Equipment Safety. The College agrees that no unsafe or improperly maintained or non-functioning equipment that would jeopardize an employee’s safety shall be knowingly assigned to employees covered by this Agreement. Any malfunctioning equipment essential to the employee’s daily duties will be maintained and/or repaired in a timely fashion. The same shall be reported and documented to the Deputy Chief of Police.
Equipment Safety. 12 Article VIII. Holidays 8.1 Eligibility . . . . . . . . 13 8.2 Holiday During Vacation . . . . . 13 8.3 Holiday Pay . . . . . . . 14 8.4 Holiday Absence. . . . . . . 14
Equipment Safety. (Applies to SB1, SC1, SD1, and SI1) The City shall provide all unit members with personal protective equipment (PPE) and other safety equipment appropriate to their assignment so that they can safely do their work. Unit members should be held accountable for all equipment checked out to them. When items are checked out by unit members, there should be a check-in form. If items checked out are missing, the unit member or work crew may be subject to disciplinary action. Unsafe work behavior, loss of equipment, misuse of equipment, and neglect of equipment, failure to adhere to safety practices may cause disciplinary action. The City shall provide a two-way radio to all full-time and permanent part-time custodians assigned to a roving crew.
Equipment Safety. 14.1 It is to the mutual advantage of both the Company and the employee that employees shall not operate equipment which is not in safe operating condition and not equipped with the safety appliances required by law. Equipment declared unsafe by a Supervisor will not be put back into service until necessary repairs have been completed.
Equipment Safety. Any equipment issued that affects officer safety should be documented and forwarded to the Chief of Police through the Chain of Command. The Chief of Police or designee will have five (5) business days to acknowledge receipt of the complaint to the Vice President of the Renton Police Guild.
Equipment Safety. ATS shall build the Product to comply with ATS’s interpretation of applicable (OSHA or CSA) safety standards. ATS shall review equipment safety including guarding designs with Photowatt at a design review meeting with the intent to maximize operator safety, particularly with respect to all pinch points and moving parts. Photowatt shall advise ATS of any required equipment safety or guarding changes no later than five (5) days following the date of such design review meeting. Unless provided for in the Specifications, if Photowatt requests deviation from ATS’s interpretation of the applicable safety standards, this shall be considered a design change (See Section 5). ATS may decline any proposed change in the design by Photowatt, if ATS has concerns regarding safety, reliability, performance or warranty service.
Equipment Safety. SECTION 1. All equipment necessary to perform the work as determined by the Employer, shall be provided by the Employer. Outerwear, hip boots, rain coats, hard hats, outer safety glasses (both clear and tinted), and appropriate gloves shall be provided and made available to all employees. These items will be replaced whenever needed and outerwear, will be replaced every other year or as deemed necessary by the Superintendent.
Equipment Safety. Service and Maintenance Schedule
Equipment Safety. If a bus driver believes that the bus assigned to that employee is not in safe operating condition, she shall promptly report such belief, and the reason therefore, to the Transportation Director. After consulting with the chief bus mechanic, the Transportation Director shall determine whether or not the bus is in safe operating condition. If a bus is considered unsafe, then the driver shall not operate such equipment.
Equipment Safety. If an operator of mechanical equipment considers that the equipment is unsafe to operate before he leaves the Garage, he/she shall not be required to operate the equipment until it is inspected by the Mechanic or supervisor on duty at the time, and found not to be defective. After certification by the Mechanic or Supervisor, the employee shall commence operation of the piece of equipment.
