CENTRAL AIR CONDITIONER Sample Clauses

CENTRAL AIR CONDITIONER. If a plan covering an electric central air conditioning split system that utilizes R22 or R410A refrigerant and is rated at five tons or less by the manufacturer is purchased, all parts and labor services required for the repair or replacement of the following items will be covered at no addi- tional charge, if they become defective as a result of normal wear and usage: Belts & Pulleys • Capacitor (start & run) • Clean Condensate Line (if accessible) • Cleaning of Condenser (when necessary) • Condenser Fan Blade • Condenser Fan Motor • Contactor • Fan Motor • Fuses (cartridge type) • Hard Start Kit (if part of original design) • Low-Ambient Temperature Control • Pressure Switch (external pressure switches only) • Refrigerant (up to 2 lbs. per season) • Xxxxxxxx Valve Stems • Sensors • Solid State Controls • Thermostat (re- placement type-standard area heating/cooling) • Time Delay Controls • Transformers • Relays PGW will not open sealed refrigerant systems. Systems empty of refrigerant will not be charged. Finish defects, rusting, corrosion and finish flaws on housings or component failure resulting from rust or corrosion of any product are not covered.
AutoNDA by SimpleDocs
CENTRAL AIR CONDITIONER. If a plan covering an electric central air conditioning split system that utilizes R22 or R410A refrigerant and is rated at five tons or less by the manufacturer is purchased, all parts and labor services required for the repair or replacement of the following items will be covered at no additional charge, if they become defective as a result of normal wear and usage: PGW’s Check and Adjust must be purchased in conjunction with a Parts and Labor Plan for your natural gas heating appliance. The Check and Adjust cannot be purchased as a standalone item. A Check and Adjust is only available for your heating equipment and will not be available for any other equipment covered under a Parts and Labor Plan. Each customer that purchases Check and Adjust along with their heating plan is permitted one (1) inspection of their heating appliance from September 1, 2019 through October 31, 2020. Inspections are performed from September 1, 2019 through Belts & Pulleys Capacitor (start & run) Clean Condensate Line (if accessible) Cleaning of Condenser (when necessary) Condenser Fan Blade Condenser Fan Motor Contactor Fan Motor Fuses (cartridge type) Hard Start Kit (if part of original design) Low-Ambient Temperature Control Pressure Switch (external pressure switches only) Refrigerant (up to 2 lbs. per season) Xxxxxxxx Valve Stems Sensors Solid State Controls Thermostat (replacement type-standard area heating/cooling) Time Delay Controls Transformers Relays November 15, 2019 and April 1, 2020 through May 31, 2020, weather and conditions per- mitting. Customers are responsible for scheduling their annual inspection. Service to items on the above list could be limited based on seasonal temperatures and conditions found. If a PGW technician encounters a problem with the heating equipment during the scheduled Check and Adjust, covered repairs will be made as provided in the Parts and Labor Plan terms and conditions; provided that the visit by the PGW technician constitutes the one (1) annual permitted inspection even if repairs are made pursuant to the Parts and Labor Plan. PGW will not open sealed refrigerant systems. Systems empty of refrigerant will not be charged. Finish defects, rusting, corrosion and finish flaws on housings or component failure resulting from rust or corrosion of any product are not covered.
CENTRAL AIR CONDITIONER. Pressure Switches Relief Valve Safety Switches Thermocouple Lead Burner or interior door gasket Resettable Thermal Switch (Bradford AWH) Does not include tank replacement. 2018-2019 If a plan covering an electric central air conditioning split system that utilizes R22 or R410A refrigerant and is rated at five tons or less by the manufacturer is purchased, all parts and labor services required for the repair or replacement of the following items will be covered at no additional charge, if they become defective as a result of normal wear and usage: Belts & Pulleys Capacitor (start & run) Clean Condensate Line (if accessible) Cleaning of Condenser (when necessary) Condenser Fan Blade Condenser Fan Motor Contactor Fan Motor Fuses (cartridge type) Hard Start Kit (if part of original design) Low-Ambient Temperature Control Pressure Switch (external pressure switches only) Refrigerant (up to 2 lbs. per season) Xxxxxxxx Valve Stems Sensors Solid State Controls Thermostat (replacement type-standard area heating/cooling) Time Delay Controls Transformers Relays PGW will not open sealed refrigerant systems. Systems empty of refrigerant will not be charged. Finish defects, rusting, corrosion and finish flaws on housings or component failure resulting from rust or corrosion of any product are not covered.
CENTRAL AIR CONDITIONER. If a Plan covering an electric central air conditioning split system that utilizes R22 or R410A refrigerant and is rated at five tons or less by the manufacturer is purchased, all parts and labor services required for the repair or replacement of the following items will be covered at no additional charge, if they become defective as a result of normal wear and usage: Belts & Pulleys Capacitor (start & run) Clean Condensate Line (if accessible) Cleaning of Condenser (when necessary) Condenser Fan Blade Condenser Fan Motor Contactor Fan Motor Fuses (cartridge type) Hard Start Kit (if part of original design) Low-Ambient Temperature Control Pressure Switch (external pressure switches only) Refrigerant (up to 2 lbs. per season) Xxxxxxxx Valve Stems Sensors Solid State Controls Thermostat (replacement type-standard area heating/cooling) Time Delay Controls Transformers Relays PGW will not open sealed refrigerant systems. Systems that are empty of refrigerant will not be charged. Finish defects, rusting, corrosion and finish flaws on housings or component failure resulting from rust or corrosion of any product are not covered.
CENTRAL AIR CONDITIONER. Protected: Ducted electric central air conditioning, including entire unit. Annual preventative maintenance required on HVAC system to qualify for coverage. Not Protected: Any repair or replacement relating to freon leaks or freon recharging.
CENTRAL AIR CONDITIONER. Window Air Conditioner Attic Fan Ceiling Fan Exhaust Fan Air Cleaning System Plumbing Fences or Gates Central Vacuum Plumbing Fixtures Lawn Sprinkler System Microwave Oven Washer / Dryer Hook-Up Wood Framing or Siding Trash Compactor Water Softener Gas Heater/Propane Tank Disposal Hot Water Heater Garage Door Opener Dishwasher Sauna or Hot Tub Antenna / TV Dish Range Fireplace or Chimney Intercom Oven Fire / Smoke Detector Humidifier Refrigerator Burglar Alarm Pool / Pool Equipment Check if you are aware of any of the following with respect to the property: Additions / Improvements Zoning / Set-Back Violations Encroachments / Easements Flooding / Sump Pumps Existing/Threatened Legal Action Fire Damage at any time Party Walls or Common Areas Code Violations/ Liens/ Assessments Landfill or Subterranean Problems Reappraisal / Reclassification Homes Association Problems with Water Supply If you have checked any of the above, please explain what you know:

