Back Filling Sample Clauses

Back Filling. The Contractor shall back-fill completed structures in accordance with the following requirements. No back-filling shall be placed against structures until permission shall have been given, by the superintending Engineer or 14 days after the concrete has been placed. The trenches or other excavations shall be filled up with the excavated earth carefully rammed, in regular layers of not more than 230mm (9") in thickness and compacted and consolidated by the addition of necessary water to each layer.
Sample 1Sample 2Sample 3See All (10)
AutoNDA by SimpleDocs
Back Filling. In all excavations where the excavated material is required to be returned to the excavation as backfill, suitable material shall be set aside during excavation and shall be kept free from contamination with top soil, vegetable matter or other unsuitable material, failing which the Contractor shall at his own expense import suitable material from elsewhere. Back filling shall not be placed in waterlogged excavations. Backfill material which is in the opinion of the Engineer too wet shall be used until it has dried out sufficiently. Excessively dry backfill material shall be watered during backfill. The Contractor's rates shall allow for any additional costs these measures any may entail. No back filling shall be carried out without the permission of the Engineer that will normally only be given when the Work has been inspected, tested and approved. After such permission has been given back filling shall be carried out as soon as possible. The utmost care shall be taken to ensure that no damage occurs to the Works and compaction methods employed shall be approved by the Engineer and shall ensure that excessive loads are not placed on pipes or structures upon or around which the backfill is being placed. Unless specified otherwise all back filling shall be carried out in layers not exceeding 200 mm, such layers being brought up evenly around and above the work and well consolidated before the next layer is placed. Where compaction is carried out by hand, rammers of not less than 4 kg in weight shall be used and the ratio of men employed in ramming and filling shall be two to one.
Sample 1Sample 2Sample 3See All (4)
Back Filling. Permanent Full Time Employees who are successful in a bid to a Limited Job Posting or return by his/her own request to his/her former classification per Article 19:06 shall not create a vacancy for Job Posting purposes. Such vacancy created may be filled from the Part Time Employees per selection by the Employer within the classification giving consideration to qualifications and seniority per the provisions in Article 16:05 of this Agreement. If a back fill vacancy provides a change in shift or job classification for the Permanent Full Time Employee, he/she may request in writing to the Scheduling Coordinator at the time of such a vacancy to be considered in accordance with his/her Seniority. All Employees back-filling shall be required to remain in the Limited Position until it expires.
Sample 1Sample 2
Back Filling. If an assessment period is offered to an employee in these circumstances, the position held by the employee at the time of receiving the offer shall be back-filled on a temporary term basis.
Sample 1Sample 2

Related to Back Filling

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Dark Fiber Transport Dark Fiber Transport is defined as Dedicated Transport that consists of unactivated optical interoffice transmission facilities without attached signal regeneration, multiplexing, aggregation or other electronics. Except as set forth in Section 6.9.1 below, BellSouth shall not be required to provide access to Dark Fiber Transport Entrance Facilities pursuant to this Agreement.

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • GARBAGE DISPOSAL, RECYCLING, AND BIODEGRADABLE MATERIALS A. Concessionaire shall be responsible for maintaining the cleanliness of the Concession Premises. Concessionaire shall ensure placement of all garbage and trash generated by the Concession Operation in designated containers and that said containers are emptied daily, or as more frequently required by Department, at a location within the Area designated by Department. Disposal costs from this latter location shall be borne by Department. Concessionaire shall provide such additional trash containers as may be required to keep the immediate Concession Premises clean at all times. The type of trash containers provided by Concessionaire shall be approved by Department prior to use.

  • Recyclable Materials “Recyclable Materials” means Solid Waste consisting of any material 371 which retains useful properties and can be reclaimed after the production or consumption process.

  • Cutting, Patching, and Fitting The Contractor shall do all cutting, patching, and fitting of the Work that may be required to make its several parts come together properly and fit.

  • NEW MATERIALS The Work to be delivered hereunder shall consist of new materials, not used, or reconditioned, remanufactured, or of such age as to impair its usefulness or safety.

  • Removal of Equipment and Materials Within 30 days after completion of the requirements of this contract, PURCHASER shall remove from the areas of operations, and other property owned or controlled by STATE, all equipment, materials, and other property PURCHASER has placed or caused to be placed thereon that is not to become the property of STATE. It is agreed that any such equipment, materials, and other property that are not removed within 30 days, shall become the property of STATE and may be used or otherwise disposed of by STATE without notice or obligation to PURCHASER or to any party to whom PURCHASER may transfer title. Nothing in this section shall be construed as relieving PURCHASER from an obligation to clean up and to burn, remove, or dispose of debris, waste materials, and such, in accordance with the provisions of this contract. PURCHASER shall indemnify STATE for expenses as a result of cleanup, removal or disposal of debris, waste materials, and such.

  • Training Materials Training Materials will be provided for each student. Training Materials may be used only for either (i) the individual student’s reference during Boeing provided training and for review thereafter or (ii) Customer’s provision of training to individuals directly employed by the Customer.

Time is Money Join Law Insider Premium to draft better contracts faster.