Goods Not Wholly Produced or Obtained Sample Clauses

Goods Not Wholly Produced or Obtained. 1. For the purposes of Article 2.1(b) (Originating Goods), except for those goods covered under Paragraph 2, a good shall be treated as an originating good if:
Sample 1Sample 2Sample 3See All (15)
AutoNDA by SimpleDocs
Goods Not Wholly Produced or Obtained. 1. For the purposes of Article 2.1(b) (Originating Goods), except for those goods covered under Paragraph 2, a good shall be treated as an originating good if: 3 “International law” refers to generally accepted international law such as the United Nations Convention on the Law of the Sea.
Sample 1Sample 2Sample 3See All (7)
Goods Not Wholly Produced or Obtained. 1. For goods that do not have originating status under subparagraph (a) of Article 4.2 (Originating Goods) and are not covered under Annex 4B (Product Specific Rules of Origin), a good shall be considered originating if all non-originating materials have undergone at least a change in tariff sub-heading (CTSH) level of the Harmonized System, and the QVC of the good is not less than 35 per cent of the FOB value as per build-up formula or 45 per cent of the FOB value calculated as per build-down formula under Article 4.6 (Calculation of Qualifying Value Content), provided that the final production process of the manufacture of the good is performed within the territory of the exporting Party.
Sample 1

Related to Goods Not Wholly Produced or Obtained

  • Wholly Obtained or Produced Goods For purposes of Article 3.1.1(a), the following goods are wholly obtained or produced entirely in the territory of one or both of the Parties: (a) live animals born and raised in the territory of Korea or Peru; (b) goods obtained from live animals born and raised in the territory of Korea or Peru; (c) goods obtained by hunting, trapping, fishing, or aquaculture in the territory of Korea or Peru1; (d) goods of sea-fishing and other goods taken from the sea outside the territory of a Party by vessels registered or recorded with a Party and flying its flag; (e) goods produced on board factory ships, exclusively from the goods referred to in subparagraph (d), provided that such factory ships are registered or recorded with a Party and fly its flag; (f)

  • REPAIRED OR REPLACED PRODUCTS, PARTS, OR COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including warranties, as set forth in the Warranties clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturers’ installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.

  • Sale or License of Custom Products Involving Tax Exempt Financing (i.e., Certificates of Participation - COPS) The Authorized User’s sale or other transfer of Custom Products which were acquired by the Authorized User using third party, tax-exempt financing may not occur until such Custom Products are, or become, useable. In the event that the Contractor wishes to obtain ownership rights to Custom Product(s), the sale or other transfer shall be at fair market value determined at the time of such sale or other transfer, and must be pursuant to a separate written agreement in a form acceptable to the Authorized User which complies with the terms of this paragraph.

  • Tandem Switched Transport 7.3.4.2.1 For traffic delivered through a CenturyLink or CLEC tandem Switch (as defined in the Agreement), the Parties agree that, because this State is a new market for CLEC, tandem switched transport functions for Exchange Service (EAS/Local) non-transit traffic shall be compensated based upon the xxxx and keep compensation mechanism. Xxxx and keep will apply to both the tandem switching rate and the tandem transmission rate. Xxxx and keep shall govern compensation for such traffic exchanged by the Parties in this State until the earlier of: (1) the expiration of the Agreement, or (2) further action by the Federal Communications Commission (FCC), or a court of competent jurisdiction, vacates, replaces, modifies, or supersedes the applicable rules adopted in Order on Remand and Report and Order, CC Docket Nos. 96-98, 00-00, XXX 00-000 (xxx. Apr. 27, 2001). 7.3.4.2.2 Intentionally Left Blank.

  • Third Party Products 1. Third Party Hardware. We will sell, deliver, and install onsite the Third Party Hardware, if you have purchased any, for the price set forth in the Investment Summary. Those amounts are payable in accordance with our Invoicing and Payment Policy.

  • Preference for Domestically Manufactured Goods The provisions of paragraphs 2.54 and 2.55 of the Guidelines and Appendix 2 thereto shall apply to goods manufactured in the territory of the Borrower.

  • REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.

  • OWNERSHIP OF WRITTEN PRODUCTS All reports, documents or other written material (“written products” herein) developed by Consultant in the performance of this Agreement shall be and remain the property of City without restriction or limitation upon its use or dissemination by City. Consultant may take and retain copies of such written products as desired, but no such written products shall be the subject of a copyright application by Consultant.

  • USE OF RECYCLED OR REMANUFACTURED MATERIALS New York State supports and encourages contractors to use recycled, remanufactured or recovered materials in the manufacture of products and packaging to the maximum extent practicable without jeopardizing the performance or intended end use of the product or packaging unless such use is precluded due to health or safety requirements or product specifications contained herein. Refurbished or remanufactured components or products are required to be restored to original performance and regulatory standards and functions and are required to meet all other requirements of this bid solicitation. Warranties on refurbished or remanufactured components or products must be identical to the manufacturer's new equipment warranty or industry's normal warranty when remanufacturer does not offer new equipment. See "Remanufactured, Recycled, Recyclable or Recovered Materials" in Appendix B, OGS General Specifications.

  • Recycled Products The Provider shall procure any recycled products or materials, which are the subject of or are required to carry out this Contract, in accordance with the provisions of sections 403.7065, F.S.

Time is Money Join Law Insider Premium to draft better contracts faster.