Safety. This installation manual is written exclusively for competent professional personnel. The installation, electrical connections and adjustments must be carried out conforming to good practice and according to the regulations in force. Incorrect installation can cause a potential hazard. The packing materials (plastic, polystyrene, etc.) must not be allowed to pollute the environment, but must be disposed of correctly, and must not be left within the reach of children since they could potentially be a source of danger. Before starting installation, check the product is complete and undamaged. Do not install the product in an explosive environment or atmosphere: the presence of flammable gas or fumes is a serious safety hazard. Before installing the drive mechanism, put in place all the structural modifications relating to safety gaps and to the protection or segregation of all the zones involving hazards of crushing, shearing, entrapment and of general hazard. Check that all the existing structure has the necessary requirements of strength and stability. The manufacturer of the unit is not responsible for failing to conform to good practice in the construction of the windows to be opened, as well as any distortion which could occur during use. Put up the notices laid down by current regulations to identify hazardous areas. Ensure that the electrical supply is not a temporary one, but has the required electrical boxes, and in case of doubt or lack of (definite) information, also install: - suitable isolating transformers - thermal magnetic cut-outs suitable to voltage requirements - surge arrester. Before connecting the electrical supply, ensure that the electrical rating corresponds to that of the electrical mains. Fit onto the supply network an all-pole switch with a contact gap of at least 3 mm. Check that on the supply side of the electrical plant there is a suitable differential residual current circuit breaker and overload protection. When required to do so, connect to an efficient earthing/ground system fitted according to the safety regulations in force in the country where the actuator is being installed. Before carrying out any operation (installation, maintenance or repair), isolate the electrical supply before working on the equipment. To ensure complete isolation from the mains, the installation of an homologated double-pole switch is recommended.
Appears in 1 contract
Sources: Manuale Di Istruzioni Per L’uso
Safety. This installation manual is written exclusively for competent professional personnel. The installation, electrical connections and adjustments must be carried out conforming to good practice and according to the regulations in force. Incorrect installation can cause a potential hazard. The packing materials (plastic, polystyrene, etc.) must not be allowed to pollute the environment, but must be disposed of correctly, and must not be left within the reach of children since they could potentially be a source of danger. Before starting installation, check the product is complete and undamaged. Do not install the product in an explosive environment or atmosphere: the presence of flammable gas or fumes is a serious safety hazard. Before installing the drive mechanism, put in place all the structural modifications relating to safety gaps and to the protection or segregation of all the zones involving hazards of crushing, shearing, entrapment and of general hazard. Check that all the existing structure has the necessary requirements of strength and stability. The manufacturer of the unit is not responsible for failing to conform to good practice in the construction of the windows to be opened, as well as any distortion which could occur during use. Put up the notices laid down by current regulations to identify hazardous areas. Ensure that the electrical supply is not a temporary one, but has the required electrical boxes, and in case of doubt or lack of (definite) information, also install: - suitable isolating transformers - thermal magnetic cut-outs suitable to voltage requirements - surge arrester. Before connecting the electrical supply, ensure that the electrical rating corresponds to that of the electrical mains. Fit onto the supply network an all-pole switch with a contact gap of at least 3 mm. Check that on the supply side of the electrical plant there is a suitable differential residual current circuit breaker and overload protection. When required to do so, connect to an efficient earthing/ground system fitted according to the safety regulations in force in the country where the actuator is being installed. Before carrying out any operation (installation, maintenance or repair), isolate the electrical supply before working on the equipment. To ensure complete isolation from the mains, the installation of an homologated double-pole switch is recommended.
Appears in 1 contract
Sources: Instruction Manual