Annual Services. Unless otherwise indicated in this Exhibit B, fees for annual services are due annually, in advance, commencing on the availability of the service. Your annual fees for the initial term are set forth in the Investment Summary. Upon expiration of the initial term, your annual fees will be at our then-current rates.
Annual Services. The training, maintenance, monitoring, measurement and verification review and other services specified in the Project Documents for which the ESCO is responsible during the Guarantee Period.
Annual Services. (once per year)
Annual Services. 1. Recondition all resilient or composition flooring to provide a level of appearance equivalent to a completely refinished floor.
Annual Services. 1. Clean light fixtures, lens and lamps.
Annual Services. Clean condenser coils with fresh water 1 time per year. (Overtime not included) Additional cleaning will be billed to customer on a T&M basis. Clean and wipe control panels. Complete operating log and record settings. All Scheduled Maintenance activities. Adjust operating and safety controls as necessary. Record. Log operation of temperatures, pressures, voltages and amperages. Inspect operation of control circuit. Visual inspection of unit. Inspect operation of all motors. Inspect operation of crankcase heater(s). Written Report (Daily Timesheet) Provided to customer representative following each regular inspections or emergency call. Unitary Unit Scope This schedule describes the basic Scheduled maintenance procedures that will be performed by HUNTON SERVICES. These procedures comply with all EPA regulations regarding maintenance and repair of air conditioning/heating & refrigeration equipment and systems.
Annual Services. Clean condenser coils with fresh water 1 time per year. (Overtime not included) Provide material and labor to replace belts 1 time(s) per year. (Overtime not included) Tighten electrical connections as necessary Complete operating log and record settings. Lubricate fan and motor bearings as necessary. Inspect bearing and motor mounting. Inspect drive sheaves. Tighten set screw(s) as required. Complete operating log and record settings. Inspect coil conditions. Inspect unit for unusual noise or vibration. Recommend action as necessary. Inspect and adjust belt tension as necessary Written Report (Daily Timesheet) Provided to customer representative following each regular inspection or emergency call. Exhibit B Exhibit B
Annual Services. Provide material and labor to replace belts one time per year. (Overtime not included) Inspect bearing and motor mounting. Log motor operating voltage and amperage. Provide labor and materials to replace carbon filters on units EF#1, EF#2, and EF#3 one time per year. (Overtime not included) Tighten electrical connections as necessary. Inspect and adjust belt tension as necessary. Inspect condensate drain pan and drain line. Inspect drive sheaves. Tighten set screw(s) as required. Rotate the fan wheel and check for obstructions in the fan housing. Inspect unit for unusual noise or vibrations. Recommend action as necessary. Written Report (Daily Timesheet) Provided to customer representative following each regular inspections or emergency call. Condensing Unit Scope This schedule describes the basic Scheduled maintenance procedures that will be performed by HUNTON SERVICES. These procedures comply with all EPA regulations regarding maintenance and repair of air conditioning/heating & refrigeration equipment and system.
Annual Services. Provides: (1) Up to forty-five ($45) dollars towards Hand-Held Computer Engine Diagnostic exam; (2) Up to twenty-five ($25) dollars towards Alignment Check, and; (3) Up to fifty-five ($55) dollars towards State Safety Inspection where required by state (limited to one-time per year per service).
Annual Services a. Dust high partitions, ledges and molding.
