CORRECTION OF WORK 13.2.1 The Contractor shall be responsible for correcting all Work which the Architect has found to be defective or which fails to conform to the Contract Documents whether observed be- fore or after Substantial Completion and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting such rejected Work, including compensation for the Architect's and the State’s additional services made necessary thereby. The Architect, upon a finding of defect or failure to conform, shall immediately notify the State and Contractor, in writing, of the defect. The Contractor shall begin correcting the defective or non-conforming Work within ten (10) days unless the State agrees to a Change Order which reflects the reduction in Contract Sum due to the value of diminishment of the defective or nonconforming Work.
Statement of Work The Contractor shall provide the services and staff, and otherwise do all things necessary for or incidental to the performance of work, as set forth below:
Software Warranty We warrant that the Tyler Software will perform without Defects during the term of this Agreement. If the Tyler Software does not perform as warranted, we will use all reasonable efforts, consistent with industry standards, to cure the Defect in accordance with the maintenance and support process set forth in Section C(9), below, the SLA and our then current Support Call Process.
Rejection of Work Using the Notice of Non-Conforming Work procedures outlined in the General Conditions, the Design Professional shall reject work that does not comply with the requirements of the Contract Documents or that does not comply with the applicable laws and codes. The Design Professional shall have authority to order testing of the Work, as is provided in the Contract Documents or as otherwise required in its judgment, whether such work is fabricated, installed, or completed.
Hardware Warranty A. RISK OF LOSS If you purchase any of the hardware Products directly from us, risk of loss or damage to hardware, will pass to you and acceptance will occur upon delivery to your “ship to” address or, if special shipping arrangements are agreed to, upon delivery to your carrier or designee. Title to hardware Products will pass from HPE to you upon full payment for or delivery of the Products, whichever is later. You agree to properly insure the Products for the benefit of HPE between the time risk of loss and damage pass and the time title passes.
Service Warranty Provider has carefully examined and analyzed the provisions of this Agreement, including but not limited to all exhibits attached and incorporated into it, and can and will perform, or cause, the Services to be performed in strict accordance with the provisions and requirements of the Agreement. Services will be performed in a timely, professional and workmanlike manner in accordance with all applicable industry and professional standards.
Inspection of Work CONSULTANT and any subconsultant shall permit LOCAL AGENCY, the State, and the FHWA if federal participating funds are used in this AGREEMENT; to review and inspect the project activities and files at all reasonable times during the performance period of this AGREEMENT.