Application methods Sample Clauses

Application methods. This chemical will primarily be applied via spot foliar application using a hand-held wand (backpack or ATV mounted) or ATV-towed weed wiper. Limited application may occur utilizing ATV or tractor-mounted boom sprayers on limited areas dominated by invasive plants.
Sample 1Sample 2Sample 3See All (12)
AutoNDA by SimpleDocs
Application methods. This chemical will be hand painted or directly wicked onto fresh cut stumps, within 24 hours of cutting. For broadleaf weed control, it will be applied primarily via spot foliar application using a hand-held wand or mounted on an all-terrain vehicle. No spraying will occur.
Sample 1Sample 2Sample 3
Application methods. This chemical will be hand painted or directly wicked onto fresh cut stumps, within 24 hours of cutting. No spraying will occur.
Sample 1
Application methods. The method of application must be agreed by all Parties. The diagram below shows where the pesticide types may be used.
Sample 1
Application methods. ‌ 12 As summarized in Table 2-2, the FS anticipates using various methods to apply the indaziflam 13 formulations Esplanade 200 SC and Esplanade F, including ground and aerial broadcast.
Sample 1
Application methods. 1.Dilute chemical cleaner based on testing and manufacturer’s published recommendations.
Sample 1
Application methods. ‌ 11 The most common methods for application of the flumioxazin products described in Table 2.1-2 are 12 spray (backpack directed foliar spray, boom ground spray, and/or aerial aircraft spray), surface and 13 subsurface applications to water bodies, and ground application of granules. Each of these is likely to 14 be used by the FS and discussed in detail below.
Sample 1
AutoNDA by SimpleDocs

Related to Application methods

  • Construction Methods No four course of brick-work, with three joints, shall exceed in height, when built, one inch more than the same bricks piles upon one another without mortar. The bricks are to be well soaked in water before use on works, in proper through so as to be thoroughly wet when layed. The Cessation of the bubbles through the water is an irldication of saturation being complete. For ensuring thorough soaking of the bricks every one or two bricklayers or more as necessary, shall be provided with tubs for use The wall of structures shall be carried up regularly in all cases 1` when the nature of the work will admit of it not leaving any part 915mm (3 feet) lower than another. Horizontal courses shalI be straight, level and even and faces of walls smooth and plumb. A straight edge and a plumb- xxx shall be used for constant checking during progress of the work. No brick-bats shall be permitted to be used except when necessary for obtaining the dimension of the different course or for obtaining the specified bond. All unfinished work must be raked back in course unless otherwise directed arid when new work is to be jointed to it the surface of unfinished work must be cleaned and wetted. The bricks shall be laid by placing sufficient mortar on the wall and forcing every brick into it in such a manner as to completely fill every joint with moratar whether at the bottom, side or end of the brick. The mortar to be used shall be that specified for the relevant schedule items and shall comply with the specification for the mortar specified. The bound used shall be English and shall be carried throughout the work. At all angles forming the junction of any two walls, the bricks shall, at each alternate course be carried into each of the respective walls, so as to thoroughly unite the work. V'Jhen the faces are to be plastered, the joints shall be well raked out before any plaster is laid on should the plaster from want of proper joint ranking detach and 7 fall off from the brick work, the contractor shall strip off the plaster bodily to the extent ordered by Superintending Engineer and shall re-do the work properly at his own expense. All requisite scaffolding shall be provided at the contractor's expense and shall be double i.e., must it have two sets of upright supports Care must be taken to ensure the safety of the work people and the contractor must comply with such instructions as the Superintending Engineer may issue to ensure such safety. The contractor will be entirely responsible for any damage or injuries to person or property resulting from ill-erected scaffolding, defective ladders, or otherwise arising out of his default in this respect. The brick work for the retaining wall shall proceed side by side with the depositing and compacting of earth between the retaining walls. At no time shall the brick-work be constructed more than 405mm (1'-4") above Y the compacted earth. In the retaining wall weep-holes shall be provided at suitable intervals as instructed during execution, with the inner surface of the weep-holed plastered 20mm (3/4") thick in cement mortar 1:4 crouched rock of grades in different layer shall be provided at the inner end of the weep-holes to prevent the choking of the weep-holes to have full drainage. No extra payment will be made for this and no deductions will be made for this in the brick-work.

  • APPLICATION/SCOPE 1.1 This collective agreement shall be applicable to every person who requires a teacher certificate as a condition of employment with the School Division excepting those positions agreed to be excluded in local bargaining between the School Division and the Association. Effective March 4, 2020, clause 1.1 above is repealed and replaced by the following clause:

  • Agreed Guidelines Applications With respect to the application of the Sentencing Guidelines to this case, the parties stipulate and agree as follows:

  • Application Form By electronically signing or submitting the Application Form you:

  • Calculation methodology No adjustment in the Conversion Price need be made unless the adjustment would require an increase or decrease of at least 1% in the Conversion Price then in effect, provided that any adjustment that would otherwise be required to be made shall be carried forward and taken into account in any subsequent adjustment. Except as stated in this Article VI, the Conversion Rate will not be adjusted for the issuance of Common Stock or any securities convertible into or exchangeable for Common Stock or carrying the right to purchase any of the foregoing. Any adjustments that are made shall be carried forward and taken into account in any subsequent adjustment. All calculations under Article V and Section 6.06 hereof and this Section 6.07 shall be made to the nearest cent or to the nearest 1/10,000th of a share, as the case may be.

  • Application Procedures a) An employee applies for a listing on the system-wide registry through the employee’s Human Resources Department by completing the form in Appendix B.

  • Application Procedure 7.4.1. Application Priority........................................ 7.4.2. [Reserved].................................................. 7.4.3. Advance Payments............................................

  • Application Process The employees wishing to enter into a job share arrangement will apply in writing to the Employer and forward a copy to the Union outlining the proposed commencement date of the job share, how the hours and days of work will be shared and how communication and continuity of work will be maintained. The Employer shall communicate a decision on a job share request in writing to the applicants. Applications to Job Sharing shall not be unreasonably denied.

  • Application and Selection (1) Application for professional development leave shall contain an appropriate outline of the project or work to be accomplished during the leave.

  • Application for Promotion Employees who have successfully completed their initial probationary period may make application for any Job Posting provided they meet the minimum, stated qualifications for the involved position; provided, however, that employees who have failed a promotional probationary period in a classification shall not be permitted to take an examination for promotion to that classification within twelve (12) months of the date of such failure.

Time is Money Join Law Insider Premium to draft better contracts faster.