Basic Design and Installation Requirements for Using Municipal Facilities Sample Clauses

Basic Design and Installation Requirements for Using Municipal Facilities. All of Licensee’s construction and installation work for its Small Cell Equipment on the Municipal Facilities shall be performed at Licensee’s sole cost and expense and in a good and workmanlike manner and promptly completed. When Licensee and Licensor have agreed on an existing Municipal Facility location as a suitable site for Licensee’s Small Cell Equipment, but the existing Municipal Facility needs to be replaced to accommodate the Small Cell Equipment, then the Site Supplement shall so specify and Licensee shall pay all costs related to replacing the Municipal Facility, including but not limited to installation of the replacement pole (the “Replacement Pole”), transfer of the streetlight fixtures, and/or other items attached to the existing Municipal Facility to the Replacement Pole, and removal and salvage of the existing Municipal Facility to the Licensor. Payment of the pole replacement costs does not provide Licensee with any ownership interest in the Replacement Pole. Licensor will be deemed to own the original Municipal Facility and the Replacement Pole. The installation or attachment of the Small Cell Equipment using the Replacement Pole shall be at Licensee’s sole cost and expense.
Sample 1Sample 2Sample 3See All (5)
AutoNDA by SimpleDocs
Basic Design and Installation Requirements for Using Municipal Facilities. The basic design of the Equipment will be described in Exhibit A-1 to each Supplemental Site License. All of Licensee’s construction and installation work for its Equipment shall be performed at Licensee’s sole cost and expense and in a good and workmanlike manner and promptly completed. When Licensee and Licensor have agreed on an existing Municipal Facility location as a suitable site for Licensee’s Equipment, but the existing Licensor-owned pole site needs reconfiguration work, including but not limited to replacement of a pole to accommodate the Equipment and existing fixtures, then Licensee shall pay all costs related to such work, including but not limited to installation of the replacement pole and its foundation, transfer of any fixtures, traffic signals, luminaires, banners, and/or other items attached to the existing Licensor- owned pole, and removal and salvage of the existing Licensor-owned pole to the Licensor. Payment by Licensee for any work under this section does not provide Licensee with any ownership interest in the resultant Municipal Facility or any replacement pole. Specifically, Licensor will be deemed to own the original Licensor-owned Municipal Facility and the replacement pole that includes a Municipal Facility. The installation or attachment of the Equipment using the replacement pole shall be at Licensee’s sole cost and expense.
Sample 1
Basic Design and Installation Requirements for Using Municipal Facilities. The basic design of the Equipment will be described in Exhibit A-1 to each Supplemental Site Licenses. All of Licensee’s construction and installation work for its Equipment shall be performed at Licensee’s sole cost and expense and in a good and workmanlike manner and promptly completed. When Licensee and Licensor have agreed on an existing Municipal Facility location as a suitable site for Licensee’s Equipment, but the existing Licensor-Owned pole needs to be replaced to accommodate the Equipment, then Licensee shall pay all costs related to replacing the Licensor-Owned pole, including but not limited to installation of the replacement pole (the “Replacement Pole”), transfer of the fixtures, traffic signal, and/or other items attached to the existing Licensor-Owned pole to the Replacement Pole, and removal and salvage of the existing Licensor-Owned pole to the Licensor. Likewise, when Licensee and Licensor have agreed on an existing Facility location as a suitable site for Licensee’s Equipment, but the existing pole needs to be replaced to accommodate the Equipment, then Licensee shall pay all costs related to removal and replacing the pole, including but not limited to installation of the Replacement Pole, transfer of the fixtures, and/or other items attached to the existing pole to the Replacement Pole, and removal and salvage of the existing pole to the Licensor. Payment of the pole replacement costs does not provide Licensee with any ownership interest in the Replacement Pole. Licensor will be deemed to own the original Licensor-Owned pole and the Replacement Pole. The installation or attachment of the Equipment using the Replacement Pole shall be at Licensee’s sole cost and expense.
Sample 1

Related to Basic Design and Installation Requirements for Using Municipal Facilities

  • Installation requirements 7.8 We (if we install the System) or our contractor (if we procure a contractor to install the System) must:

  • Technical and Interconnection Requirements 2.1 Consumer agrees that his Rooftop Solar PV System and Net Metering System will conform to the standards and requirements specified in the Policy, Regulations and Supply Code as amended from time to time.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.

  • Construction Requirements a) All Life and Safety and applicable Building Codes will be strictly enforced (i.e., tempered glass, fire dampers, exit signs, smoke detectors, alarms, etc.). Prior coordination with the Building Manager is required.

