Cabling and Wiring Sample Clauses

POPULAR SAMPLE Copied 3 times
Cabling and Wiring. The Contractor shall provide and install all additional and replacement wire and/or cable necessary for the operation of the proposed system. The Contractor shall provide and install all wire and/or cable required at new facilities and may make a one-time/per facility charge against the commissions paid to the DOC/DJJ based upon actual cost of installation subject to DOC/DJJ approval. All wire and/or cable installed becomes the property of the DOC/DJJ.
Cabling and Wiring. The right to, place, lay and maintain over, under, along or upon the Council's Property in such locations and along such routes as may be agreed between the Council and the Provider (both Parties acting reasonably) such cables (to include fibre optic cables), wires, ducting, conducting media, and supports as are necessary for the proper functioning and operation of the Equipment together with the right to enter upon the Council's Property with workmen and all necessary machinery for the purpose of exercising this right, the Provider making good any damage thereby occasioned to the Council's Property to the reasonable satisfaction of the Council.
Cabling and Wiring. The design and installation of all cabling and wiring to be provided under this section shall be in accordance with the NEC.
Cabling and Wiring a. The Contractor provides all control system cabling as required by the Works. b. The Contractor provides all control system wiring as required by the Works. c. The DCS OEM, ABB, or any other ABB accredited contractor is utilised to perform any control system related cabling work as required by the Works. This is to ensure that all existing warrantees and guarantees are maintained and that all work is carried out according to the OEM best practices. d. All cabling and wiring adheres to standard 240-56227443 Requirements for Control and Power Cables for
Cabling and Wiring. Tenant shall have the right for up to 15 days immediately prior to the Commencement Date to install cabling and wiring in the Premises at the same time that Landlord performs ▇▇▇▇▇▇▇▇’s Pre-Commencement Work. Landlord and Tenant shall use reasonable efforts to cooperate with each other so as to permit the other to work in the Premises at the same time. If the performance by Tenant of such work in the Premises interferes with the performance by Landlord of Landlord's Pre-Commencement Work, Landlord shall, notwithstanding the foregoing, have the right to notify Tenant of such interference (which notification may be oral) and Tenant shall immediately discontinue such interference. If the Substantial Completion of Landlord's Pre-Commencement Work is solely delayed by reason of interference with the performance of Landlord's Pre-Commencement Work caused by ▇▇▇▇▇▇ performing such work in the Premises at the same time as Landlord or any other act or omission of Tenant, its agents, employees or contractors during such period of early access, such interference shall constitute a Tenant Delay. Such access to the Premises by Tenant prior to the Commencement Date shall not be deemed to be use and occupancy by Tenant of the Premises nor Tenant having taken possession of the Premises for purposes of determining the Commencement Date but shall otherwise be subject to all of the terms of the Lease.

Related to Cabling and Wiring

  • Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.▇▇▇ ▇▇▇▇▇ ▇▇▇▇▇▇▇. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The ▇▇▇▇▇ heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where ▇▇▇▇▇ heights are lower for aesthetic, land treatment, or silvicultural rea- sons.

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • Moonlighting Employee will focus his/her professional time, ability, and attention on City business during the term of this Agreement. To the extent consistent with applicable law, Employee shall not engage in any other business duties or pursuits whatsoever or, directly or indirectly, render any services of a business, commercial, or professional nature to any other person or organization, whether for compensation or otherwise, without the prior consent of the City Manager, except that: (1) The expenditure of reasonable amounts of time not in conflict with the City's needs and interests, for educational, charitable, community, and professional activities, shall not be deemed a breach of this Agreement and shall not require prior consent. (2) This Agreement shall not be interpreted to prohibit Employee from making passive personal investments or conducting private business affairs if those activities do not materially interfere with the services required under this Agreement or create conflicts of interest.

  • CUTTING AND PATCHING The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.

  • Packing and Marking By supplier