Liability Limitations This paragraph limits the liabilities arising under this Agreement or any SOW and is a bargained-for and material part of our business relationship with you. You acknowledge and agree that Verticomm would not enter into any SOW or this Agreement unless Verticomm could rely on the limitations described in this paragraph. In no event shall either party be liable for any indirect, special, exemplary, consequential, or punitive damages, such as lost revenue, loss of profits (except for fees due and owing to Verticomm), savings, or other indirect or contingent event-based economic loss arising out of or in connection with this Agreement, any SOW, or the Services, or for any loss or interruption of data, technology or services, or for any breach hereof or for any damages caused by any delay in furnishing Services under this Agreement or any SOW, even if a party has been advised of the possibility of such damages; however, reasonable attorneys’ fees awarded to a prevailing party (as described below), your indemnification obligations, and any amounts due and payable pursuant to the non-solicitation provision of this Agreement shall not be limited by the foregoing limitation. Except for the foregoing exceptions, a responsible party’s (“Responsible Party’s”) aggregate liability to the other party (“Aggrieved Party”) for damages from any and all claims or causes whatsoever, and regardless of the form of any such action(s), that arise from or relate to this Agreement (collectively, “Claims”), whether in contract, tort, indemnification, or negligence, shall be limited solely to the amount of the Aggrieved Party’s actual and direct damages, not to exceed the amount of fees paid by you (excluding hard costs for licenses, hardware, etc.) to Verticomm for the specific Service upon which the applicable claim(s) is/are based during the three (3) month period immediately prior to the date on which the cause of action accrued. The foregoing limitations shall not apply to the extent that the Claims are caused by a Responsible Party’s willful or intentional misconduct, or gross negligence. Similarly, a Responsible Party’s liability obligation shall be reduced to the extent that a Claim is caused by, or the result of, the Aggrieved Party’s willful or intentional misconduct, or gross negligence.
Regulatory Limitations Notwithstanding any other provision of this Agreement, neither Buyer, Buyer Bank, Seller, nor Seller Bank shall be obligated to make, and Executive shall have no right to receive, any payment under this Agreement which would violate any law, regulation, or regulatory order applicable to Buyer, Buyer Bank, Seller, or Seller Bank, as applicable, at the time such payment is due, including, without limitation, Section 1828(k)(1) of Title 12 of the United States Code and any regulation or order thereunder of the Federal Deposit Insurance Corporation.
Specific Limitations No Member shall have the right or power to: (a) withdraw or reduce such Member’s Capital Contribution except as a result of the dissolution of the Company or as otherwise provided by law or in this Agreement; (b) make voluntary Capital Contributions or to contribute any property to the Company other than cash; (c) bring an action for partition against the Company or any Company assets; (d) cause the termination and dissolution of the Company, except as set forth in this Agreement; or (e) upon the Distribution of its Capital Contribution require that property other than cash be distributed in return for its Capital Contribution. Each Member hereby irrevocably waives any such rights.
Warranty Limitations This Contractual Warranty does not warrant uninterrupted or error-free operation of the Product or cover normal wear and tear of the Product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. The warranty claims that relate to defects caused by any of the following factors are not covered by the Contractual Warranty: • Improper Use or Non-compliance with installation, commissioning, operation or maintenance instructions (i.e. not according to the operation & installation manual) • Unauthorized modifications, changes or attempted repairs, • Vandalism, destruction through external influence and/or persons/animals • Use in an unsuitable environment, including any environment or location that causes excessive wear and tear or dirt or dust or debris buildup within the system or that is difficult or unsafe for Xantrex LLC representatives to access • Insufficient ventilation • Installation in a corrosive environment • Failure to observe applicable safety standards & regulations • Damages during transportation or storage • Force majeure, examples include, but not limited to: fire, flood, earthquakes, storm damage, overvoltage & lightning strikes • Exposure to fire, water, snow, moisture, or liquid ingress (except for any such exposure to environmental conditions that your Product was specifically designed to withstand as indicated in the applicable specifications for your Product) • Used as a component part of a product expressly warranted by another manufacturer • If the original identification (trade-mark, serial number) markings have been defaced, altered, or removed • Consumable components of any type are not covered, including but not limited to fans, fuses and filters etc. • Cosmetic shortcoming which do not impair the use of the product for the intended purpose i.e. supply of energy Warranty claims also exclude: • Damages arising due to the fact that the use of the product for the intended purpose is no longer possible or only possible with restrictions as a result of amendments to the statutory provisions applicable to the operation of the product made after the delivery of the product • Compensation for damages related to loss of power production or business operation or any expenses incurred by customer towards repair & replacement of the product (including but not limited to labor, transportation, temporary power) • Cost arising from changes to existing PV systems or building installations or vehicle or marine vessel installation and like • Additional costs and expenses (i.e. shipping costs, travel, accommodation, meals, etc.) arising due to remote locations of the indicated geographies, including but not limited to islands and overseas territories
