Air Compressor. Air compressor shall be a Wabco brand, minimum of 18.7 cubic feet per minute capacity. Air brake system shall be the quick build up type. The air compressor discharge line shall be stainless steel braid reinforced Teflon hose.
Air Compressor. Air Compressor: • Expand air compressor & air dryer capacity, one new 1,000 cfm air compressor with one receiver and one regenerative dryer sized for the application • Air compressor/dryer system will not exceed 80 db noise limits outside compressor shed. • Dryer will provide -40 F dew point air with system operating at full air flow, • One compressor shed
Air Compressor. The air compressor system will demonstrate the ability to generate the designed flow rate of 1,000 cfm compressed air, and a maximum dew point of-40F while generating less than 80 db of noise outside the compressor shed.
Air Compressor. Asphalt Spreader; Combination - Small Equipment Operator; Generators; Heaters, Mechanical; Hoists, Inside Elevators - (Rheostat Manual Controlled); Hydraulic Power Units (Pile Driving, Extracting, or Drilling - with a seat); Lowboys; Pumps, Over 3" (1 to 3 not to exceed total of 300 ft.); Pumps, Well Points; Welding Machines (2 through 5); Winches, 4 Small Electric Drill Winches; Bobcat (up to and including 3/4 cu. yd.).
Air Compressor. Quantity (1) Manufacturer Castair Performance 4.6 cfm @ 100 psi Controls/Electrical Processor (PLC) Xxxxx‐Xxxxxxx CompactLogix, data logging onto flash card and ethernet communication. Operator Interface (HMI) Xxxxx‐Xxxxxxx Panel View 1000 Color Touchscreen. Enclosures Xxxxxxx Concept, Painted Steel, NEMA 4/12 Conduit Liquid‐Tight Flexible Metal Conduit or PVC Rigid Conduit Location Main Control Panel mounted on RO Skid & wired to RO Instruments and Valves. Piping Materials RO Skid Inlet Schedule 80 PVC RO Skid High Pressure Schedule 10 304 Stainless Steel RO Skid Permeate Schedule 80 PVC RO Skid Concentrate Schedule 80 PVC Interconnecting Piping Interconnecting plumbing between RO skid and feed, CIP and flush tanks shall be provided by others. Chemical Feed Pumps Pump Quantity 3 (antiscalant, acid and sodium bisulfite) Manufacturer Pulsafeeder Type Peristaltic Other In‐line static mixer on RO feed, calibration columns and check valves on chemical lines. Chemical Feed Tanks Tank Quantity (3) located on RO skid Manufacturer Norwesco Vessel Construction HDPE Capacity 10 gallons, flat bottom Dimensions 13” dia. x 20” hgt. Chemical Feed Mixer Quantity (3) located on RO skid Manufacturer Penguin Type Drum mixer CIP Tank Tank Quantity (1) shipped loose Manufacturer Norwesco Vessel Construction HDPE Capacity 105 gallons, flat bottom Dimensions 23” dia. x 63” hgt. CIP Pump Pump Quantity (1) located on RO skid Manufacturer Grundfos CMG3‐5 Type Multistage centrifugal Pump Construction Stainless steel Motor HP 2 HP Performance 20 gpm @ 58 psi CIP Tank Heater
Air Compressor. 54. Miscellaneous refrigeration parts and accessories, filters, piping, batteries and parts.
Air Compressor. A. Without waiver of the provisions of the first paragraph of this Section 6.2.5, Tenant shall have the right, at its sole expense, and subject to Tenant obtaining all requisite permits and otherwise in compliance with all applicable codes and laws, to install, maintain, repair, replace and operate an air compressor (the air compressor is referred to as the “Air Compressor”), such Air Compressor to be located in a mutually acceptable location of the loading dock area of the Building or the Premises (the “Air Compressor Area”), provided Tenant shall promptly repair any damage caused to the Building or to the Property caused by reason of such installation and operation. Tenant shall not install the Air Compressor in the Air Compressor Area without Landlord’s prior approval of the manner of and the plans and specifications for such installation and screening if reasonably required by Landlord. If such installation shall result in an increase in premiums for Landlord’s insurance coverage for the Building, then Tenant shall be liable for the increase as Additional Rent hereunder.
Air Compressor. Two (2) 50 percent capacity air compressors are provided. The compressors are rotary screw type, complete with intake filter, intercoolers, aftercoolers, air receiver, motor drive, and accessories. The air receiver is free-standing. Air Receiver Material: Carbon Steel
Air Compressor. Tenant shall have use of the air compressor with related equipment and Tenant shall accept such air compressor in "as is" condition. Landlord shall have no obligation to make repairs to the air compressor and equipment either at delivery of the Premises or during the Lease Term. All maintenance and repair of the air compressor and equipment shall be Tenant's responsibility and such air compressor and equipment shall be returned to Landlord at the end of Lease Term in as good condition as at the beginning of the Lease Term, ordinary wear and tear excepted.
Air Compressor. Enclose air compressor in northwest corner of bay A. Run distribution lines as necessary.
