Wheelchair ramp definition

Wheelchair ramp means a facility constructed between the curb and concrete sidewalk to provide access from the street to the sidewalk for wheelchairs. (Sec. 20-2.2, R.O. 1978 (1987 Supp. to 1983 Ed.))
Wheelchair ramp. A wheelchair ramp shall be included on the curbside front of the bus at the ambulatory entrance door. A Xxxxx XX 300 Bi Fold Transit Ramp or approved equal, shall be installed and conform to all requirements as outlined in the ADA regulations. The ramp shall be equipped with a manual over-ride to permit ramp to be deployed or stowed manually in event of power failure or emergency. A complete set of operating instructions, schematics and a trouble- shooting guide shall be included with each ramp. Entry ramp shall be rated at 1,000 pounds. Entry ramp shall be 62 inches minimum and provide a 1:5 angle when deployed to the ground. Securement Devices: There shall be two wheelchair tie down spaces (reference seating diagram). All floor-mounted attachments shall be flush mounted, and must meet the specifications as outlined in the ADA regulations Subpart B-Buses, Vans and Systems, 38.23 Mobility aid accessibility (d) Securement devices, as well as ANSI/RESNA WC-18. Retractors must be self-tensioning and self-locking. Acceptable kits are Q’Straint QRT-360 (Q-10007) Sure-Lok WC-18 TITAN (AL812S-4C) or pre-approved equal. A storage container shall be provided for each securement station to allow clean storage of the system straps and belts when not in use. A hand held web cutter shall be provided. (Sure-Lok part number 8705 or Q’Straint part number Q5-7590) Stanchion Bar: Stanchion and grab bars shall be of corrosion resistant stainless steel or equivalent, a minimum of 1-1/4" in diameter and padded. Padding shall be permanently bonded to stanchion and grab bars. Padded stanchion bar shall be installed at side entrance door. Anti- vandal grab handles shall be located on top of each forward facing aisle seat. A passenger assist stainless grab bar shall be securely mounted on both sides of the entrance door running parallel to the entryway for ADA compliance. Bar to be a minimum of 1" in diameter. Location to be approved by DRPT. There shall also be a floor to ceiling stanchions on the left side of the aisle at the entry to the passenger compartment. The vertical stanchion shall include a horizontal cross bar that attaches to the sidewall. In addition, the curbside stanchion shall include a modesty panel separating the first row of curbside seats from the step well. Driver’s Privacy Glass: Lexan or Plexiglas driver’s privacy glass to be mounted on the stanchion behind the driver.

Examples of Wheelchair ramp in a sentence

  • Wheelchair ramp door shall be located on the right side of vehicle, ramp shall be manually operated, fold out type, manufactured from formed aluminum with a shock or spring assembly to control the rate of movement, and shall have 60 grit powder coating bonded to walking surface.

  • In this aspect of the study, “Incorporation of ADA Requirements into Transit Guidance Information,” the Figure 2 - Wheelchair ramp access to the bus.Image from: http://www.ican.com/news/fullpage.cfm/articleid/ 31AB30A2-2605-430F-91F1A248642137AD/cx/self_discovery.role_models/ more general question of access to information in public accommodations for those with sensory or mental disabilities has been addressed.

  • Wheelchair ramp installation shall be included as a part of the sidewalk pay item.

  • Wheelchair ramp construction shall be in accordance with standards set forth in the City of Savannah's standard detail or as specified by the Director of Streets Maintenance.

  • Front and rear axle assemblies Multiplex Training Board Wheelchair ramp assemblyEngine, radiator, and transmission mock up The following chart lists the training curriculum subjects, expected hours, number of classes and total number of training hours for the five year contract based on one buy per year.

  • Lake District: Wheelchair ramp leading to front door, wide WC/wet room with hand rails, wider corridor and door entrances.

  • Wheelchair ramp control interlock shall be integrated with coach brakes and accelerator to prevent coach movement during operation.

  • An overdue fee is charged per day when a book is not returned on time up to a maximum of 60 days after which the book will be assumed lost, and a replacement cost demanded from the patron by the finance department.

