CARGO INSTALLATION Sample Clauses

CARGO INSTALLATION. Transportable products and respective quantities *) Tank No. 20°C 100% X0 -000°X 98.5% X0 -000°X 98.5% MT S.G. 0.47 -163°C 70%L X0 -000°X 70%H X0 -000°X 10%L X0 -000°X 10%H M3 1 19,386 19,095 8,975 12,196 13,195 1,398 1,494 2 41,873 41,245 19,385 41,873 31,203 6,541 3,955 3 41,873 41,245 19,385 41,873 31,203 6,541 3,955 4 41,873 41,245 19,385 41,873 31,203 6,541 3,955 Total 145,004 142,829 67,130 137,814 106.804 21,022 13,359
AutoNDA by SimpleDocs
CARGO INSTALLATION. Transportable products and respective quantities *) Tank Nx. 00 °X 000% X0 -000 °X 98.5 % M3 -163 °C 98.5% MT S.G. 0.47 -163°C 70%L M0 -000°X 70%H M0 -000°X 10%L M0 -000°X 10%H M3 1 19,404 19,113 8,983 12,542 13,212 1,426 1,490 2 41,913 41,284 19,404 41,913 31,247 6,635 3,949 3 41,913 41,284 19,404 41,913 31,244 6,635 3,945 4 41,916 41,287 19,405 41,916 31,246 6,636 3,947 Total 145,146 142,969 67,195 138,284 106,948 201,332 13,329 *) Approx. figures per 1 July 2009 based on a cargo specific gravity of 470 kg/m^3 The cargo tank system is GTT Mxxx III, reinforced to all cargo tank area except tank bottom in accordance with GTT document N500 CR009. SRV Cape Axx – Amendment No. 5 Scantlings of the cargo tanks are based on a maximum density of cargo of 500 kg/m3. Tank working pressure Maximum pressure (LNGC mode) 25 kPa gauge Maximum pressure (FSRU Mode) 40 kPa gauge Minimum pressure -1 kPa gauge Minimum temperature acceptable in tanks -163ºC Acceptable cargo filling levels (LNGC mode) Lower criteria Below 10% of cargo tank height Upper criteria Above 70% of cargo tank height Loading & discharging time for LNG 12 hours, excluding time for connecting, disconnecting, cooling down, topping up and custody transfer measurement Discharging time for regasified LNG Rxxxx rate (mmscuf/hr) 120 250 450 500 600 712.5 750 Rxxxx rate (mt/hr) 101 210 378 420 504 599 630 Rxxxx duration (days) 26.0 12.5 7.0 6.3 5.2 4.4 4.2 1.5 CARGO MACHINERY Cargo pumps 1,700 m^3/h @155 mlc x 8 units Cargo pump location 2 in each cargo tank Max permissible specific gravity 500 kg/m Time for discharging full cargo using all cargo pumps against no backpressure 12 hours, excluding time for connecting, disconnecting, cooling down, topping up and custody transfer measurement Unpumpable cargo volume 1,450 m^3 Heel LNG for cooling down 500 m^3 Fuel LNG for ballast voyage 3,300 m^3 Cargo remaining onboard in cargo tanks after completion pumping 5,250 m^3 Spray pumps 50m^3/h @145 mlc x 4 units Fuel Gas Pumps 40m3/h@215mlc x 2 units Located in tank No. 3 and 4 10m3/h@155mlc x 1 unit Emergency cargo pump/ LNG Feed Pump 650m^3/h @145 mlc x 3 units Located in tank No. 2, 3 and 4 SRV Cape Axx – Amendment No. 5 High duty cargo compressor 32,000 m^3/h x 2 units Low duty cargo compressor 4,350 m^3/h x 2 units Nitrogen plant 120 Nm^3 x 2 units Inert gas plant 14,000 Nm^3/h x 1 unit Composition of inert gas Carbon dioxide, CO2 Max 14% by volume Oxygen max., O2 1.0% by volume Carbon monoxide max. ; CO 100 ppm HC ...