Monetary Limitations Neither any Seller nor any Principal will have any obligation to indemnify Buyer Indemnified Persons pursuant to Section 7.01(a)(ii), Section 7.01(b)(ii), or Section 7.01(b)(v) in respect of Losses arising from the breach of, or inaccuracy in, any representation, warranty or statement described therein (or arising in respect of any Specified Liability) unless and until the aggregate amount of all such Losses incurred or suffered by the Buyer Indemnified Persons exceeds $500,000 (at which point the Sellers and the Principals will indemnify the Buyer Indemnified Persons for all such Losses in excess of such amount in accordance with the other provisions of this ARTICLE VII). The Sellers’ and the Principals’ aggregate liability in respect of claims for indemnification pursuant to Section 7.01(a)(ii), Section 7.01(b)(ii), or Section 7.01(b)(v) will not exceed $10 million. The limitations in the immediately preceding two sentences will not apply to (a) claims for indemnification pursuant to Section 7.01(a)(ii) or Section 7.01(b)(ii) in respect of breaches of, or inaccuracies in, any Seller Fundamental Representation or (b) claims for indemnification based upon fraud, intentional misrepresentation or intentional breach of any representation or warranty in ARTICLE III or ARTICLE IV. Subject to the immediately following sentence, claims for indemnification pursuant to any provision of Section 7.01(a) or Section 7.01(b) (other than Section 7.01(a)(ii), Section 7.01(b)(ii), and Section 7.01(b)(v)) are not subject to the monetary limitations set forth in this Section 7.01(c). Notwithstanding anything to the contrary in this Agreement, (x) in no event shall the aggregate liability of the Principals and the Sellers under this ARTICLE VII and Section 8.01 exceed the Overall Indemnity Cap and (y) in no event shall the aggregate liability of any Principal under Section 7.01 and Section 8.01 (when combined, without duplication with his Pro Rata Percentage of the Sellers’ liability under such provisions) exceed such Principal’s Pro-Rata Percentage of the Overall Indemnity Cap. Notwithstanding anything to the contrary in this Agreement, no amounts distributed to Buyer out of the Escrow Cash Amount in accordance with the Escrow Agreement shall be applied against the $10 million limit described in the second sentence of this Section 7.01(c).
License Limitations You may not distribute, redistribute, sell, resell, transfer, rent, lease, or sublicense the Progress Telerik JustMock Product Package or any portions thereof.
Regulatory Limitation In the event, as a result of increases in the value of Alternative Currencies against the Dollar or for any other reason, the obligation of any of the Lenders to make Loans (taking into account the Dollar Amount of the Obligations and all other indebtedness required to be aggregated under 12 U.S.C.A. §84, as amended, the regulations promulgated thereunder and any other Applicable Law) is determined by such Lender to exceed its then applicable legal lending limit under 12 U.S.C.A. §84, as amended, and the regulations promulgated thereunder, or any other Applicable Law, the amount of additional Extensions of Credit such Lender shall be obligated to make or issue or participate in hereunder shall immediately be reduced to the maximum amount which such Lender may legally advance (as determined by such Lender), the obligation of each of the remaining Lenders hereunder shall be proportionately reduced, based on their applicable Commitment Percentages to the relevant Credit Facility and, to the extent necessary under such laws and regulations (as determined by each of the Lenders, with respect to the applicability of such laws and regulations to itself), and the Company shall reduce, or cause to be reduced, complying to the extent practicable with the remaining provisions hereof, the Obligations outstanding hereunder by an amount sufficient to comply with such maximum amounts.
Amount Limitations Notwithstanding any other term of this Agreement or any other Loan Document, no Lender shall be required to make a Loan, the Issuing Bank shall not be required to issue a Letter of Credit and no reduction of the Revolving Commitments pursuant to Section 2.13 shall take effect, if immediately after the making of such Loan, the issuance of such Letter of Credit or such reduction in the Revolving Commitments:
Par Value Limitations Before taking any action that would cause an adjustment reducing the Purchase Price below one one-hundredth of the then par value, if any, of the Preferred Shares or other shares of capital stock issuable upon exercise of the Rights, the Company shall take any corporate action which may, in the opinion of its counsel, be necessary in order that the Company may validly and legally issue fully paid and nonassessable Preferred Shares or other such shares at such adjusted Purchase Price.
Other Limitations Prior to the payment in full of the Debt, neither Borrower nor any of its Affiliates shall, without the prior written consent of Lender (which may be furnished or withheld at its sole and absolute discretion), give its consent or approval to any of the following actions or items: the distribution by Mortgage Borrower or Senior Mezzanine Borrower of property other than cash.
