Division Of Responsibility For Control Maintenance and Operation Sample Clauses

Division Of Responsibility For Control Maintenance and Operation. All Apparatus and Plant on the Company’s side of the Connection Point shall be controlled and operated by the Company. Maintenance of all Apparatus and Plant on the Company’s side of the Connection Point is the Company’s responsibility at the Company’s cost. All Apparatus and Plant on the User’s side of the Connection Point shall be controlled and operated by the User. Maintenance of all Apparatus and Plant on the User’s side of the Connection Point is the User’s responsibility at the User’s cost.
AutoNDA by SimpleDocs
Division Of Responsibility For Control Maintenance and Operation. (a) The control and ownership boundary is as follows: [Description of the boundary equipment and ownership where detailed description will assist to clarify the SRS and schematic diagram. This may not always be necessary on simple connections] See site layout ref: [XXXX] attached

Related to Division Of Responsibility For Control Maintenance and Operation

  • Cost Responsibility for Network Upgrades 9 5.1 Applicability 9 5.2 Network Upgrades 9

  • Responsibility for Content Vendor is solely responsible for administration, content, intellectual property rights, and all materials at Vendor’s website. DIR reserves the right to require a change of listed content if, in the opinion of DIR, it does not adequately represent the Contract.

  • Maintenance of Services 5.1 Services resold pursuant to this Attachment and BellSouth’s General Subscriber Service Tariff and Private Line Service Tariff and facilities and equipment provided by BellSouth shall be maintained by BellSouth.

  • Consultant’s Responsibility Nothing herein shall be construed as limiting in any way the extent to which Consultant may be held responsible for damages resulting from Consultant’s operations, acts, omissions, or negligence. Insurance coverage obtained in the minimum amounts specified above shall not relieve Consultant of liability in excess of such minimum coverage, nor shall it preclude NCTC from taking other actions available to it under this Agreement or by law, including but not limited to, actions pursuant to Consultant’s indemnity obligations.

  • Areas of Responsibility The lateral and vertical limits of the respective areas of responsibility are as follows:

  • Allocation of Responsibility 6.1 For the purposes of this Schedule 8 responsibility for each minute of delay included in Minutes Delay, each Third Party Train Cancellation, each Diversion, each Failure to Stop and each Planned Service Cancellation shall be allocated according to the responsibility for the incident which caused such Minutes Delay, Third Party Train Cancellation, Diversion, Failure to Stop or Planned Service Cancellation as established in accordance with the following provisions of this paragraph 6.

  • CAISO Responsibility The Parties acknowledge that the CAISO is responsible for the efficient use and reliable operation of the CAISO Controlled Grid consistent with achievement of planning and Operating Reserve criteria no less stringent than those established by the Western Electricity Coordinating Council and the North American Electric Reliability Corporation and further acknowledges that the CAISO may not be able to satisfy fully these responsibilities if the Participating Generator fails to fully comply with all of its obligations under this Agreement.

  • Maintenance Responsibilities 42. Agency shall, at its own expense, maintain operate, and provide power as needed upon Project completion at a minimum level that is consistent with normal depreciation and/or service demand and throughout the useful life of the Project. The useful life of the Project is defined in the Special Provisions. State may conduct periodic inspections during the life of the Project to verify that the Project is properly maintained and continues to serve the purpose for which federal funds were provided. Maintenance and power responsibilities shall survive any termination of the Project Agreement. In the event the Project will include or affect a state highway, this provision does not address maintenance of that state highway.

  • POSITIONS OF SPECIAL RESPONSIBILITY 1. The Board, in consultation and agreement with the Union, will draw up job descriptions for all Positions of Special Responsibility, including, but not limited to, Head Teachers, Department Heads, Helping Teachers and Teachers in Charge. These descriptions shall be recognized as the job descriptions for such positions.

  • Client’s Responsibilities In addition to other responsibilities herein or imposed by law, the Client shall:

Time is Money Join Law Insider Premium to draft better contracts faster.