Contractor Procurement Requirements Sample Clauses

Contractor Procurement Requirements. Contractor agrees to adhere to the following procurement procedures when obtaining any and all commodities and contractual services including, but not limited to, office supplies, training supplies, equipment, rental agreements, insurance, construction, maintenance, professional and consultant services, and all other goods and services needed to carry out the terms of this agreement.
AutoNDA by SimpleDocs

Related to Contractor Procurement Requirements

  • Procurement Requirements The below listed provisions of State Procurement requirements shall be complied with throughout the contract period:

  • Specific Order Processes and Requirements 1. Distributor will order Software from SAP using and filling out completely such forms and minimum order requirements as SAP may prescribe from time to time and must comply with any then-current order process for the specific Software product. Where applicable, Distributor agrees to use the electronic means provided by SAP for placing orders.

  • Agreement Requirements This agreement will be issued to cover the Janitorial Service requirements for all State Agencies and shall be accessible to any School District, Political Subdivision, or Volunteer Fire Company.

  • Development Requirements The exterior wall standards set forth in this section shall apply to the structures located on the Property. At least ninety percent (90%) of the combined exterior surface area of all walls, including all stories of buildings / structures, shall consist of stone, brick, painted or tinted stucco, and factory tinted (not painted) split faced concrete masonry unit or similar material approved by the Director of Planning.

  • Equipment Requirements No Equipment is provided to Customer as part of this Service.

  • Service Order Process Requirements 53.5.1 CenturyLink will accept orders for As-Is Transfer of services from CenturyLink to CLEC where CenturyLink is the End User’s current local exchange carrier.

  • U.S. Federal Procurement Requirements Without limiting Section 12.1, in light of DXC’s status as a U.S. Federal contractor and subcontractor, all applicable procurement regulations required by federal statute or regulation to be inserted in contracts or subcontracts apply to this Order, including but not limited to FAR 52.219-8 (Utilization of Small Business Concerns), FAR 52.219.-9 (Small Business Subcontracting Plan), FAR 52.219-16 (Liquidated Damages Subcontracting Plan), FAR 52.222-26 (Equal Opportunity), FAR 52.222-35 (Equal Opportunity for Special Disabled Veterans, Veterans of the Vietnam Era, and other Eligible Veterans), FAR 52.222-36 (Affirmative Action for Workers with Disabilities), FAR 52.222-39 ( Notification of Employee Rights Concerning Payment of Union Dues or Fees), FAR 52.222-41 (Service Contract Act of 1965), and FAR 52.247-64 (Preference for Privately Owned U.S. Flag Commercial Vessels).

  • Compliance with Procurement Laws This Contract is the result of compliance with applicable procurement laws of the State of Texas. DIR issued a solicitation on the Comptroller of Public Accounts’ Electronic State Business Daily, Request for Offer (RFO) DIR-TSO-TMP-225, on February 27, 2015, for Software, including Software as a Service, Products and Related Services. Upon execution of this Contract, a notice of award for RFO DIR-TSO-TMP-225 shall be posted by DIR on the Electronic State Business Daily.

  • Project Requirements Failure to comply with the following requirements will result in a suspension of all other operations:

  • Minimum System Requirements The following summarizes the minimum office system requirements for all Contractors and Architect/Engineer to possess in order to participate. It is the responsibility of all Contractors and Architect/Engineer to possess these minimum requirements at no additional cost to Princeton University.

Time is Money Join Law Insider Premium to draft better contracts faster.