Discipline On Standards Sample Clauses

Discipline On Standards. In Arbitration Board Case No. 1664 the Impartial Chairperson said that "the mere presence of proof of failure to meet a rate of production requires the Chairperson to approve the propriety of discipline unless, by some means other than a showing of non-compliance with Sections (46)-(48) (now Section (4.1)) it is established that the fault did not lie with the employee." Nevertheless, the undersigned agree that the provisions of Section (44) (c) of the National Production and Maintenance Agreement dated November 2, 1961, give the Arbitration Board power and authority to determine the propriety of the penalty imposed by management in disciplinary discharges and layoffs for violation of Letter (4.2), Work Standards, of said Agreement, and that the mere presence of proof of an employee's failure to meet a disputed work standard does not require the Arbitration Board or the Chairperson to approve the propriety of the discipline assessed to an employee. The disposition of any such case shall be on the merits but shall not involve the propriety of any disputed work standard or work load assignment performed by the grievant or grievants. In any such determination, the Arbitration Board will take into consideration any relevant facts occurring prior and subsequent to the time the penalty in question was imposed. This letter shall not be construed to limit or otherwise impair any right Section (1.2) reserves to the Company, including the right to establish and maintain work standards or rates of production and to discipline employees. (c99) WORK STANDARDS
AutoNDA by SimpleDocs
Discipline On Standards. In Arbitration Board Case No. 1664 the Impartial Chairperson said that "the mere presence of proof of failure to meet a rate of production requires the Chairperson to approve the propriety of discipline unless, by some means other than a showing of non-compliance with Sections (46)-
Discipline On Standards. In Appeal Board Case No. 1664 the Impartial Chairman said that "the mere presence of proof of failure to meet a rate of production requires the Chairman to approve the propriety of discipline unless, by some means other than a showing of non-compliance with Sections (46)-(48) (now Section (44)) it is established that the fault did not lie with the employee." Nevertheless, the undersigned agree that the provisions of Section (44) (c) of the National Production and Maintenance Agreement dated November 2, 1961, give the Appeal Board power and authority to determine the propriety of the penalty imposed by management in disciplinary discharges and layoffs for violation of Section (59), Work Standards, of said Agreement, and that the mere presence of proof of an employee's failure to meet a disputed work standard does not require the Appeal Board or the Chairman to approve the propriety of the discipline assessed to an employee.

Related to Discipline On Standards

  • Reformulation Standards A “reformulated” product (a) contains lead in concentrations that do not exceed 90 parts per million, equivalent to 0.009%, in any exterior parts analyzed pursuant to U.S. Environmental Protection Agency (EPA) methodologies 3050B and 6010B, or (b) yields a result of no more than 1.0 micrograms of lead when sampled according to NIOSH 9100 protocol and analyzed according to EPA 6010B. In addition to the above tests, the Settling Entity may use equivalent methods utilized by any California or federal agency to determine lead content in a solid substance or the amount of the bioavailability of the toxicant through a wipe test, respectively.

  • WORKLOAD STANDARDS One (1) Direct Service Hour (DSH) will be equal to sixty (60) minutes of direct services.

  • Construction Standards The Subrecipient and Developer shall ensure that all Approved Projects comply with the following requirements:

  • PRODUCTION STANDARDS The Company may establish minimum production standards applicable to Representative.

  • Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.

  • OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.

  • ELIGIBILITY STANDARDS ‌ Employee eligibility standards for health care benefits shall be determined solely by the Board of Trustees and as permitted under existing law. The Trust is responsible for notifying newly eligible workers of their opportunity to enroll, enrolling eligible workers, providing open enrollment notifications and follow up to secure required applications/documentation, disenrolling ineligible workers and providing COBRA notifications and follow up. The Employer will provide the Trust with hours worked and other information needed by the Trust to determine eligibility, enroll eligible workers, and disenroll ineligible workers. The Employer will provide information on the Trust’s benefits to all employees during the onboarding process. The Trust shall determine the appropriate level of contribution, if any, by eligible home care workers. Ongoing costs for deduction of home care worker premiums for health care shall be paid by the Employer.

  • STANDARDS OF DISCIPLINE 32.01 Where written departmental standards of discipline are developed or amended, the Employer agrees to supply sufficient information on the standards of discipline to each employee and to the Institute.

  • SUPPLIER STANDARDS OF CONDUCT Accenture is committed to conducting its business free from unlawful, unethical or fraudulent activity. Supplier will act in a manner consistent with the ethical and professional standards of Accenture as described in the Accenture Supplier Standards of Conduct, including prompt reporting of unlawful, fraudulent or unethical conduct. A copy of these standards can be found at xxxxxxxxx.xxx/xx- en/company-ethics-code.

  • Contractor Standards Contractor shall comply with Contractor Standards provisions codified in the SDMC. Contractor understands and agrees that violation of Contractor Standards may be considered a material breach of the Contract and may result in Contract termination, debarment, and other sanctions.

Time is Money Join Law Insider Premium to draft better contracts faster.