Bodywork. 6.1. Type of bodywork:
Bodywork. 3.1. Seats
Bodywork. 4.1. Type of bodywork: Single deck/double-deck/articulated/low floor1 4.2. Materials used and methods of construction:.....................................................
Bodywork. 11.1. Means of rear visibility or detection Devices for indirect vision: Direct vision, Devices approved to UN Regulation No. 46, Close Proximity Rear-view Mirror complying with this Regulation, Rear-View Camera System complying with this Regulation, Detection System complying with this Regulation3.
Bodywork. 4.1. Type of bodywork: single deck / double-deck / articulated / low floor 1/
Bodywork. 5.1. Wheel guards
Bodywork. 3.1. A brief description of the vehicle with regard to the heating system if the heating system uses the heat of the engine cooling fluid ..............................................................................
Bodywork. 12.1. Devices for indirect vision
Bodywork. − Front material and rear pump location cabinet frames; will be manufactured from galvanized steel profiles with appropriate cross-section according to the location and the load. − Surfaces other than the aluminum shutter covers at the rear and on both sides will be covered with minimum 1.5 mm thick galvanized sheet metal. − The floors of the cabinet sections compartments will be covered with at least 2 mm thick aluminum plates. Roofing will be covered with minimum 3/4 aluminum with embossed pattern. Water tightness will be provided. − Rear cabinet; it will have rear and two side shutters. Pump location will be equipped with emergency response reel and the delivery hoses will be stored in this section. − The front cabinet will be used for the protection of the additional equipment to be given with it. There will be at least 2 sliding drawers in this section. In this section, there will be a respiratory device carrying apparatus that can carry at least 2 respirators and can reach the level that the personnel can wear these directly on their back. − The covers of the cabinets will be shutters made of aluminum anodized material, in appropriate width, opening upwards with water and dust proofing and handles. The shutters will be lockable type. − In order to climb onto the bodywork, there will be at least 1 aluminum folding ladder mounted on the right or left side of the rear wall of the pump location cabinet. The bodywork that comes under the aluminum ladder will be covered with a suitable insulation material to prevent deformation by the feet of the personnel climbing the ladder. Stair steps will be placed in a way that they do not coincide with the stop lights. − The interior of the tool cabinets will be illuminated with sufficient number of lighting lamps and controlled from inside the vehicle cabin. The lamps to be used will be led type.
Bodywork. 6.1. Seats:...................................................................................................................
