Exhaust Fans. Resident shall consistently use exhaust fans in bathrooms, kitchens and utility rooms. Exhaust fans on automatic timers shall not be tampered with or turned off. Exhaust of moist air is essential in the prevention of moisture accumulation and mold growth. Hint: Allow exhaust fan to run during and 10 minutes after all showers; Use exhaust fan in utility room while doing laundry.
Exhaust Fans. Provide DDC start/stop control and status of twelve (12) exhaust fans. The exhaust fan starters are located in three different locations in the building. Some starters control multiple exhaust fans. Starter locations noted below: Closet near kindergarten area. (Qty. – 2 starters, 3 EFs) Corridor near admin area. (Qty. – 4 starters, 7 EFs) Corridor near custodial slop sink between bathrooms. (Qty. – 2 starters, 2 EFs) Exhaust Fan AI AO DI DO Fan S/S 8 Fan Status 8 Honeywell Shall Implement: Install new relays to provide start/stop control and status. Occupied/Unoccupied schedules and set points are to be programmed per Exhibit G1 and G2. Graphics for units showing proper points and associating alarm points with their respective graphic pages. Integration into the existing BMS.
Exhaust Fans. Provide DDC start/stop control and status of seven (7) exhaust fans. Starter locations noted below. Closet near kindergarten area. (Qty. - 1) Closet across from admin area. (Qty. - 4) Custodial slop sink between bathrooms. (Qty. - 2) Exhaust Fans AI AO DI DO Fan S/S 7 Fan Status 7 Honeywell Shall Implement: Install new relays to provide start/stop control and status. Occupied/Unoccupied schedules and set points are to be programmed per Exhibit G1 and G2. Graphics for units showing proper points and associating alarm points with their respective graphic pages. Integration into the existing BMS.
Exhaust Fans. Provide DDC start/stop control and status for one (1) exhaust fan. Starter location noted below. Inside room 18B there is a small switch Closet near kindergarten area. (Qty. - 1) Exhaust Fan AI AO DI DO Fan S/S 1 Fan Status 1 Honeywell Shall Implement: Install new relays to provide start/stop control. Occupied/Unoccupied schedules and set points are to be programmed per Exhibit G1 and G2. Graphics for units showing proper points and associating alarm points with their respective graphic pages. Integration into the existing BMS.
Exhaust Fans. Provide Direct Digital Control start/stop control and status of three (3) exhaust fans. Exhaust Fan (Typical of 3) AI AO DI DO Fan S/S 3 Fan Status 3 Honeywell Shall Implement: Install new relays to provide start/stop control. Occupied/Unoccupied schedules and setpoints as outlined in the IGA REPORT. Graphics for units showing proper points and associating alarm points with their respective graphic pages.
Exhaust Fans. Provide Direct Digital Control start/stop control and status of three (3) exhaust fans.
Exhaust Fans. Preventative maintenance service to be performed annually per manufacturer’s recommendation: • Check all electrical wiring and connections and tighten. • Check all motor starter contactor surfaces for wear. • Clean starter and electrical control enclosures. • Lubricate motor bearings and fan bearings. • Check exhaust fan belts for wear, replace as required. • Check belt tension and sheave alignment. Adjust as required. • Inspect exhaust fan unit assembly. • Check all mounting hardware. Tighten as required.
Exhaust Fans. Provide exhaust fan with occupancy sensor in each restroom. Any other exhaust fans will be considered Special Items.
Exhaust Fans. Provide exhaust fan with solid-state variable speed control switch in rooms greater than 200 square feet and in Pantry areas.
Exhaust Fans. Furnish and install an exhaust fan in each toilet room and shower room (if applicable). Install a supply air grille in the toilet rooms.
