Fiber. Splicing within an existing fiber cable that is carrying live traffic, or that carries customer fibers.
Fiber. Optic Cable - Each fiber-optic termination shall be tested end-to-end and must pass light in compliance with manufacturer’s specifications.
Fiber o In the metropolitan segments, single mode fiber will be used. In any case where the routes for Grantor's intercity and metropolitan networks converge, Grantor shall have the right to elect to install either non-zero dispersion-shifted optical fiber or single mode fiber. Grantor may substitute alternative fibers if and only if such alternative fibers have performance specifications which are at least equal to the specifications set forth below: Single Mode Fiber
Fiber. (a) In manufacturing Cartridges, Medica shall use fiber ----- supplied by Membrana Gmbh, a German company ("Membrana"), or other fiber -------- suppliers as specified by Nephros.
Fiber. The City shall, at the sole expense of LMH, oversee the installation of 24 strands of fiber optic cable ("LMH South Fiber") in the Kasold Drive Conduit and the LMH South Conduit. LMH shall own and be responsible for the LMH South Fiber. Costs LMH shall be responsible for all costs of the LMH South Project. The City shall be responsible for hiring K&W Underground to complete the LMH South Project and for overseeing the work. Before the work is completed, LMH will issue to the City a PO in the amount of the estimated cost of the project. At the conclusion of the LMH South Project, the City will pay K&W Underground for its work. If the cost of the work is less than the estimated cost of the project, then the City will refund the balance to LMH. If the cost of the work is more than the estimated cost of the project, then LMH shall reimburse the City, upon the City's invoice, for all costs exceeding the estimate.
Fiber. On the terms and conditions herein and in each Product Order, SRP licenses to Licensee, and Licensee licenses from SRP, the right to use the Fiber specifically described in each Product Order (the “Fiber”) and any equipment described in the Product Order as being licensed to Licensee. All right, title and interest in the Fiber and any Equipment shall at all times remain exclusively with SRP (or with any third party from whom SRP obtains the rights to the Fiber), except for the rights granted to Licensee to use the Fiber and Equipment under this Agreement and the applicable Product Order. Licensee may use the Fiber solely for providing Telecommunications Services, in accordance with applicable laws, rules, regulations, orders and other regulatory requirements, now or later in effect, of any governmental authority having jurisdiction over Licensee, the Fiber or the use thereof. This Agreement and the license granted hereunder are subject to termination or expiration as provided herein, and shall have no force or effect thereafter, except as provided in Section 2.3 (Product Orders) with respect to any Product Order that may continue to remain effective.
Fiber. 15.2 ------ 718.87 115 AMERICAN CABLE TV INVESTORS 5, LTD. AMERICAN CABLE TV OF ST. MARY'S COUNTY SCHEDULE 5.16
Fiber. The fiber reflected on the Metropolitan Access Network maps and the Long Haul Fiber Route maps are all of the fiber used for the conduct of the Business as presently conducted by the Company. All of the fiber owned by the Company is free and clear of any Lien, other than Permitted Liens. The Metropolitan Access Network and the Long Haul Fiber Route comply, and have been maintained and perform, in all material respects, with applicable Bellcore, Underwriters' Laboratory, Network Equipment Building Standards and Electronic Industry Alliance - Telecommunications Industry Association standards or equivalents. All fiber in the Metropolitan Access Network and the Long Haul Fiber Route has been built and installed substantially in accordance with applicable permits and the Metropolitan Access Network and the Long Haul Fiber Route are currently operational.
Fiber. Grantor is installing non-zero dispersion-shifted optical fiber in the long haul segments (i.e., Gateway Facility to Gateway Facility) of the Grantor System. In the metropolitan segments, single mode fiber will be used. In any case where the routes for Grantor's long-haul and metropolitan networks converge, Grantor shall have the right to elect to install either type of fiber. Grantor may substitute alternative fibers if and only if such alternative fibers have performance specifications which are at least equal to the specifications set forth below. Non-Zero Dispersion -Shifted Optical Fiber o Attenuation at 1550 nm = 0.25 dB/km max o Attenuation at 1625 nm = 0.25 dB/km max o Total Dispersion = 2.0 - 6.0 ps/nm-km for 1530 nm to 1565nm 4.5 - 11.2 ps/nm-km for 1565nm to 1625nm o Effective Area (Aeff) = 72 m(2), typical o Polarization Mode Dispersion = 0.20 ps max per fiber, typical 0.08 ps link value o Mode Field Diameter = 9.20 to 10.00 im at 1550 nm o Cladding Diameter = 125.0 +- 1.0 im o Core/Clad Concentricity <= 0.5 im Single Mode Fiber o Attenuation at 1310 nm = 0.40 dB/km max o Attenuation at 1550 nm = 0.30 dB/km max o Zero Dispersion wavelength = 1312nm typical o Wavelength cutoff<1260nm typical o Dispersion slope =<.0902ps typical o Polarization Mode dispersion = 0.20 ps max per fiber, 0.10 ps link value o Mode Field Diameter = 9.2+- 0.4 im at 1310 nm & 10.4 +-0.8 at 1550 nm o Cladding Diameter = 125.0 +- 1.0 im o Core/Clad Concentricity <=0.5 im Conduit o OSP Conduit SDR 11 o 1-1/4" (inside diameter) o High density polyethylene (HDPE) duct o Tensile yield 3200 psi o Flexural modulus 110,000 psi o Smoothwall inside & outer o Empty (no rope or tape) o Unlubricated Exhibit "F" Long Haul Network Fiber Acceptance Testing Procedures and Standards All splices will be performed with an industry accepted fusion splicing machine. Grantor will perform two stages of testing during the construction of a new fiber cable route. Initially, Optical Time Domain Reflectometer ("OTDR") tests will be taken from one direction. As soon as fiber connectivity has been achieved to both Regeneration/Opamp Facilities, Grantor will verify and record the continuity of all fibers. Grantor will take and record power level readings on all fibers in both directions. Grantor will bi-directional OTDR test all fibers. During the initial construction, it is only possible to measure the fiber from one direction. Because of this, splices will be qualified during initial construction wit...
