Law Compliance In providing the SOLID WASTE HANDLING SERVICES required by this AGREEMENT, CONTRACTOR shall observe and comply with all applicable federal and, state laws, regulations and codes regarding the provision of the SOLID WASTE HANDLING SERVICES described herein, as such may be amended from time to time, including where required by such laws, the funding and maintenance of sufficient closure and post-closure maintenance financial assurances for any landfill operated or utilized by CONTRACTOR for disposal of the SOLID WASTE. Any violation of this Paragraph shall constitute a major breach.
Georgia Security and Immigration Compliance Act Requirements No bid will be considered unless the Contractor certifies its compliance with the Immigration reform and Control Act of 1986 (IRCA), D.L. 99-603 and the Georgia Security Immigration Compliance Act OCGA 13-10-91 et seq. The Contractor shall execute the Georgia Security and Immigration Compliance Act Affidavit, as found in Section 7 of the Construction Contract. Contractor also agrees that it will execute any affidavits required by the rules and regulations issued by the Georgia Department of Audits and Accounts. If the Contractor is the successful bidder, contractor warrants that it will include a similar provision in all written agreements with any subcontractors engaged to perform services under the Contract.
Anti-Corruption Compliance (a) For the past three (3) years, neither the Company nor any of its Subsidiaries, nor, to the knowledge of the Company, any director, officer, employee or agent acting on behalf of the Company or any of the Company’s Subsidiaries, has offered or given anything of value to: (i) any official or employee of a Governmental Authority, any political party or official thereof, or any candidate for political office or (ii) any other Person, in any such case while knowing that all or a portion of such money or thing of value will be offered, given or promised, directly or indirectly, to any official or employee of a Governmental Authority or candidate for political office, in each case in violation of the Anti-Bribery Laws.
ANTI-BRIBERY COMPLIANCE The Parties hereby acknowledge the importance of combating and preventing bribery and to that end both Parties agree to comply fully with all applicable laws, regulations and sanctions relating to anti-bribery and anti-corruption.
INDEMNITY/COMPLIANCE 4.1 A-E shall indemnify, defend with counsel approved in writing by COUNTY, and hold harmless, the COUNTY, its agents, officers, and employees from employer sanctions and any other liability which may be assessed against A-E or the COUNTY or both in connection with any alleged violation of any Federal or State statutes or regulations pertaining to the eligibility for employment of any persons performing work under this CONTRACT.
Compliance with Texas Privacy Laws and Regulations In performing their respective obligations under the Agreement, the LEA and the Provider shall comply with all Texas laws and regulations pertaining to LEA data privacy and confidentiality, including but not limited to the Texas Education Code Chapter 32, and Texas Government Code Chapter 560.
Permit Compliance Such Party fails to obtain and maintain in full force and effect any Permit (other than the Regulatory Approval) necessary for such Party to perform its obligations under this Agreement.
DBE/HUB Compliance The Engineer’s subcontracting program shall comply with the requirements of Attachment H of the contract (DBE/HUB Requirements).
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
HIPAA Compliance If this Contract involves services, activities or products subject to the Health Insurance Portability and Accountability Act of 1996 (HIPAA), the Contractor covenants that it will appropriately safeguard Protected Health Information (defined in 45 CFR 160.103), and agrees that it is subject to, and shall comply with, the provisions of 45 CFR 164 Subpart E regarding use and disclosure of Protected Health Information.
