Annual Maintenance Service Sample Clauses

Annual Maintenance Service. Altitude valve maintenance (1) - The maintenance services shall be conducted every year and shall include: cleaning valve stems of sediment and deposits, checking rubber parts for pliability, and conducting any necessary pilot control adjustments. A log of maintenance procedures shall be kept and include contractor name, date, results of maintenance event, and any future maintenance and/or operations recommendations. Copies shall be provided to Contract Administrator. Altitude valve rebuild (1) – A Cla-Val manufacturing technician will be retained to inspect, fully open, and clean and replace gaskets and/or damaged fittings on the main valve and pilots. The valve settings will then be set and the valve tested for proper operation. Fire hydrant (1) - The fire hydrant (1) shall be tested to a fully open setting for three minutes and then to a closed position to ensure ease and efficiency of operation. This test shall keep the valve in operation; however, the most important reason is to ensure that no line valves upstream have been shut off in the previous period. This fire hydrant open- close test should be accomplished after any other line valves around the Site are tested. The Contractor shall comply with any other City and OCFA requirements for O&M of fire hydrants. A maintenance log shall be kept, which includes contractor name, date, and any maintenance procedures used. Copies shall be provided to Contract Administrator. 100,000-gallon reservoir tank (2) – Inspect seams and epoxy sealant on inside and outside of the tank. A video or photo log and written record of visual inspection information, including contractor name, date, inspection results, and recommendations, shall be prepared.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
Annual Maintenance Service. Automated Dosing Systems (3) - Prior to the rainy season, Contractor shall inspect piping for corrosion and buildup, perform alarm and alert tests and inspect solar panel frames and bracing. Task C. Non-Routine Maintenance Non-routine maintenance is defined as maintenance/repair work that is not included or scheduled in Task A and Task B. Should the need arise or at Contract Administrator’s request, Contractor shall respond to any non-routine maintenance/repairs within three (3) calendar days or sooner from date when problem was first noticed or request date. Contractor shall not receive additional compensation for preparation or revision of task orders. Non-routine maintenance shall include, but not limited to, the following:
Sample 1Sample 2
Annual Maintenance Service. Automated Dosing Systems (3) - Prior to the rainy season, Contractor shall inspect piping for corrosion and buildup, perform alarm and alert tests and inspect solar panel frames and bracing.
Sample 1

Related to Annual Maintenance Service

  • MAINTENANCE SERVICE 1. Free maintenance services including spares shall be provided by the vendor during the period of warranty. User, at its discretion may ask the vendor to provide maintenance services after warranty period, i.e. Annual maintenance and repairs of the system at the rates indicated by bidder in its proposal and on being asked so, the vendor shall provide the same. The cost of annual maintenance and repairs cost (after warranty period), which will include cost of spares replaced, shall be paid in equal quarterly installments at the end of each quarter.

  • Routine Maintenance Services PM1.03.2-1 Respond immediately to restrict all access to Highway Crossing Infrastructure, as directed by the Province.

  • Maintenance Services Subject to Client’s timely payment of the applicable maintenance fees, Accenture will make available the following maintenance services (“Maintenance Services”):

  • Support and Maintenance Services Information about Teradici’s support and maintenance for the Licensed Product may be found at xxxxx://xxxx.xxxxxxxx.xxx.

  • Salary Maintenance (a) Entitlement to salary maintenance An Affected Employee who is successfully redeployed will be entitled to salary maintenance where the Affected Employee’s pay is reduced because the new role:

  • System Maintenance The Trust understands that USBFS will perform periodic maintenance to the System(s), which may cause temporary service interruptions. To the extent possible, USBFS shall notify the Trust of all planned outages and will perform any necessary maintenance during non-business hours.

  • Planned Maintenance (a) Sellers may designate up to twenty (20) Days of Planned Maintenance on Sellers’ Facilities during each Contract Year. Sellers shall be entitled to reduce (including down to zero (0)) its Gas scheduling under Clause 8 and Exhibit 3 for each Day of Planned Maintenance.

  • Software Maintenance Subrecipient shall apply security patches and upgrades in a timely manner and keep virus software up-to-date on all systems on which State data may be stored or accessed.

  • Janitorial Services or Building Maintenance Services If this Agreement is for janitorial or building maintenance services, this section is applicable. If this Agreement requires Contractor to perform Services at a new site, Contractor shall retain for sixty (60) days all employees currently employed at that site by any previous contractor that performed the same services at the site. Contractor shall provide upon request information sufficient to identify employees providing janitorial or building maintenance services at each site and to make the necessary notifications required under Labor Code section 1060 et seq.

  • Software Maintenance and Support If You purchase Software Maintenance and Support for the Software, the Software Maintenance and Support will be provided as described in Kofax’s then current Software Maintenance and Support Agreement, available at xxxx://xxx.xxxxx.xxx/legal/SMSA, and which is incorporated herein by this reference. If You are active and current on Software Maintenance and Support, You may request reconfigurations of the Software subject to Your payment of Kofax’s then current standard rates for such reconfigurations. Kofax will have no liability to You arising from or related to Your cessation of Software Maintenance and Support, whether from Your failure to timely renew Software Maintenance and Support or otherwise. If You elect to reinstate Software Maintenance and Support following expiration of the Software Maintenance and Support for whatever reason, You will (a) pay a reinstatement fee equal to the sum of the current annual Software Maintenance and Support fees, any unpaid Software Maintenance and Support fees from the date of expiration to the date of reinstatement, and an amount equal to one additional year of Software Maintenance and Support fees, and (b) apply all upgrades, enhancements and new releases to the Software needed to bring Your Software current with Kofax’s most current supported version of the Software. Software Maintenance and Support pricing will increase for renewal terms by an amount not to exceed 5% of the prior year term fee, provided that increases associated with additional software license purchases, if any, will be incorporated into the base for the purpose of calculation of each annual increase.

Time is Money Join Law Insider Premium to draft better contracts faster.