PRESCRIPTION MEDICATION BENEFITS, LIMITATIONS AND EXCLUSIONS The following items are limited or excluded from your Prescription Medication coverage:
Limitations and Exclusions The limitation and exclusion in this Section 8 shall not apply: (i) to the extent that liability cannot be limited or excluded according to the Applicable Law; (ii) in cases of our willful misconduct and gross negligence; (iii) in cases of bodily injuries or death caused by our negligence; and (iv) in cases of our fraud or fraudulent misrepresentation.
Conditions and Exclusions Notwithstanding anything to the contrary set forth in this SLA, this SLA and Customer’s entitlement to the remedies set out in this SLA are subject to the following conditions and exclusions:
Warranty and Exclusions If you paid a charge for the IBM SaaS then the Section 17 Warranty and Exclusions is replaced in its entirety by the following:
Limitations and exclusions of liability 16.1 Nothing in this Agreement will:
Scope of Limitations and Exclusions The limitation and exclusion in this Section 8 shall not apply: (i) to the extent that liability cannot be limited or excluded according to Applicable Law; (ii) in cases of willful misconduct and gross negligence; (iii) in cases of bodily injuries or death caused by our negligence; and (iv) in cases of fraud or fraudulent misrepresentation. In cases of gross negligence, liability is limited to the amount of foreseeable loss that would have been prevented through the exercise of due care.
GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Xxxxx of License; Limitations The Engineer is granted a limited revocable non-exclusive license to use the registered TxDOT trademark logo (TxDOT Flying “T”) on any deliverables prepared under this contract that are the property of the State. The Engineer may not make any use of the registered TxDOT trademark logo on any other materials or documents unless it first submits that request in writing to the State and receives approval for the proposed use. The Engineer agrees that it shall not alter, modify, dilute, or otherwise misuse the registered TxDOT trademark logo or bring it into disrepute.
Warranties and Exclusions 6.1 Accenture warrants that the SaaS Services provided to Client pursuant to the Agreement will comply in all material respects with the Documentation. This warranty shall not apply where: (i) the Client’s or any Authorized User's access or use of the SaaS Services is not in accordance with the Agreement or with Accenture’s instructions; (ii) modification or alteration of the SaaS Services or any systems, software or other content or materials embodied therein is made by any Party other than Accenture; or (iii) the SaaS Services are being provided free of charge, or as a trial, pre-release or as a beta release.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
