Example for arm alignment Sample Clauses

Example for arm alignment i-Size indication The dynamic tests shall be conducted with the largest dummy and the smallest dummy as defined in the following tables according to the size range indicated by the manufacturer for the Enhanced Child Restraint System. Table 76 Selection criteria for the dummy according to the range size range indication ≤ 60 60 < x ≤ 75 75 < x ≤ 87 87 < x ≤ 105 105 < x ≤ 13525 >13525 Dummy Q0 Q1 Q1.5 Q3 Q6 Q101 1 No lateral impact test is required for size range over 135 cm until Q10 dummy injury criteria for the lateral impact test are established. Where the Enhanced Child Restraint System requires substantial modification for different sizes (e.g., convertible Enhanced Child Restraint System) or if the size range cover more than 3 size ranges a relevant intermediate dummy(ies) shall be tested in addition to the dummy(ies) defined above. If the Enhanced Child Restraint System is designed for two or more children, one test shall be carried out with the heaviest dummies occupying all seatingpositions. A second test with the lightest and the heaviest dummies specified above shall be carried out. The tests shall be conducted using the test benchas shown in Annex 6, Appendix 3, Figure 3. The laboratory conducting the tests may, if it deems it advisable, add a third test with any combination of dummies or empty seat positions. If the i-Size Enhanced Child Restraint System uses a top tether, one test shall be carried out with the smallest dummy with the shorter distance of the top tether (anchorage point G1). A second test shall be carried out with the heavier dummy with the longer distance of the top tether (anchorage point G2). Adjust the top tether to achieve a tension load of 50 ± 5 N. For side lateral impact the ISOFIX child restraint shall be tested with only the shorter distance of the top tether. If the i-Size Enhanced Child Restraint System uses a support-leg, as an anti-rotation device the hereafter mentioned dynamic tests shall be carried out as follows: The tests for frontal impact shall be conducted with the support-leg adjusted to its maximum adjustment compatible with the positioning of the trolley floor pan. The tests for rear impact shall be conducted with the worst case position selected by the Technical Service. During the tests the support-leg shall be supported by the trolley floor pan as described in Annex 6, Appendix 32, figure 2; In the case of support-legs out of the plane of symmetry, the worst case shall be selected by the Technical Se...
Sample 1Sample 2Sample 3See All (5)
AutoNDA by SimpleDocs

Related to Example for arm alignment

  • Uncontrollable Forces Tariff Provisions Section 14.1 of the CAISO Tariff shall be incorporated by reference into this Agreement except that all references in Section 14.1 of the CAISO Tariff to Market Participants shall be read as a reference to the Participating Generator and references to the CAISO Tariff shall be read as references to this Agreement.

  • Separation of Components The SOFTWARE PRODUCT is licensed as a single product. Its component parts may not be separated for use on more than one computer.

  • Unbundled Network Element Combinations 4.1 For purposes of this Section, references to “Currently Combined” Network Elements shall mean that the particular Network Elements requested by NewPhone are in fact already combined by BellSouth in the BellSouth network. References to “

  • System for Award Management (XXX) Requirement Alongside a signed copy of this Agreement, Grantee will provide Florida Housing with a XXX.xxx proof of registration and Commercial and Government Entity (CAGE) number. Grantee will continue to maintain an active XXX registration with current information at all times during which it has an active award under this Agreement.

  • Individual Flexibility Arrangement The Employer and an Employee may agree to make an individual flexibility arrangement to vary the effect of the terms of this Agreement if:

  • Individual Flexibility Arrangements 7.1 An Employer and Employee covered by the Agreement may agree to make an individual flexibility arrangement to vary the effect of terms of the Agreement if:

  • Subloop Elements 2.8.1 Where facilities permit, BellSouth shall offer access to its Unbundled Subloop (USL) elements as specified herein.

  • Multiple Listing Service (MLS) Due to rules administered by the local Multiple Listing Service (“MLS”), all details of any transaction that are procured by the Agency may be used for publication in the MLS. Seller hereby consents to such publication on an unrestricted basis whereas the Agency must comply with all applicable MLS rules to allow data about the Property to be shown and made available by the MLS in addition to other internet websites. MLS rules generally provide that any property entered into its database be updated within forty-eight (48) hours, or some other period of time, after all necessary signatures have been obtained in regard to the Property. Seller has the right to prohibit any and all publication of information in regard to a transfer of the Property. In order to exercise this right, the Seller is required to authorize a separate addendum provided by the Agency and attach to this Agreement.

  • MINOR CHANGES IN THE WORK 7.4.1 The Architect will have authority to order minor changes in the Work not involving adjustment in the Contract Sum or extension of the Contract Time and not inconsistent with the intent of the Contract Documents. Such changes shall be effected by written order and shall be binding on the Owner and Contractor. The Contractor shall carry out such written orders without delay.

  • System for Award Management (XXX) XXX.gov)

Time is Money Join Law Insider Premium to draft better contracts faster.