Electrical characteristics. When measured according to the conditions specified in annex 4, the voltage and wattage of the light source shall be within the limits given on the relevant data sheet.
Electrical characteristics. 1.3.1.1 The output jitter shall not exceed 0.75 UI under worst case operating conditions when measured in the frequency range 20 Hz to 100 KHz, as defined in ITU-T G.921 table 3.
Electrical characteristics. Three phase alternating current Nominal declared frequency : Final Voltage at Delivery Point:
Electrical characteristics. The electrical characteristics of the equipment shall be verified prior to installation of conduits and wiring for the equipment.
Electrical characteristics. The electrical characteristics of the QF shall conform with standards established by the Cooperative. The standards include voltage, current, frequency, harmonics, and automatic synchronization, etc. Wherever possible the Cooperative will base its standards on industry wide standards.
Electrical characteristics. 3.4.7.1. Electrical characteristics shall be tested at least at one sample and, in the case of a high-efficiency LED replacement light source, including and excluding the AE device(s), if any.
Electrical characteristics. Seller covenants that the Facility will be operated with the electrical characteristics specified in Section 5.2.
Electrical characteristics. No Item Unit Specification --------------------------------------------------------------------------------
Electrical characteristics. 5.1.2 Item (b)(65° rise) shall apply.
Electrical characteristics. 5.1.1 The transformer shall be designed to deal with higher losses associated with harmonics that are generated as a result of supplying non-linear loads to our commercial customers. In order to deal with harmonic loading, a K-factor rating of 4 as defined by ANSI C57.110 is required.
