Common use of Geometric visibility Clause in Contracts

Geometric visibility. Horizontal angle: 45° to the front and to the rear. Vertical angle: 10° above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° in the case of a retro-reflector less than 750 mm above the ground.

Geometric visibility. Horizontal angle: 4530° to the front inwards and to the rearoutwards. Vertical angle: 10° above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° in the case of a retro-reflector less than 750 mm above the ground.

Geometric visibility. Horizontal angle: 45angles β = 30° to the front and to the rear. Vertical angle: 10angles α = 15° above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° in °, however, if the case height of a the retro-reflector is less than 750 mm above the groundmm.

Geometric visibility. Horizontal angle: 45° ( to the front and to the rear. Vertical angle: 10° ( above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° ( in the case of a retro-reflector less than 750 mm above the ground. E/ECE/324 Rev.1/Add.47/Rev.2 Regulation No. 48 page 48 6.17.6. Orientation Towards the side.

Geometric visibility. Horizontal angleangle : 4530° to the front left and to the rearright. Vertical angle: 1015° above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° in °, however, if the case height of a retro-the reflector is less than 750 mm above the ground.mm. E/ECE/324 Rev.1/Add.73/Rev.1 Regulation No. 74

Geometric visibility. Horizontal angleangle : 4530° to the front left and to the rearright. Vertical angle: 1015° above and below the horizontal. The vertical angle below the horizontal may be reduced to 5° in °, however, if the case height of a retro-the reflector is less than 750 mm above the groundmm.