Herbicide Application. Apply herbicides to unwanted vegetation in compliance with all herbicide application requirements as set forth by the California Department of Pesticide Regulations (CA DPR), Environmental Protective Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA) label, the Material Safety Data Sheet, and the site specific HMMP. Herbicides will be applied by a spot spray application direct application must be done in a way to preserve and protect native habitat. Contractor shall, throughout the length of the Contract, provide all personnel, equipment, vehicles, tools, materials, qualified supervision and other items and services necessary to perform herbicide applications. Herbicide solutions include the following:
Herbicide Application. When needed and where there is no feasible alternative to herbicide treatment, ORGANIZATION NAME will use agents and application procedures with the greatest target specificity and lowest toxicity.
Herbicide Application i. Within the Watershed, no aerial spray will be conducted within 1 mile of any legal and/or designated intake or water impoundment.
Herbicide Application. Hourly Spray is defined as time spent applying herbicides to target vegetation, as well as the following on-site spray related activities:
Herbicide Application use of equipment or vehicles to apply herbicides to control invasive plants including brush
Herbicide Application. 1. The contractor shall provide and apply herbicide under supervision of a Professional Applicator licensed to apply pesticides in a forested environment.
Herbicide Application. Herbicide application will be accomplished by the use of an acceptable system capable of injecting the chemical below the water surface directly into the plant bed. Prior to application, the contractor will provide to the COR the proposed method of application for approval.
Herbicide Application. 1.3.8 Supply and installation of grout.
Herbicide Application. The Permittee shall only apply herbicides in accordance with state and federal law. No herbicides shall be used where Threatened or Endangered species occur. Foliar application of herbicides shall not be used when wind velocities are above 5 miles per hour or when nesting birds could be exposed. Wick or xxxx herbicide application methods may be used if the wind velocities exceed 5 miles per hour. Only products that are labeled safe for aquatic use may be used for this Project.
Herbicide Application. To minimize the need for re-treatment, foliar herbicide application should not occur when rain is anticipated within four hours at the treatment site. • For cut surface treatments, herbicide should be applied at concentrations equal to or less than 50 percent of the maximum concentration permitted by the label, through proper application technique and timing. • To minimize the need for retreatment, glyphosate should be applied to the cut xxxxx immediately (within 1 hour) following cutting of the stem during cut xxxxx treatment. Application Rates Typical and maximum application rates for glyphosate. Application Treat/Control Invasive Species Typical (Maximum) pounds/acre Active Ingredient Glyphosate Manual – ground (backpack) 2.0 (4.0) Cut surface 1.0 (2.0) • Percent solution for foliar spraying of shrubs should be between 1 ½ and 2% percent or in such concentration as to effectively control target species, however, concentrations shall not exceed maximum active ingredient per acre and/or labeled rates(whichever one is less). • Non-ionic surfactant should be applied with foliar treatments, per manufacturer’s recommendations (generally ½ percent solution by volume).
