Track Width definition

Track Width. ’ means the lateral distance between the centerlines of the base tires at ground, including the camber angle.
Sample 1Sample 2Sample 3
Track Width means the distance referred to in point 6.5 of Standard ISO 612:1978;
Sample 1Sample 2
Track Width means the distance between two parallel planes bounding the outside of the raised tread pattern (lugs) or pads.
Sample 1

Examples of Track Width in a sentence

  • A.2-2013.1. Track Width and Spacing...............................................................................

  • Front and rear Track Width: 1730mm maximum This measurement will be taken at the bottom of the wheel (closest to the ground) from the widest part of the outer edge of the rim where it meets the tyre.

  • The measurements are to be taken from the ground to the tallest point of the vehicle for the Overall Vehicle Height and the normal track measure- ment as stated in Section 12 for the Average Track Width.

  • After several experimental and numerical iterations, theb φ Vehicle Weight Track Width Track Length Track Area Track Height Vehicle Width Contact Pressure Aspect Ratio Sinkage Depth Drawbar-Pull Grouser Height Table 1:HOUDINI Design and Performance ParametersHoudini system was laid out with the design parameters and the predicted physical performance characteristics shown in Table 1 - experimental verification is currently underway.

  • The specific pieces of data are:• Wheelbase;• Track Width Front;• Track Width Rear;• EPS (Electric Power Steering);• ROLL (Reduced Rolling Resistance);• LUB (Advance Lubrication i.e., low weight oil);• IACC (Improved Electrical Accessories);• Curb Weight;• GVWR (Gross Vehicle Weight Rating)The track widths, wheelbase, curb weight, and GVWR could have been looked up on the Internet (159 were), but were taken from the product plans when available for convenience.

  • A track width measurements application is available at www.nd.gov/ndhp, click on Motor Carrier, Permit Application Forms, click on Diagram for Track Width Measurements.

  • The final Track Width measurement uses the average of multiple independent measurements in order to minimize errors associated with small steer angles.

  • Track Width – Minimum track width is 28” and maximum track width and maximum kart width is 55 and 1/8”.

  • Be- tween September 1986 and April 1989, (which we will call the “enrollment period,”) incident cases of IDDM in children up to age 15 (the “probands,”) were identified through the prospective IDDM registry and their families were asked to participate in the study [Tuomilehto et al., 1992].

  • Rear Axle Track Width (average of items 1 through 4 and rounded to two decimal places) The vehicle track width is the calculated average of the front and rear track widths in mm (step 5 in each table) rounded to two decimal places and then converted to inches by dividing by 25.4 mm/in and rounding to the nearest tenth of an inch or one decimal place.) Vehicle Track Width = (in.) 16.

Related to Track Width

  • Bandwidth means a distributor’s defined tolerance used to flag data for further scrutiny at the stage in the VEE process where a current reading is compared to a reading from an equivalent historical billing period. For example, a 30 percent bandwidth means a current reading that is either 30 percent lower or 30 percent higher than the measurement from an equivalent historical billing period will be identified by the VEE process as requiring further scrutiny and verification;

  • Router means a modem or router provided by us for use by you in connection with the Broadband Service.

  • Source-image receptor distance means the distance from the source to the center of the input surface of the image receptor.

  • Network Load means the load that a Network Customer designates for Network Integration Transmission Service under Tariff, Part III. The Network Customer’s Network Load shall include all load (including losses) served by the output of any Network Resources designated by the Network Customer. A Network Customer may elect to designate less than its total load as Network Load but may not designate only part of the load at a discrete Point of Delivery. Where an Eligible Customer has elected not to designate a particular load at discrete points of delivery as Network Load, the Eligible Customer is responsible for making separate arrangements under Tariff, Part II for any Point-To-Point Transmission Service that may be necessary for such non-designated load.

  • online interface means any software, including a website, part of a website or an application, that is operated by or on behalf of an economic operator, and which serves to give end users access to the economic operator's products;

  • Interface means the mixture occurring in pipeline operations between adjoining batches having similar or dissimilar physical characteristics.

  • Synchronous Optical Network (SONET) is an optical interface standard that allows inter-networking of transmission products from multiple vendors. The base rate is 51.84 Mbps (“OC-1/STS-1”) and higher rates are direct multiples of the base rate, up to 13.22 Gbps.

  • Check Meter means the Buyer revenue-quality meter section(s) or meter(s), which Buyer may require at its discretion, and which will include those devices normally supplied by Buyer or Seller under the applicable utility electric service requirements.

  • Automated driving system means the same as that term is defined in Section 41-26-102.1.

  • User Interface(s means any technologies thatiii. Customer owns and/or for which Customer has secured an appropriate license/subscription and is/areiv. used to develop/manage user interaction features and characteristics for ERP. Solely for clarity regarding ERP licensing requirements under a contract, User Interfaces for ERP shall be deemed part of ERP and therefore require human users Using ERP via such User Interfaces to have a “Named User” and/or “User” license for ERP, as applicable.

  • Net Metering Net metering refers to customers who sell electricity they produce, typically through a rooftop solar panel, back to the utility for credit. If you are a net metering customer, you should not enroll with XOOM because your net metering agreement will not transfer to XOOM once you enroll.

  • Building Energy Benchmarking means the process of measuring a building’s Energy use, tracking that use over time, and comparing performance to similar buildings.

  • Voice over internet protocol service means any service that:

  • Internet service means a service that enables users to access proprietary and other content,

  • Switched Access Service means an offering of facilities for the purpose of the origination or termination of traffic from or to Exchange Service customer in a given area pursuant to a Switched Access tariff. Switched Access Services include: Feature Group A, Feature Group B, Feature Group D, 800 Series, and 900 access. Switched Access does not include traffic exchanged between LECs for purpose of local exchange interconnection.

  • Broadband Internet access service means a mass-market retail service by wire or radio that provides the capability to transmit data to and receive data from all or substantially all Internet endpoints, including any capabilities that are incidental to and enable the operation of the communications service, but excluding dial-up Internet access service. This term also encompasses any service that the State finds to be providing a functional equivalent of the service described in the previous sentence, or that is used to evade the protections set forth in this section.

  • Network means the participating providers described in the Provider Directory.

  • Three-dimensional reference system means a system as described in Appendix 2 to this annex;

  • Modular building retailer means any person who purchases or acquires a modular building from a

  • Connectivity means the provision of a Permanent Separated Bicycle Lane system that reflects desired routes between all major origins and destinations in the city.

  • Net metering system means a facility for the production of electrical energy that does all of the following:

  • Data Universal Number System (DUNS) Number means the 9-digit number assigned by Dun and Bradstreet, Inc. (D&B) to identify unique business entities.

  • Exchange Message Interface or "EMI" means the format used for exchange of Telecommunications message information among Telecommunications Carriers. It is referenced in the Alliance for Telecommunications Industry Solutions (ATIS) document that defines industry guidelines for the exchange of message records.

  • Synchronous interaction means a real-time interaction between a patient and a health care provider for telehealth located at a distant site.

  • User Interface means the interface for the Hosted Services designed to allow individual human users to access and use the Hosted Services.

  • Data Universal Numbering System +4 (DUNS+4) number means the DUNS number assigned by D&B plus a 4- character suffix that may be assigned by a business concern. (D&B has no affiliation with this 4-character suffix.) This 4-character suffix may be assigned at the discretion of the business concern to establish additional SAM records for identifying alternative Electronic Funds Transfer (EFT) accounts for the same parent concern.