Related to CARGO INSTALLATION

  • Utility Installations Trade Fixtures Alterations 8.3.1 The term “Utility Installations” refers to all floor and window coverings, air and/or vacuum lines, power panels, electrical distribution, security and fire protection systems, communication cabling, lighting fixtures, HVAC equipment, plumbing, and fencing in or on the Premises. The term “

  • Maintenance Repairs Utility Installations Trade Fixtures and Alterations 7.1 Lessee's Obligations.

  • Installation Tenant may install and use Tenant's Lines and make connections and disconnections at the terminal blocks as described above, provided Tenant shall: (i) obtain Landlord's prior written approval of all aspects thereof, (ii) use an experienced and qualified contractor designated or approved in writing in advance by Landlord (whom Landlord may require to enter an access and indemnity agreement on Landlord's then standard form of agreement therefor), (iii) comply with such inside wire standards as Landlord may adopt from time to time, and all other provisions of this Lease, including Paragraph 8 respecting alterations, and the Building rules respecting access to the wire closets, (iv) not install Lines in the same sleeve, chaseway or other enclosure in close proximity with electrical wire, and not install PVC-coated Lines under any circumstances, (v) thoroughly test any riser Lines to which Tenant intends to connect any Lines to ensure that such riser Lines are available and are not then connected to or used for telephone, data transmission or any other purpose by any other party (whether or not Landlord has previously approved such connections), and not connect to any such unavailable or connected riser Lines, and (vi) not connect any equipment to the Lines which may create an electromagnetic field exceeding the normal insulation ratings of ordinary twisted pair riser cable or cause radiation higher than normal background radiation, unless the Lines therefor (including riser Lines) are appropriately insulated to prevent such excessive electromagnetic fields or radiation (and such insulation shall not be provided by the use of additional unused twisted pair Lines). As a condition to permitting installation of new Lines, Landlord may require that Tenant remove any existing Lines located in or serving the Premises.

  • DELIVERY AND INSTALLATION Lessee shall be responsible for payment of all transportation, packing, installation, testing and other charges associated with the delivery, installation or use of any Equipment which are not included in the Agreement with respect to such Equipment.

  • Rooftop Equipment Provided that Tenant complies with the terms of ----------------- this Section, Tenant may, at its risk and expense, install a satellite dish and related communications equipment and wiring (collectively, the "Rooftop ------- Equipment") on the roof of the Building at a location approved by Landlord, --------- which equipment may be used solely by Tenant and its Permitted Transferees or Permitted Sublessees. Before installing the Rooftop Equipment, Tenant shall submit to Landlord for its approval (which approval shall be in Landlord's sole discretion) plans and specifications which (a) specify in detail the design, location, size, and, in the case of a satellite dish, frequency of the Rooftop Equipment and (b) are sufficiently detailed to allow for the installation of the Rooftop Equipment in a good and workmanlike manner and in accordance with all Laws (the "Legal Requirements"). If Landlord approves of such plans, Tenant ------------------ shall install (in a good and workmanlike manner), maintain and use the Rooftop Equipment in accordance with all Legal Requirements and shall obtain all consents and permits required for the installation and operation thereof; copies of all such permits and evidence of such consents must be submitted to Landlord before Tenant begins to install the Rooftop Equipment. Tenant shall thereafter maintain all permits necessary for the maintenance and operation of the Rooftop Equipment while it is on the Building and operate and maintain the Rooftop Equipment in such a manner so as not to unreasonably interfere with any other satellite, antennae, or other transmission facility on the Building's roof or in the Building. Landlord may require that Tenant screen the Rooftop Equipment with a parapet or other screening device acceptable to Landlord. Tenant shall maintain the Rooftop Equipment and screening device in good repair and condition. Tenant shall, at its risk and expense, remove the Rooftop Equipment (including all wiring related thereto), within five days after the occurrence of any of the following events: (1) the termination of Tenant's right to possess the Premises; (2) the termination of the Lease; (3) the expiration of the Term; or (4)

  • Lending Installations Each Lender may book its Loans at any Lending Installation selected by such Lender and may change its Lending Installation from time to time. All terms of this Agreement shall apply to any such Lending Installation and the Loans and any Notes issued hereunder shall be deemed held by each Lender for the benefit of any such Lending Installation. Each Lender may, by written notice to the Agent and the Borrower in accordance with Article XIII, designate replacement or additional Lending Installations through which Loans will be made by it and for whose account Loan payments are to be made.

