Energy Conservation Measures Sample Clauses

Energy Conservation Measures a. Insulation of roofs, crawl spaces, ceilings, attics, floors and around pipes/ducts as long as these measures do not induce, retain, or introduce moisture into a building, utilization of spray foam insulation is not covered under this agreement and must be reviewed in accordance with 36 CFR Part 800.
Sample 1Sample 2
AutoNDA by SimpleDocs
Energy Conservation Measures. This project consists of the design and construction of energy conservation measures on the Springfield campus. The conservation measures could consist of, but are not limited to, upgrades to or replacement of components for the lighting, heating, air conditioning, temperature control, mechanical, energy management control, and domestic water. A guaranteed energy savings contract will be requested of the provider(s) so that guaranteed savings are in amount which are anticipated to be sufficient to pay the cost of that portion of the annual Installment Payments relating to this project. INDENTURE OF TRU between U.S. BANK NATIONAL ASSO TION, as Trust and Board of Trustees of Xxx xxxx Illinois U er ity Dated as of February 1, 2014 Draft.Indenture.doc 2212033 • AGB • 11/1/13 INDENTURE
Sample 1
Energy Conservation Measures. The PMSA shall report conditions that are contrary to energy/water efficiency and shall recommend energy conservation measures, discovered during Scheduled Maintenance and when processing a DMO or IJO.
Sample 1
Energy Conservation Measures. 3.1 Performance of the Work ESP shall perform or cause to be performed the Work in strict accordance with the Contract Documents. The Work shall also include whatever is done by or required of ESP to perform and complete its duties under the Contract Documents, including but not limited to the following: the provision or furnishing of labor, supervision, services, materials, supplies, equipment, fixtures, appliances, facilities, tools, transportation, storage, power, permits and licenses required, and fuel, heat, light, cooling and all other utilities as required by this Agreement. Notwithstanding the preceding sentence, ESP may request Owner to provide power, fuel, heat, cooling, or other utilities. Upon such request Owner may, in its sole and complete discretion, elect to provide such utilities at a price set by Owner, but Owner shall have no obligation to provide such utilities. If Owner elects to provide such utilities, ESP shall indemnify, hold harmless, and defend Owner against any damages, losses, or expenses arising from ESP’s use of Owner’s facilities or utilities at the Premises. No later than INSERT DAYS days after execution of this Agreement, ESP shall provide detailed drawings and specifications concerning the ECMs and associated equipment and materials, and all impacted areas of the Premises, for Owner’s review and comment. Such documents shall become the property of Owner without restriction. ESP shall make such reasonable modifications to the drawings and specifications as Owner may require. Upon Owner’s approval of the drawings and specifications, ESP shall proceed to provide ECM Submittals as set forth in Section 3.4. Owner’s approval of any drawings, specifications, or submittals shall not be evidence that such documents, and associated Work pursuant thereto, conform to the requirements of the Contract Documents, nor shall such approval relieve or diminish in any way ESP’s obligation to comply with the Contract Documents.
Sample 1
Energy Conservation Measures. In progress. Carollo completed the initial investigations in 2020. The 2021 task effort includes additional coordination work with Nexant and SRP related to energy conservation and power monitoring. Carollo investigated alternative energy generation, energy reduction, and automation opportunities at each plant. As part of this effort, Carollo identified energy conservation measures (ECMs) that reduce energy use in areas like process controls, lighting, pumps, and motors.
Sample 1
Energy Conservation Measures. This project consists of the design and construction of energy conservation measures on the Carbondale campus. The conservation measures would consist of a combination of high efficiency lighting and plumbing upgrades, high efficiency HVAC components, energy management system upgrades, as well as miscellaneous items such as high efficiency motors and occupancy sensors.
Sample 1
Energy Conservation Measures. .03 During the Contract Documents Phase consisting of preparation of final mechanical engineering calculations, Drawings and Specifications based on approved Design Development Documents, setting forth in detail the mechanical construction requirements for the Project.
Sample 1
AutoNDA by SimpleDocs
Energy Conservation Measures. The Project shall include the following energy conservation measures which are currently requirements of the SMMC. Nothing in this Section 2.7.14 shall preclude the City from applying Subsequent Code Changes permitted in accordance with Section 5.2.
Sample 1

Related to Energy Conservation Measures

  • Energy Conservation The Contractor agrees to comply with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

  • Mitigation Measures Company shall take commercially reasonable measures (except measures causing it to incur out-of-pocket expenses which BNYM does not agree in advance to reimburse) to mitigate losses or potential losses to BNYM, including taking verification, validation and reconciliation measures that are commercially reasonable or standard practice in the Company’s business.

  • Health and Safety C8.1 The Contractor shall promptly notify the Authority of any health and safety hazards which may arise in connection with the performance of the Contract. The Authority shall promptly notify the Contractor of any health and safety hazards which may exist or arise at the Authority’s Premises and which may affect the Contractor in the performance of the Contract.

  • Environmental, Health and Safety Matters (a) The Company has complied and is in compliance with all Environmental, Health, and Safety Requirements.

  • Environmental, Health and Safety i. Environment, Health and Safety Performance. Seller acknowledges and accepts full and sole responsibility to maintain an environment, health and safety management system ("EMS") appropriate for its business throughout the performance of this Contract. Buyer expects that Seller’s EMS shall promote health and safety, environmental stewardship, and pollution prevention by appropriate source reduction strategies. Seller shall convey the requirement of this clause to its suppliers. Seller shall not deliver goods that contain asbestos mineral fibers.

  • Additional Resources The WLSC may establish workgroups that include other department representatives and/or subject matter experts. These subcommittees will conform with rules established by the WLSC.

  • Disaster Recovery and Business Continuity The Parties shall comply with the provisions of Schedule 5 (Disaster Recovery and Business Continuity).

  • Business Continuity and Disaster Recovery Bank shall maintain and update from time to time business continuation and disaster recovery procedures with respect to its global custody business, which are designed, in the event of a significant business disruption affecting Bank, to be sufficient to enable Bank to resume and continue to perform its duties and obligations under this Agreement without undue delay or disruption. Bank shall test the operability of such procedures at least annually. Bank shall enter into and shall maintain in effect at all times during the term of this Agreement reasonable provision for (i) periodic back-up of the computer files and data with respect to Customer and (ii) use of alternative electronic data processing equipment to provide services under this Agreement. Upon reasonable request, Bank shall discuss with Customer any business continuation and disaster recovery procedures of Bank. Bank represents that its business continuation and disaster recovery procedures are appropriate for its business as a global custodian to investment companies registered under the 1940 Act.

Time is Money Join Law Insider Premium to draft better contracts faster.