Related to CENTRAL AIR CONDITIONER

  • Air Conditioning If the Apartment has been provided with a ledge for split air conditioning system with suitable provision for keeping outdoor units of the AC system and also the route to take refrigerant piping, which the Allottee shall have to strictly follow while installing AC units

  • Quality Management System Supplier hereby undertakes, warrants and confirms, and will ensue same for its subcontractors, to remain certified in accordance with ISO 9001 standard or equivalent. At any time during the term of this Agreement, the Supplier shall, if so instructed by ISR, provide evidence of such certifications. In any event, Supplier must notify ISR, in writing, in the event said certification is suspended and/or canceled and/or not continued.

  • Substance Abuse Testing The Parties agree that it is in the best interest of all concerned to promote a safe working environment. The Union has no objection to pre-employment substance abuse testing when required by the Employer and further, the Union has no objection to voluntary substance abuse testing to qualify for employment on projects when required by a project owner. The cost and scheduling of such testing shall be paid for and arranged by the Employer. The Union agrees to reimburse the Employer for any failed pre-access Alcohol and Drug test costs.

  • Quality control system (i) The Contractor shall establish a quality control mechanism to ensure compliance with the provisions of this Agreement (the “Quality Assurance Plan” or “QAP”).

  • Substance Abuse Program The SFMTA General Manager or designee will manage all aspects of the FTA-mandated Substance Abuse Program. He/she shall have appointing and removal authority over all personnel working for the Substance Abuse Program personnel, and shall be responsible for the supervision of the SAP.

  • Quality Management Grantee will:

  • Health plan specification The Employer will require health plans participating in the Group Insurance Program to develop and implement health promotion and health education programs for State employees and their dependents.

  • Firefighters Any truck with an inoperative aerial ladder shall be regularly and routinely staffed with one (1) officer and five (5) firefighters for the period of time that the aerial ladder is inoperative, or until such time as the truck with the inoperative aerial ladder is replaced with a truck with an operative aerial ladder. At 0800 and 2000 hours, all trucks shall be staffed with one (1) officer and four (4) firefighters, and any truck with an inoperative aerial ladder shall be staffed with one (1) officer and five (5) firefighters.

  • SUBSTANCE ABUSE The dangers and costs that alcohol and other chemical abuses can create in the electrical contracting industry in terms of safety and productivity are significant. The parties to this Agreement resolve to combat chemical abuse in any form and agree that, to be effective, programs to eliminate substance abuse and impairment should contain a strong rehabilitation component. The local parties recognize that the implementation of a drug and alcohol policy and program must be subject to all applicable federal, state, and local laws and regulations. Such policies and programs must also be administered in accordance with accepted scientific principles, and must incorporate procedural safeguards to ensure fairness in application and protection of legitimate interests of privacy and confidentiality. To provide a drug-free workforce for the Electrical Construction Industry, each IBEW local union and NECA chapter shall implement an area-wide Substance Abuse Testing Policy. The policy shall include minimum standards as required by the IBEW and NECA. Should any of the required minimum standards fail to comply with federal, state, and/or local laws and regulations, they shall be modified by the local union and chapter to meet the requirements of those laws and regulations.

  • Quality Control A. Controlled Affiliate agrees to use the Licensed Marks and Name only in connection with the licensed services and further agrees to be bound by the conditions regarding quality control shown in attached Exhibit A as they may be amended by BCBSA from time-to-time.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!