  • Upon any termination or expiration of this Agreement: (i) Customer must immediately pay all Fees (if applicable) accrued up to the effective date of termination or expiration of this Agreement (whichever is applicable); and (ii) all applicable licenses granted to Customer under this Agreement will immediately cease; provided that licenses granted to Arcserve with respect to Customer Data shall survive for the duration as provided below.

  • DISCUSSION In its charge, the Union alleges that Ross’s and Blakey’s questioning of Sheetz about the posting, Ross’s order to remove the posting and implied threats made during the discussion at the board on September 10, 2008, constitute interference with--as well as intimidation, coercion and restraint of--Sheetz’s Article IV rights thereby constituting an independent violation of Section 1201(a) (1) of PERA.1 (Specification of Charges, ¶ 6).

Related to Wheelchair ramp

  • Wheelchair means a manually operated or power-driven device designed primarily for use by an individual with a mobility disability.

  • Motorized wheelchair means any self-propelled vehicle designed for, and used by, a handicapped person and that is incapable of a speed in excess of eight miles per hour.

  • Wheel means a complete wheel consisting of a rim and a wheel disc;

  • Intermodal Rail Yard means a rail facility in which cargo is transferred from drayage truck to train or vice-versa.

  • High voltage bus means the electrical circuit, including the coupling system for charging the REESS, that operates on a high voltage.

  • Landing Gear means the installed main and nose landing gear, components and their associated actuators, side braces and parts.

  • Luggage compartment means the space in the vehicle for luggage accommodation, bounded by the roof, hood, floor, side walls, as well as by the barrier and enclosure provided for protecting the occupants from direct contact with high voltage live parts, being separated from the passenger compartment by the front bulkhead or the rear bulk head.

  • Passenger compartment means the space for occupant accommodation, bounded by the roof, floor, side walls, doors, outside glazing and front bulkhead and the plane of the rear compartment bulkhead or the plane of the rear-seat back support.

  • NACE means National Association of Corrosion Engineers

  • Network Rail means Network Rail Infrastructure Limited, a company registered in England under company number 02904587 and having its registered office at 0 Xxxxxxxxx Xxxxxx, Xxxxxx XX0 0XX;

  • Auxiliary meaning an employee who is employed for work which is not of a continuous nature. "Employee" does not include managerial or confidential positions mutually excluded by the parties to this Agreement or by decision of the Labour Relations Board.

  • Dark Fiber shall have the meaning set forth in Section 9.7.1.

  • Landing means the level portion of a stairs located between flights of stairs or located at the top and foot of a stairs.

  • Generator Operator means the Person that Operates the Generating Facility and performs the functions of supplying electric energy and interconnected operations services within the meaning of the NERC Reliability Standards.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Rack means a mechanism for delivering motor vehicle fuel or diesel from a refinery or terminal into a truck, trailer, railroad car, or other means of non-bulk transfer.

  • PNode has the meaning set forth in the CAISO Tariff.

  • Bicycle lane means that portion of a roadway designated by signs and/or pavement markings for

  • Generator Planned Outage means the scheduled removal from service, in whole or in part, of a generating unit for inspection, maintenance or repair with the approval of the Office of the Interconnection in accordance with the PJM Manuals.

  • Stack means any point in a source designed to emit solids, liquids, or gases into the air, including a pipe or duct but not including flares.

  • Co-pilot means a pilot operating other than as pilot-in-command, on an aircraft for which more than one pilot is required, but excluding a pilot who is on board the aircraft for the sole purpose of receiving flight instruction for a licence or rating.

  • Pilot or "Payment in Lieu of Tax" shall mean any payment made to the Agency or an affected tax jurisdiction equal to all or a portion of the real property taxes or other taxes which would have been levied by or on behalf of an affected tax jurisdiction with respect to a project but for tax exemption obtained by reason of the involvement of the Agency in such project, but such term shall not include Agency fees.

  • STP means the temperature of fifteen degrees Celsius (15°C) and at a pressure of one hundred and one decimal three two five kilopascals (101.325 kPa).

  • Stinger-steered automobile or watercraft transporter means an automobile or watercraft transporter

  • Bus means a motor vehicle designed for carrying more than 10 passengers and used for the transportation of persons and any other motor vehicle, other than a taxicab, designed and used for the transportation of persons for compensation.

  • Yard trimmings means grass clippings, leaves, wood chips from tree parts, and brush.