  • Communications Equipment Members of the board of directors or any committee thereof may participate in and act at any meeting of such board or committee through the use of a conference telephone or other communications equipment by means of which all persons participating in the meeting can hear each other, and participation in the meeting pursuant to this section shall constitute presence in person at the meeting.

  • Roof Any Tenant-installed equipment must be removed with all roof penetrations properly repaired by a licensed roofing contractor approved by Landlord. Leaks arising from any Tenant-installed equipment or roof penetrations must be fixed in accordance with Landlord’s maintenance and repair recommendations.

  • Tenant’s Equipment Tenant shall provide notice to Landlord prior to moving any heavy machinery, heavy equipment, freight, bulky matter or fixtures (collectively, “Equipment”) into or out of the Building and shall pay to Landlord any costs actually incurred by Landlord in connection therewith. If such Equipment requires special handling, Tenant agrees (a) to employ only persons holding all necessary licenses to perform such work, (b) all work performed in connection therewith shall comply with all applicable Requirements and (c) such work shall be done only during hours designated by Landlord.

  • Maintenance Repairs and Alterations 6.01 Tenant's Obligations to Repair ------------------------------ Tenant shall at its sole cost and expense, maintain in clean and safe condition, and make all repairs and replacements to the Premises and every part thereof, structural and non-structural, so as to keep, maintain and preserve the Premises in first class condition and repair, including, without limitation, the roof, the foundation, the heating, ventilation and air conditioning system ("HVAC"), elevators, if any, all plumbing and sewage facilities, fire sprinklers, electrical and lighting facilities, systems, appliances, and equipment within the Premises, fixtures, interior and exterior walls, floors, ceilings, windows, doors, entrances, all interior and exterior glass (including plate glass), and skylights located within the Premises, and all sidewalks, service areas, parking areas and landscaping comprising part of the Premises. All repairs and replacements required to be made by Tenant shall be made promptly with new materials of like kind and quality to those used in the original construction of the Premises. If the repair or replacement work affects the structural parts of the Premises, or if the estimated cost of any item or repair or replacement exceeds $10,000, then Tenant shall first obtain Landlord's written approval of the scope of work, plans therefor, and materials to be used. Any such work shall be performed by Landlord's contractor or by such contractor as Tenant may choose from an approved list to be submitted by Landlord. Landlord shall have the right to make any repairs or replacements which are not promptly made by Tenant and charge Tenant, as Additional Rent, for the cost thereof together with interest thereon at the Agreed Rate from the date of payment thereof by Landlord. Without limiting any of Tenant's obligations hereunder, during the Lease Term Tenant, at its expense, shall obtain and keep in force an HVAC service contract and a roof maintenance program satisfactory to Landlord. Tenant hereby waives the benefit of any statute now or hereafter in effect which would otherwise afford Tenant the right to make repairs at Landlord's expense or to terminate this Lease because of Landlord's failure to keep the Premises in good condition, order and repair. Tenant specifically waives all rights it may have under Sections 1932(1), 1941 and 1942 of the California Civil Code, and any similar or successor statute or law. Notwithstanding anything to the contrary contained herein, Landlord shall exercise its rights under any guaranties or warranties relating to the original construction of the Premises if the need to make repairs arises due to a defect therein; provided, however, Landlord shall not have any liability or be required to expend any funds if such guaranties or warranties are not honored by the makers hereof.

Time is Money Join Law Insider Premium to draft better contracts faster.