Failure Analysis. VENDOR shall provide a failure analysis on Products that are returned for repair under warranty. On serialized Products, repair data shall be provided for each serialized unit returned. VENDOR shall provide general failure data on out of warranty returns.
Failure Analysis. Upon written request from Buyer, Seller will perform failure analysis of Products returned to Seller with a Seller-issued Return Material Authorization number. If such analysis shows the existence of material defects in breach of applicable Seller warranties, Seller will not be entitled to payment for the cost of Seller’s failure analysis concerning such defects for the specific Products which were subject to them. In the event that Buyer repeatedly requests that Seller perform failure analysis for Products which prove to have no material defect in breach of applicable Seller warranties, Seller reserves the right to condition further failure analysis activities upon satisfactory arrangements for payment to Seller for the reasonable costs involved.
Failure Analysis. At Cisco’s request, Supplier will adhere to the failure analysis procedure as set forth in Exhibit C and provide to Cisco a failure analysis report specifying the reason for failure of any Non-Conforming Product. [***].
Failure Analysis. As part of the Support Services, Supplier shall complete an initial failure analysis on all returned Defective Products within [***] of receipt of such Products. Supplier shall deliver to JDSU, within [***] of receipt of the returned Defective Products, a written report of analysis of Supplier’s findings. If more than [***] percent ([***]%) of all units of a Product shipped to JDSU within any [***] period are defective, then Supplier shall, [***], immediately initiate a corrective action plan and perform a routine cause analysis on the Product. Supplier shall update JDSU on a daily basis with the status and findings of the said analysis and plan and provide such other reasonable information required by JDSU in connection therewith.
Failure Analysis. If an Epidemic Failure occurs: (a) Eargo will promptly notify Supplier upon discovery of the Epidemic Failure; (b) Supplier and Eargo will jointly exert all [***] efforts to diagnose the problem and plan a work-around or more permanent solution; (c) Supplier will apply its ECO procedure in appropriate circumstances for hardware problems originating in the manufacturing process; and (d) Supplier will prepare and consult with Eargo regarding an appropriate recovery plan as well as an appropriate workaround, as an interim solution, if one is needed., Subject to Supplier’s obligations in Section 17.1, Eargo will [***], if any, of a “root cause” analysis and follow-up corrective actions associated with any epidemic failure due [***].
Failure Analysis. Brocade shall provide failure analysis in accordance with the provisions of sub-Section 6.3 of Attachment C.
Failure Analysis. TRANSACT shall provide a failure analysis on Products that are returned for repair under warranty. On request by BUYER, TRANSACT will provide failure analysis for serialized units returned for a specific failure mode or region.
Failure Analysis. Within [*], SSI shall perform a formal failure analysis to root cause for all field related failures or where a Product falls outside of defined Reliability standards of the Specifications. SSI shall provide StorageTek the results of the analysis, SSI's corrective action, data regarding the effectiveness of the corrective action and disposition of Spare Parts affected by the corrective action. In addition, design failure mode effect analysis or process failure effect mode analysis, if deemed appropriate by SSI, will be conducted as part of the corrective action process. If in any [*] SSI fails to meet the minimum failure analysis "track to closure" performance minimum in the Scorecard, SSI's Vice President and General Manager for will meet with StorageTek's Vice President of Quality in Louisville, Colorado to establish appropriate corrective actions.
Failure Analysis. Supplier will perform a failure analysis of all returned Product that is suspected to be defective. Supplier will use reasonable efforts to respond within one (1) week of receipt of the Product with an initial assessment of the cause of the defect and within three (3) weeks of receipt of the Product with the root cause of the defect.
