection provided by the “Stop Gap” endorsement to the general liability policy. Property Insurance Insurance Services Office form number (CP 00 10) covering BUILDING AND PERSONAL PROPERTY COVERAGE and Insurance Services Office form number (CP 10 30) CAUSES OF LOSS – SPECIAL FORM or project appropriate equivalent. National Flood Insurance The use of CDBG and HOME funds for acquisition or construction purposes in identified special flood hazard areas shall be subject to Contractor mandatory purchase of flood insurance as required by Section 102(a) of the Flood Disaster Protection Act of 1973 (Pub L. 93-237). Builder's Risk/Installation Floater The Contractor shall procure and maintain during the life of the Contract, or until acceptance of the project by King County, whichever is longer, “All Risk” Builders Risk Insurance at least as broad as ISO form number CP0020 (Builders Risk Coverage Form) with ISO form number CP0030 (Causes of Loss—Special Form) including coverage for collapse, theft and property in transit. The coverage shall insure for direct physical loss to property of the entire construction project, for one hundred percent of the replacement value thereof. The policy shall be endorsed to cover the interests, as they may appear, of King County, Owner, Contractor and subcontractors of all tiers with King County listed as a loss payee. Minimum Limits of Insurance—Capital Projects The Contractor shall maintain limits no less than the following: Commercial General Liability: $1,000,000 combined single limit per occurrence by bodily injury, personal injury, and property damage; and for those policies with aggregate limits, a $2,000,000 aggregate limit. Professional Liability, Errors, and Omissions: $1,000,000, Per Claim and in the Aggregate. Automobile Liability: $1,000,000 combined single limit per accident for bodily injury and property damage if the use of motor vehicles is contemplated. Wor...
Sample 1Sample 2
Insurance Services Office form number. (CA 00 01) covering BUSINESS AUTO COVERAGE, symbol 1 “any auto”; or the appropriate coverage provided by symbols 2, 7, 8, or 9. Workers’ Compensation Workers’ Compensation coverage, as required by the Industrial Insurance Act of the State of Washington, as well as any similar coverage required for this work by applicable federal or “Other States” state law. Stop Gap/Employers Liability Coverage shall be at least as broad as the protection provided by the Workers’ Compensation policy Part 2 (Employers Liability) or, in states with monopolistic state funds, the protection provided by the “Stop Gap” endorsement to the general liability policy. Property Insurance Insurance Services Office form number (CP 00 10) covering BUILDING AND PERSONAL PROPERTY COVERAGE and Insurance Services Office form number
Sample 1
Insurance Services Office form number. CA 0001 covering, Code 1 (any auto), or if CONSULTANT has no owned autos, Code 8 (hired) and 9 (non-owned), with limit no less than $1,000,000 per accident for bodily injury and property damage.
Sample 1

Related to Insurance Services Office form number

  • Application to the Office of Rail and Road XXX shall have the right under the Contracts (Rights of Third Parties) Xxx 0000 to enforce directly such rights as have been granted to it under this contract.

  • NYS OFFICE OF INFORMATION TECHNOLOGY SERVICES NOTIFICATION All New York State Agencies must notify the Office of Information Technology Services of any and all plans to procure IT and IT -related products, materials and services meeting required thresholds defined in Technology Policy NYS–P08-001: xxxxx://xxx.xx.xxx/sites/default/files/documents/NYS-P08-001.pdf, as may be amended, modified or superseded. SALES REPORTING REQUIREMENTS Contractor shall furnish OGS with quarterly sales reports utilizing Appendix I - Report of Contract Sales. Purchases by Non- State Agencies, political subdivisions and others authorized by law shall be reported in the same report and indicated as required. All fields of information shall be accurate and complete. OGS reserves the right to unilaterally make revisions, changes and/or updates to Appendix I - Report of Contract Sales or to require sales to be reported in a different format without processing a formal amendment and/or modification. Further, additional related sales information and/or detailed Authorized User purchases may be required by OGS and must be supplied upon request. Reseller Sales Product sold through Reseller(s) must be reported by Contractor in the required Appendix I – Report of Contract Sales. Due Date The Appendix I - Report of Contract Sales will be quarterly (January - March, April - June, July - September and October - December). Reports will be due 1 month after the closing quarter. SERVICE REPORTS FOR MAINTENANCE/SUPPORT AND WARRANTY WORK Service Reports for Authorized User An Authorized User in an RFQ may require compliance with any or all of this section. If requested by the Authorized User, the Contractor shall furnish the Authorized User with service reports for all Maintenance/support and warranty work upon completion of the services. The service reports may include the following information in either electronic or hard copy form as designated by the Authorized User:  Date and time Contractor was notified  Date and time of Contractor’s arrival  Make and model of the Product  Description of malfunction reported by Authorized User  Diagnosis of failure and/or work performed by Contractor  Date and time failure was corrected by Contractor  Type of service – Maintenance/support or warranty  Charges, if any, for the service Service Reports for OGS

  • Medical Benefits - Prescription Drugs Administered by a Provider (other than a pharmacist) This plan covers prescription drugs as a medical benefit, referred to as “medical prescription drugs”, when the prescription drug requires administration (or the FDA approved recommendation is administration) by a licensed healthcare provider (other than a pharmacist). Please note: Specialty prescription drugs meeting these requirements or recommendations are covered as a pharmacy benefit and not a medical benefit. These medical prescription drugs include, but are not limited to, medications administered by infusion, injection, or inhalation, as well as nasal, topical or transdermal administered medications. For some of these medical prescription drugs, the cost of the prescription drug is included in the allowance for the medical service being provided, and is not separately reimbursed.

  • Notice of City Policy THE CITY OPPOSES DISCRIMINATION ON THE BASIS OF RACE AND SEX AND URGES ALL OF ITS CONTRACTORS TO PROVIDE A FAIR OPPORTUNITY FOR MINORITIES AND WOMEN TO PARTICIPATE IN THEIR WORK FORCE AND AS SUBCONTRACTORS AND VENDORS UNDER CITY CONTRACTS.

  • Office of Supplier Diversity The State of Florida supports its diverse business community by creating opportunities for woman-, veteran-, and minority-owned small business enterprises to participate in procurements and contracts. The Department encourages supplier diversity through certification of woman-, veteran-, and minority-owned small business enterprises and provides advocacy, outreach, and networking through regional business events. For additional information, please contact the Office of Supplier Diversity (OSD) at xxxxxxx@xxx.xxxxxxxxx.xxx.

  • Report of the Settlement Agreement to the Office of the Attorney General Of California

  • Office Visit Copayments In each year of the Agreement, the level of the office visit copayment applicable to an employee and dependents is based upon whether the employee has completed the on-line Health Assessment during open enrollment and has agreed to opt-in for health coaching.

  • Financial Services Compensation Scheme We are a participant in the Financial Services Compensation Scheme (the “FSCS”). As a retail client you may be eligible to claim compensation from the FSCS in certain circumstances if we, any approved bank, our nominee company or eligible custodian are in default. Most types of investment business are covered in full for the first £85,000 of any eligible claim. Not every investor is eligible to claim under this scheme: for further information please contact us, or the FSCS directly at xxx.xxxx.xxx.xx.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67

  • Long Description (If Applicable Training to provide the knowledge, skills and abilities needed as a result of agency mission, policies, or procedures. . Training to acquire the knowledge, skills and abilities needed as a result of assignment to new duties and responsibilities when such training is not part of a planned, career development program (e.g., training provided to a staffing specialist who has been newly assigned to a position involving classification duties).

Time is Money Join Law Insider Premium to draft better contracts faster.