Airport Security and Safety Sample Clauses

Airport Security and Safety. All personnel of the Consultants or Contractor will have to undergo a Security and Safety Awareness Programme before the start of the contract. The Principle Agent/Contractor shall ensure that airport security is at all times complied with by his own personnel, all subcontractors and their personnel as well as all suppliers. Access to the security area for personnel, vehicles and construction plant can only be obtained with permission from the Employer. Permits may be required for personnel and vehicles frequently moving through the security check points and shall at all times be visibly displayed while a person or vehicle is within the security area. Identity Documents must be available and presented on request. Permits are only valid for a specific area inside the security area and the responsibility rests with the Contractor to control the movement of personnel, plant and vehicles to ensure their compliance with this requirement. A Prime Cost Sum has been provided for the cost of any permits required. The Contractor will be required to provide permits for each and every material delivery vehicle entering the site, and they are to be escorted by a permit and radio license holder. The Employer may withdraw any or all permits without prior notice in the case of misuse, in which case the Contractor will have no claim against the Employer. The Contractor shall make specific arrangements with the Employer, through the Principle Agent, to ensure the expedient delivery of time-dependent materials such as asphalt. If required, the Contractor shall supply additional security personnel, approved by the Airport Manager to assist with security control. If, due to the extra volume of construction traffic that has to pass through security, additional entrance facilities have to be provided, it shall be done in consultation with the Airport Manager and Principle Agent. These facilities and personnel have to be provided by the Contractor.
Sample 1Sample 2
AutoNDA by SimpleDocs
Airport Security and Safety. The County and the Union recognize the considerable importance of airport security and safety policies and procedures, and in the interest thereof, hereby agree as follows:
Sample 1Sample 2
Airport Security and Safety. All personnel of the Contractor will have to undergo a Security and Safety Awareness Program before the start of the contract. The Contractor shall ensure that airport security is at all times complied with by his own personnel, all subcontractors and their personnel as well as all suppliers. Access to the security area for personnel, vehicles and construction plant can only be obtained with permission from the Employer. Permits may be required for personnel and vehicles frequently moving through the security check points and shall at all times be visibly displayed while a person or vehicle is within the security area. Identity Documents must be available and presented on request. Permits are only valid for a specific area inside the security area and the responsibility rests with the Contractor to control the movement of personnel, plant and vehicles to ensure their compliance with this requirement. A Prime Cost Sum has been provided for the cost of any permits required. The Contractor will be required to provide permits for each and every material delivery vehicle entering the site, and they are to be escorted by a permit and radio license holder. The Employer may withdraw any or all permits without prior notice in the case of misuse, in which case the Contractor will have no claim against the Employer. The Contractor shall make specific arrangements with the Employer, through the Service Manager, to ensure the expedient delivery of time-dependent materials.
Sample 1

Related to Airport Security and Safety

  • Security and Safety A. The Contractor warrants it is and shall remain in compliance with all applicable local, state and federal laws, regulations, codes and ordinances relating to fire, construction, building, health, food service and safety, including but not limited to the Hotel and Motel Fire Safety Act of 1990, Public Law 101-391. The Judicial Council may terminate this Agreement, pursuant to the termination for cause provision set forth herein, without penalty or prejudice if the Contractor fails to comply with the foregoing requirements.

  • Health, Safety and Security 22.2.1 The University and the Association agree to promote safe, secure and healthy working conditions and procedures, and to encourage Members to adopt and follow sound health, safety and security procedures in the performance of their work.

  • Aviation safety (1) Each Contracting Party may request consultations at any time concerning the safety standards maintained by the other Contracting Party in areas relating to aeronautical facilities, flight crew, aircraft and the operation of aircraft. Such consultations shall take place within thirty (30) days of that request.

  • System Security and Data Safeguards When SAP is given access to Licensee’s systems and data, SAP shall comply with Licensee’s reasonable administrative, technical, and physical safeguards to protect such data and guard against unauthorized access. In connection with such access, Licensee shall be responsible for providing Consultants with user authorizations and passwords to access its systems and revoking such authorizations and terminating such access, as Licensee deems appropriate from time to time. Licensee shall not grant SAP access to Licensee systems or personal information (of Licensee or any third party) unless such access is essential for the performance of Services under the Agreement. The parties agree that no breach of this provision shall be deemed to have occurred in the event of SAP non-conformance with the aforementioned safeguard but where no personal information has been compromised.

  • HEALTH, SAFETY AND ENVIRONMENT 41.1 In the performance of this Contract, Contractor and Operator shall conduct Petroleum Operations with due regard to health, safety and the protection of the environment (“HSE”) and the conservation of natural resources, and shall in particular:

