Compressor. 7. Farm Tractor.
Compressor. (capacity) ..................................... ..................................... .................................(Specify) ..................................... .................................... .................................(Specify) ..................................... ....................................
Compressor. All internal functioning parts supplied by the manufacturer;
Compressor. 11.21 Run Capacitor
Compressor. (a) less than 250 cfm (b) 250 cfm or greater 4 Rock Drill c/w compressor, hoses
Compressor. MEASUREMENT VALUE --------------------------------------------------------------------------------------------- Type Axial flow --------------------------------------------------------------------------------------------- Stages 18 --------------------------------------------------------------------------------------------- Rati- 15.3 (ISO) --------------------------------------------------------------------------------------------- Maximum tip speed 1269 fps --------------------------------------------------------------------------------------------- Inlet guide vanes Variable-modulating --------------------------------------------------------------------------------------------- Rotor blade material --------------------------------------------------------------------------------------------- Stages 0 through 8 C-450 --------------------------------------------------------------------------------------------- Stages 9 through 17 AISI-403 --------------------------------------------------------------------------------------------- Stator blade material --------------------------------------------------------------------------------------------- Stages 0 through 8 C-450 --------------------------------------------------------------------------------------------- Stages 9 through 17 AISI-403 --------------------------------------------------------------------------------------------- Rotor material --------------------------------------------------------------------------------------------- Stages 0 through 14 Ni Cr MoV --------------------------------------------------------------------------------------------- Stages 15 through 17 Cr Mo V --------------------------------------------------------------------------------------------- Inlet guide vane material C-450 ---------------------------------------------------------------------------------------------
Compressor. A second compressor shall be installed on the vehicle engine it is specific to the passenger area air conditioning system. The compressor shall be nominal 13 cubic inch displacement. Evaporator: Trans Air model TA-73 or approved equal. Condenser: Trans Air model SMC3L or approved equal. Fast Idle / Interlock: Intermotive or In-Power Advanced Fast Idle / Interlock System. The vehicle shall include a voltage monitor/engine idler. The device shall activate automatically when the vehicle is in a discharge situation, the transmission is in Park and the parking brake is applied. The device shall also include a manual activation switch. The device shall automatically deactivate when the parking brake is released and the vehicle is put in gear.
Compressor. You may choose one of three compressor types: single speed (most common), dual speed and variable speed. If you choose variable speed, you must enter data on the minimum and maximum compressor speeds for heating and cooling modes. DOE-2.1E uses only the ratio of these values. Evaporative Cooler Form The evaporative cooler form is activated by (1) selecting Evaporative Cooler as the system type on the HVAC System Editor and (2) clicking on the cooling coil. The form is used to specify the properties of the evaporative cooler. This form is used for direct and indirect/direct evaporative coolers. A separate form is used for an evaporative precooler, which is an add-on to many types of HVAC systems. Template (list box). This list box contains templates for use in initializing evaporative cooler properties. When you choose a template, all properties are initialized appropriately, including part-load curves. However, you can still edit the properties. Using the Equipment Editor, you can create new evaporative cooler templates and add them to the library.
Compressor. Amperage (T1, T2 & T3), voltage (T1/T2, T1/T3 & T2/T3), and also the amperage and voltage on the nameplate.
Compressor. The compressors shall be high performance rotary type. Crankcase heater shall be factory mounted on the outside of the compressors. The condenser unit shall be equipped with accumulator, internal thermal overload, and high pressure safety switch. The compressors shall be mounted to avoid vibration. The condenser unit shall be able to operate at 0F ambient temperature without additional low ambient controls. The condenser unit shall able to operate with a maximum height difference of 164 feet and have refrigerant tubing length of 164 feet between indoor and condenser unit without the need for line size changes, traps or additional oil.