  • Licenses for Permanent Installation The contractor must comply with all State mandatory licensing requirements prior to installation. Questions on licensing requirements should be directed to the State Licensing Board. Contractor must furnish and install all furniture and materials in compliance with all applicable codes, whether local, state, or federal; and that all permits or licenses required for installation will be obtained without cost to the State.

  • Responsibility for Quality of Materials and Installation Contractor acknowledges that he has full, total, and complete responsibility for providing materials, labor, and all other items necessary for providing the level of quality specified in the Contract Documents. He agrees that this responsibility is indivisible, non-delegable, non- transferable, and not diminished by any inspections provided by the Design Professional or his consulting engineers, nor by any inspections provided by the Owner. In recognition of this, Contractor will prepare for submission and review by the Design Professional, a written program describing the efforts that will be taken to insure the proper quality level is achieved. The program shall be submitted prior to the issuance of a Proceed Order.

  • Early Construction of Base Case Facilities Developer may request Connecting Transmission Owner to construct, and Connecting Transmission Owner shall construct, subject to a binding cost allocation agreement reached in accordance with Attachment S to the ISO OATT, including Section 25.8.7 thereof, using Reasonable Efforts to accommodate Developer’s In-Service Date, all or any portion of any System Upgrade Facilities or System Deliverability Upgrades required for Developer to be interconnected to the New York State Transmission System which are included in the Base Case of the Class Year Study for the Developer, and which also are required to be constructed for another Developer, but where such construction is not scheduled to be completed in time to achieve Developer’s In-Service Date.

  • Certain Requirements as to Furniture, Equipment and Fixtures If the Assuming Institution purchases owned Bank Premises or accepts an assignment of the lease (or enters into a sublease or a new lease in lieu thereof) for leased Bank Premises as provided in Section 4.6(a) or 4.6(b), or if the Assuming Institution does not exercise such option but within twelve (12) months following Bank Closing obtains the right to occupy such premises (whether by assignment, lease, sublease, purchase or otherwise), other than in accordance with Section 4.6(a) or (b), the Assuming Institution shall (i) effective as of the date of Bank Closing, purchase from the Receiver all Furniture and Equipment and Fixtures owned by the Failed Bank at Fair Market Value and located thereon as of Bank Closing, (ii) accept an assignment or a sublease of the leases or negotiate new leases for all Furniture and Equipment and Fixtures leased by the Failed Bank and located thereon, and (iii) if applicable, accept an assignment or a sublease of any ground lease or negotiate a new ground lease with respect to any land on which such Bank Premises are located; provided, that the Receiver shall not have disposed of such Furniture and Equipment and Fixtures or repudiated the leases specified in clause (ii) or (iii).

  • CERTIFICATION OF NONSEGREGATED FACILITIES (Applicable to construction contracts exceeding $10,000) The Contractor certifies that it does not maintain or provide for its establishments, and that it does not permit employees to perform their services at any location, under its control, where segregated facilities are maintained. It certifies further that it will not maintain or provide for employees any segregated facilities at any of its establishments, and it will not permit employees to perform their services at any location under its control where segregated facilities are maintained. The Contractor agrees that a breach of this certification is a violation of the equal opportunity clause of this contract. As used in this certification, the term “segregated facilities” means any waiting rooms, work areas, rest rooms and wash rooms, restaurants and other eating areas, time clocks, locker rooms, and other storage or dressing areas, parking lots, drinking fountains, recreation or entertainment areas, transportation and housing facilities provided for employees which are segregated by explicit directive or are, in fact, segregated on the basis of race, color, religion, or national origin because of habit, local custom, or any other reason. The Contractor further agrees that (except where it has obtained for specific time periods) it will obtain identical certification from proposed subcontractors prior to the award of subcontracts exceeding $10,000 which are not exempt from the provisions of the equal opportunity clause; that it will retain such certifications in its files; and that it will forward the preceding notice to such proposed subcontractors (except where proposed subcontractors have submitted identical certifications for specific time periods).

  • Routine Maintenance, Construction, and Repair The NYISO or Connecting Transmission Owner may interrupt interconnection service or curtail the output of the Small Generating Facility and temporarily disconnect the Small Generating Facility from the New York State Transmission System or Distribution System when necessary for routine maintenance, construction, and repairs on the New York State Transmission System or Distribution System. The NYISO or the Connecting Transmission Owner shall provide the Interconnection Customer with five Business Days notice prior to such interruption. The NYISO and Connecting Transmission Owner shall use Reasonable Efforts to coordinate such reduction or temporary disconnection with the Interconnection Customer.

Time is Money Join Law Insider Premium to draft better contracts faster.