Examples of UL 1741 scope 1.1A in a sentence
Equipment must be certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and in compliance with UL 1741 scope 1.1A, effective May 7, 2007, and its installation must meet all current local and state electric and construction code requirements.
Any equipment that is certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and in compliance with UL 1741 scope 1.1A, effective May 7, 2007, and installed in compliance with this part is considered to be eligible equipment.
Category 1 – eligible electric generator(s) with aggregate generation of 20 kW or less that use equipment certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and in compliance with UL 1741 scope 1.1A.
A Category 1 Net Metering customer has one or more Eligible Electric Generators with an aggregate nameplate capacity of 20 kW or less that use equipment certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and is in compliance with UL 1741 scope 1.1A located on the customer's premises and metered at a single point of contact.
Any equipment that is certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and in compliance with UL 1741 scope 1.1A, effective May 7, 2007, and installed in compliance with this part is considered to be compliant.
Necessary instruments and accessories such as voltmeter, power factor meter, KW meter, KWH meter, Ammeter, Frequency meter etc.
A Category 1 distributed generation customer has one or more Eligible Electric Generators with an aggregate nameplate capacity of 20 kWac or less that use equipment certified by a nationally recognized testing laboratory to IEEE 1547.1 testing standards and is in compliance with UL 1741 scope 1.1A located on the customer's premises and metered at a single point of contact.
The following are required of the isolation device: • Must be approved for use on the Utility system.• Must comply with current relevant ANSI, UL 1741 scope 1.1A, and IEEE Standards.• Must have load break capability.• Must be rated for the application.• If used as part of a protective relaying scheme, it must have adequate interrupting capability.
UL 1741 scope 1.1A" means paragraph 1.1A contained in chapter 1, section 1 ofUL 1741.
Category 1" means an inverter based project of 20 kW or less that uses equipment certified by a nationally recognized testing laboratory to the most current IEEE 1547.1 testing standards and in compliance with the most current UL 1741 scope 1.1A.