Dust Suppression Sample Clauses

Dust Suppression. Soils exposed during excavation for site preparation and project construction activities shall be kept moist throughout the time they are exposed, both during and after construction work hours.
AutoNDA by SimpleDocs
Dust Suppression. Except as otherwise directed by the Employer, the Contractor shall provide dust suppression for the Contractor's yard and for the Contractor's working areas. The Employer will, however, provide dust suppression for roads and other common areas which are not used exclusively or primarily by the Contractor.
Dust Suppression. During Proposed Project activities, disturbed Project area surfaces, including unpaved access roads, shall be effectively stabilized of dust emissions (e.g., watered, covered, stabilized, or treated with a dust suppressant), consistent Onshore Compliance with the SWPPP as determined by San Diego RWQCB During Proposed Project activities Applicant or contractor Reduce impacts associated with air quality Potential Impact Mitigation Measure (MM) Location Monitoring / Reporting Action Timing Effectiveness Criteria with the Storm Water Pollution and Prevention Plan. APM-12: Stormwater Pollution Prevention Plan (SWPPP). The Applicant or its contractor shall obtain coverage for the Proposed Project under the Construction General Permit (Order No. 2009-009-DWQ, as amended by 2010- 0014-DWQ and 2012-006-DWQ). Per the requirements of the California State Water Resources Control Board (SWRCB), the Applicant or its contractor shall prepare a SWPPP to reduce the potential for water pollution and sedimentation from Proposed Project activities. The SWPPP will be project specific and expressly address site runoff, assuring that project runoff would not affect or alter drainage patterns to sensitive habitat, including but not limited to vernal pool habitat. Onshore Notification to CSLC staff that the SWPPP has been certified Prior to and during Proposed Project activities Applicant or contractor Reduce impacts associated with water quality The SWPPP shall set forth a best management practices including, but not limited to the following: • Silt fences, fiber rolls, and other measures shall be placed where they are determined to be appropriate for erosion and sediment control • A monitoring, maintenance, and reporting schedule shall be prepared and implemented and shall identify the responsible entities The Applicant or its contractor shall notify California State Lands Commission staff that the SWPPP has been certified and is available in the SWRCB’s Stormwater Multiple Applications and Reports Tracking System not Potential Impact Mitigation Measure (MM) Location Monitoring / Reporting Action Timing Effectiveness Criteria less than 30 days prior to commencement of ground disturbing activities. APM-13: Spill Prevention Control and Countermeasure (SPCC) Plan. The Applicant or its contractor shall continue compliance with the requirements of the U.S. Environmental Protection Agency (U.S. EPA; 40 CFR Part 112) through continued use of the existing SONGS SPCC Plan, including amen...
Dust Suppression. 3.1.12.1 Equipped with 145-gallon water sprinkler system
Dust Suppression. When Repowering Work begins, the Wind Operators will water the Xxxxxxx County Road(s) in a sufficient amount to eliminate the dust where houses are located along such Xxxxxxx County Road(s).
Dust Suppression. Soils exposed during excavation and project construction activities shall be kept moist throughout the time they are exposed, both during and after work hours. Step 2: The construction contractor shall be alert for the presence of contaminated soils during excavation and other construction activities (detected through soil odor, color, and texture and results of on-site soil testing), and shall be prepared to handle, profile (i.e. characterized) and dispose of such soils appropriately (i.e. as dictated by local, state and federal regulations, including OSHA lead-safe work practices) when such soils are encountered. The contractor shall ensure that soils exposed during excavation and project construction activities will be kept moist throughout the time they are exposed, both during and after work hours. Contractor Soils handling and disposal implemented as needed during construction activities SFPUC, in consultation with DPH. Completion of construction
Dust Suppression. The portal area, surface roads and workshop/laydown areas shall be watered as required to suppress wind blown or vehicle generated dust.
AutoNDA by SimpleDocs
Dust Suppression. The Contractor shall take all necessary measures to keep airborne dust to a minimum by watering. The Superintendent may direct the suspension of work at any time where that work in the Superintendent's opinion creates a dust hazard or nuisance to the public, personnel working on the site or property such as crops, stock and houses in the vicinity of the work. Where the Superintendent has directed a suspension of work and considers that the Contractor could not have been expected to have adequately controlled the dust, the Superintendent may consider an extension of time due to adverse weather conditions. No claim for increased costs due to such suspension will be considered.
Dust Suppression. AMMENDMENT TO OPSS 506 OPSS 506, May 1994 - Construction Specification for Dust Suppressants is amended as follows;

Related to Dust Suppression

  • HEATING, VENTILATING AND AIR CONDITIONING General Office Area: The building shall be equipped with a combination heating, ventilation and air conditioning system. The system shall have ducted supply and return air. The space above the ceiling shall not be used as a supply or return plenum. The systems shall be sized in accordance with the weather conditions identified in Chapter 13, “Energy Conservation” of the 1996 BOCA Building Code and supplemented by the “Building Code Rules”. All HVAC equipment shall be commercial or light industrial grade. If new construction it shall be installed at grade or within mechanical rooms for easy access and maintenance. If existing construction, roof mounted equipment will be considered after all other options have been exhausted, including the elimination of noise and vibration transfer to the structural members. The HVAC systems shall be zoned, with units sized and placed as required by heating and cooling loads on the building. Zoning of systems is dependent on the size, shape and orientation of the building. The HVAC system shall be divided into a minimum of 4 exterior and 1 interior temperature control zones. Return air shall be taken from the area supplied or adjacent to the area in the same temperature control zone. The ventilation and exhaust system shall be sized to maintain a positive pressure throughout the building envelope to limit air and dust infiltration. No HVAC ductwork shall be installed under the floor slab or underground.

  • Heating and Air Conditioning Tenant shall not use any method of heating or air-conditioning, other than that supplied by Landlord, without Landlord’s prior written consent.

  • HEATING The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Electrical Provide drawings for the following systems:

Time is Money Join Law Insider Premium to draft better contracts faster.