Classification Definitions Note: The following classification definitions should be read in conjunction with: • the stream and field definitions in subclause 1.4.3 and 1.4.75 respectively: • the definitions of “or equivalent”, “work within the scope of this level” and “Engineering Associate” at the end of this Schedule; • the National Metal and Engineering Competency Standards Implementation Guide especially Table 2 of that Guide which shows the alignment between old and new titles under the Australian Qualifications Framework. For example Advanced Certificates are now known as National Diplomas and Associate Diplomas as National Advanced Diplomas; • Clause 5.1.3 (f) Points. Trainer/Supervisor/Coordinator - Level 1 A Trainer/Supervisor/Coordinator - Level I is an employee who is responsible for the work of other employees and/or provision of structured on-the-job training. Such an employee has completed a qualification at AQFIII level or above, of which at least one third of the competencies are related to supervision/training, or equivalent. Notwithstanding the above definition an employee who is mainly engaged to perform work supervising or coordinating the work of other employees and who has sufficient additional training beyond that of those coordinated or supervised so as to enable the employee to perform work within the scope of this level shall be classified at this level. Trainer/Supervisor/Coordinator - Level II A Trainer/Supervisor/Coordinator - Level II is an employee who is responsible for the supervision and/or training of Trainers/Supervisors/Coordinators - Level I. Such an employee has completed an AQF IV or V qualification or equivalent of which at least 50% of the competencies are in supervision/training. WAGE GROUP: C14 Engineering/Production Employee - Level I As Engineering/Production Employee - Level I is an employee who is undertaking up to 38 hours induction training which may include information on the enterprise, conditions of employment, introduction to supervisors and fellow workers, training and career path opportunities, plant layout, work and documentation procedures, occupational health and safety, equal employment opportunity and quality control/assurance. An employee at this level performs routine duties essentially of a manual nature and to the level of his/her training:
Termination; Default If Contractor is in default of any of its obligations under this Contract and has not commenced cure within ten days after receipt of a written notice of default from County and cured such default within the time specified in the notice, the County shall immediately be entitled to either commence resolution in accordance with this paragraph or to terminate this Contract by giving written notice to take effect immediately. Default shall include failure to carry out any of the requirements of this Contract, including, but not limited to not providing enough properly skilled workers or proper materials, persistently disregarding laws and or ordinances, not proceeding with the work as agreed to herein, or otherwise substantially violating any provision of this Contract. Upon termination of the Contract with Contractor, the County may begin negotiations with a third-party Contractor to provide goods and/or services as specified in this Contract. The right of either party to terminate this Contract hereunder shall not be affected in any way by its waiver of or failure to take action with respect to any previous default.
EMPLOYEE DEFINED As used in this Section, "employee" means any person holding a regular, provisional, or temporary appointment in the County service, and otherwise subject to the provisions of this Memorandum of Understanding.
Change of Control Defined For purposes of this this Note, the term “
Overtime Defined All time worked before or after the regular work day, the regular work week or on a holiday, as specified herein, shall be considered overtime.
Overtime Definition Overtime shall be defined as being all hours worked in excess of the normal or standard work day, or in excess of the normal or standard work week. The overtime rate shall be one and one-half (1½) times the regular straight time hourly rate of pay. NOTE: Article 16.04 is applicable to full-time employees only.
PRODUCTION DEFINITELY DISCONTINUED If the holder of the approval completely ceases to manufacture a type of vehicle approved in accordance with this Regulation, he shall so inform the authority which granted the approval, which in turn shall forthwith inform the other Contracting Parties to the Agreement applying this Regulation by means of a communication form conforming to the model in Annex 1 to this Regulation.
Employee Definitions For the purpose of this Agreement, the following definitions shall apply:
Interpretation Definitions Unless the context shall otherwise require: words in the singular shall also include the plural, and vice versa; any pronoun shall include the corresponding masculine, feminine and neuter forms; the words “include”, “includes” and “including” shall be deemed to be followed by the phrase “without limitation”; the words “herein”, “hereof” and “hereunder” and words of similar import refer to this Agreement in its entirety and not to any part hereof; all references herein to Sections or clauses shall be deemed references to Sections or clauses of this Agreement; any references to any agreement or other instrument or law, statute or regulation are to it as amended, supplemented or restated, from time to time (and, in the case of any law, to any successor provisions or re-enactment or modification thereof being in force at the time); any reference to “law” shall include any supranational, national, federal, state, local, or foreign statute or law and all rules and regulations promulgated thereunder; any reference to a “day” or a number of “days” (without any explicit reference otherwise, such as to business days) shall be interpreted as a reference to a calendar day or number of calendar days; reference to month or year means according to the Gregorian calendar; reference to a “
Employee Definition The term “employee" when used in this Agreement will refer to all employees in the unit for bargaining as defined in Section 1.