  • AND SAFETY The Company and Union will work jointly to improve health and safety for all employees. Production and safety share an equal priority, and established safety standards will not be compromised to improve productivity or reduce costs. The Dome Mine will reduce accident frequencies from year to year and become an industry leader in Health and Safety. The Company the Union as a valuable resource in attaining these objectives. Every employee has the responsibility to ensure he/she works safely, maintains a safe work environment and participates in all health and safety programs to the fullest possible extent. All employees must report unsafe conditions to their supervisors without delay. In the event of “right to refuse unsafe work” legislation being modified or revoked, the Company, for the life of this Agreement will employees right to refuse to perform work involving unsafe conditions or danger to persons or property. It is agreed that a Joint Health and Safety Committee will be maintained consisting of equal numbers of Company and Bargaining Unit Representatives from the Underground, Plant, Pit, Mill and Human Resources departments, together with a Company Safety and a Worker Health and Safety Representative. The committee will meet at least quarterly and not more frequently than monthly. The mandate of the committee will be to recommend standards/targets and monitor health and safety performance. The committee will also monitor rehabilitation and modified work, and make recommendations concerning these programs. The company member for each department will ensure that an annual health and safety action plan is in place, and will be accountable to the committee for its implementation and success. Each Union committee member shall jointly inspect their department on a monthly basis and jointly investigate critical injuries, fatalities and any other incident he/she feels significant, having full access to all pertinent information. The committee will make recommendations to management concerning new initiatives, and changes in policies, practices, procedures, or equipment. It is agreed to maintain the position of Worker Health and Safety Representative. This employee, paid according to Schedule I of this Agreement, is selected by, and accountable to, the Joint Health and Safety Committee. The Committee co-chairs are responsible for maintaining an updated job description for the Worker Health and Safety Representative. His/her duties will include: workplace inspections and follow up in all departments participation in accident incident complaint investigation intervention to stop work in potentially hazardous situations safety auditing education, training and promotion of health and safety any special assignments The Worker Health and Safety Representative will not undertake any assignments unrelated to Health and Safety, unless otherwise directed by the Joint Health and Safety Committee. Before getting involved in any case the Worker Health and Safety Representative will ensure that all employees have used the correct lines of communication, followed all necessary procedures and attempted to resolve problems to the full extent of their responsibility. When necessary the Worker Health and Safety Representative will maintain the confidentiality of information received from workers or the Company. Although the Worker Health and Safety Representative will be supervised on a day-to-day basis by the Company Safety he/she will be given long term objectives by the Joint Health and Safety Committee. The Worker Health and Safety Representative will present a written report of all activities and work undertaken at meetings of the Joint Health and Safety Committee. The Worker Health and Safety Representative will hold as long as he/she has the confidence of both the Union and Company members of the Joint Health and Safety Committee. Upon termination of the appointment, the Worker Health and Safety Representative will return to his/her former job classification with no loss of seniority.

  • Security and Data Privacy Each party will comply with applicable data privacy laws governing the protection of personal data in relation to their respective obligations under this Agreement. Where Siemens acts as Customer’s processor of personal data provided by Customer, the Data Privacy Terms available at xxxxx://xxx.xxxxxxx.xxx/dpt/sw, including the technical and organizational measures described therein, apply to the use of the relevant Learning Services and are incorporated herein by reference.

  • Pupil Safety and Fingerprinting CONTRACTOR shall comply with all provisions of the Education Code which protect the safety of any pupil that may come in contact with employees of the CONTRACTOR. Pursuant to Education Code section 45125.1, CONTRACTOR shall conduct criminal background checks of ALL employees of CONTRACTOR assigned to the PROJECT site, and shall certify that no employees who have been convicted of serious or violent felonies, as specified in Education Code Section 45125.1, will have contact with pupils, by utilizing the General Certification Regarding Background Checks Form. As part of such certification, CONTRACTOR must provide the District with a list of all employees providing services pursuant to this Agreement, and designate which sites such employees will be assigned. In performing the services set forth in this Agreement, CONTRACTOR shall not utilize any employees who are not included on the above-referenced list. At District’s sole discretion, District may make a finding, as authorized under Education Code section 45125.1, that CONTRACTOR’s employees will have only “limited contact” with pupils. In accordance with Education Code Section 45125.2, a CONTRACTOR performing construction, reconstruction, rehabilitation or repair services to a school facility shall not be required to perform Section 45125.1 background checks of all employees assigned to the PROJECT site if such CONTRACTOR installs a physical barrier at the worksite to limit employee contact with pupils and/or provides continual supervision and monitoring of all employees of the CONTRACTOR by an employee of the CONTRACTOR whom the Department of Justice has ascertained has not been convicted of a violent or serious felony. Such CONTRACTOR shall certify to the District its compliance with one of the aforementioned alternatives under Education Code Section 45125.2 pertaining to pupil safety with the form entitled CONSTRUCTION CONTRACTOR CERTIFICATION REGARDING BACKGROUND CHECKS which is on file at the Administrative Office of the DISTRICT. Contractor’s failure to comply with the law or Article VI, Paragraph 4 of this Agreement shall be considered a material breach of this Agreement upon where this Agreement may be terminated, at District’s sole discretion, without any further compensation to Contractor.

  • Seismic Safety The Recipient agrees to comply with the Earthquake Hazards Reduction Act of 1977, as amended, 42 U.S.C. § 7701, et seq., and U.S. DOT regulations, “Seismic Safety,” 49 CFR Part 41, specifically, 49 C.F.R. § 41.

  • Safety and Security Contractor is responsible for maintaining safety in the performance of this Contract. Contractor shall be responsible for complying with the District’s rules and regulations pertaining to safety, security, and driving on school grounds, particularly when children are present.

Time is Money Join Law Insider Premium to draft better contracts faster.