General Technical Requirements. 1. Air conditioners shall be suitable for 230V, 50 Hz single phase AC supply, capable of performing the functions as Cooling, Dehumidifying, Air circulating and Filtering.
General Technical Requirements. Each lamp submitted for approval shall conform to the requirements set forth in paragraphs 4. and 5.
General Technical Requirements. Lamps submitted for approval shall conform to the requirements set forth in paragraphs 4 and 5. The requirements contained in sections 5 "General specifications" and 6 "Individual specifications" (and in the Annexes referenced in the said sections) of UN Regulations No. 48, 53, 74 or 86, and their series of amendments in force at the time of application for the lamp type approval shall apply to this Regulation. The requirements pertinent to each lamp and to the category/ies of vehicle on which the lamp is intended to be installed shall be applied, where its verification at the moment of lamp type approval is feasible.
General Technical Requirements a) The Concession Holder shall be responsible for selecting the route and path of the transmission line. The preliminary section selected for the transmission line contained in the preliminary engineering project shall be assessed by the Concession Holder, who will determine the final section. Measures shall be taken to prevent the line route from crossing archaeological zones, national parks and restricted zones.
General Technical Requirements a) The Concessionaire will be responsible for selecting the transmission line's route and track. The preliminary route selected for the transmission line contained in the engineering blueprint will be evaluated by the Concessionaire, who will define the final route. The route should avoid archaeological zones, national parks and restricted areas.
General Technical Requirements. 17 5. Specific Technical Requirements ..................................................................................................... 28
General Technical Requirements. 15.1. Horizon Utilities and the Load Customer shall comply with the general technical requirements set out in Schedule F.
General Technical Requirements a) The CONCESSIONAIRE shall be responsible for selecting the connection point, from the Piura Oeste-Pariñas 220 kV transmission line (L-2248) and the branch route (connection tie) to the Xxxxx del Xxxxx 220/60/22.9 kV substation. The preliminary proposal contained in the draft engineering documents shall be evaluated by the CONCESSIONAIRE, who shall define the definitive route. Measures shall be taken to prevent the line route from crossing archaeological zones, national parks and restricted zones.
General Technical Requirements. 20.Normal flux density (at rated voltageand frequency) – 1.6T 21.Maximum flux density (Increase of +12.5% combined voltage and frequency variation from rated voltage and frequency) - 1.9T" We request you to kindly allow the Normal flux density (at rated voltage and frequency) up to 1.69T which is in limits, as the Max flux density(Increase of +12.5% combined voltage and frequency variation form the rated voltage and frequency) is 1.9T (i.e-1.9 Tesla Max/1.125%=1.6888 Tesla ) Shall be as per Tender Specification.
General Technical Requirements. (A) Compliance Customer is responsible for obtaining and maintaining all required permits and inspections indicating that Customer’s GF complies with all applicable codes, ordinances and statutes relating to safety, construction and operation.
