Pulse repetition rate definition

Pulse repetition rate means the repetition frequency of the waveform modulating the ultrasonic carrier wave expressed in pulses per second (pps).

Examples of Pulse repetition rate in a sentence

  • Pulse repetition rate has been considered as the most important parameter in determining heat accumulation in the tissue during the ab- lation procedure [38], encouraging the use of low pulse repetition rates to have a safe prepa- ration [38].

  • The 1064 nm light beam from a pulsed laser (Surelite lasers, Continuum, CA; Pulse repetition rate: 10 Hz) was first expanded and then focused by a convex lens with a large numerical aperture (NA = 1) into a water tank, with an optical focal spot size of ~0.81 μm.

  • Pulse repetition rate was10 kHz and beam translation speed was 250 μm/s.

  • Pulse repetition rate, <1 atm of elevated static pressure, alteration of the fluid medium around the stone, waveform manipulation, and the timing between pulses were used to control cavitation and both ensuing bio-effects – stone comminution and tissue injury.

  • IPL settings: The available settings for this applicator are:• Wave Length 690 nm.• Spot size 30mmX10mm.• Pulse duration of 20 – 50 ms.• Fluence/Energy density of 5-20 J/cm2.• Pulse repetition rate of up to 3 Hz.

  • Specifications of the lidar instrument as operated during BUBBLE Laser Wavelength 532 nm Average Output power 18–20 mW Pulse repetition rate (prr) 5–6 kHz Receiver Effective aperture 100 mm Ø Range of full overlap 180 m Detection and data acquisition Detection type Photon counting, two independent channels (‘p’ and ‘s’ polarizations) Range resolution 10 m Technical Detection range Number of laser pulses for a single measurement Up to approx.

  • It has been fabricated by Stangenes Industries, Inc.Rise time 250 nsTurn ratio 1:14 Pulse repetition rate 180 pps Table 2.

  • Pulse repetition rate varied with water depth, but has a period of approximately 15 s to 20 s for the majority of the cruise.The departure draft at the beginning of the cruise of RV Kilo Moana was 7.57 m port forward; 7.65 m starboard forward; 7.72 m port aft; and 7.92 m starboard aft.

  • Divergence (full cone): 20 mrad• Pulse repetition rate shall allow for a seamless along-track ground pattern• Allow for pulse shape modelingLifetime: 1 year; total no of shots: 5 Mio (classical system, tbc.) (see performance spread sheet in Table 24) 9.1.3 DescriptionThe instrument will consist essentially of 3 components, a Laser transmitter, a Laser receiver with a receiver optics of approx.

  • Pulse repetition rate is 25Hz continuously.We have evaluated a wide range of pulsed power technology options and concluded that the requirement is beyond the state of the art for fast kicker technology.

Related to Pulse repetition rate

  • Termination Rate means a rate per annum equal to the arithmetic mean of the cost (without proof or evidence of any actual cost) to each party (as certified by such party) if it were to fund or of funding such amounts.

  • Capitation rate means the fee the department pays monthly to a participating health or dental plan for each enrollee for the provision of covered medical or dental services whether or not the enrollee received services during the month for which the fee is intended.

  • Original Accrual Rate With respect to each Payment Date and any Reference Obligation, the lesser of (i) the related Accounting Net Yield as of the Cut-off Date; and (ii) the related mortgage rate as of the Cut-off Date minus 0.35%.

  • Calculation Rate For each Distribution Date, in the case of the Class A and Class B Interests, the product of (i) 10 and (ii) the weighted average rate of the outstanding Class A and Class B Interests, treating each Class A Interest as capped at zero or reduced by a fixed percentage of 100% of the interest accruing on such Class.

  • HICP Daily Inflation Reference Index means (i) in relation to the first day of any given calendar month, the HICP Monthly Reference Index of the third calendar month preceding such month, and (ii) in relation to a day D (other than the first day) in any given month ("M"), the linear interpolation of the HICP Monthly Reference Index pertaining respectively to the third calendar month preceding such month ("M – 3") and the second calendar month preceding such month ("M – 2") calculated in accordance with the following formula:

  • Amortization rate means the amortization rate, as defined in Section 49-11-102, to be applied to the system that would have covered the retiree if the retiree's reemployed position were deemed to be an eligible, full-time position within that system.

  • Infiltration rate means the rate of water entry into the soil expressed as a depth of water per unit of time (e.g., inches per hour).

  • Inflation rate means that term as defined in section 34d.

  • Administrative Cost Rate As of any date of determination, a rate equal to the sum of the Servicing Fee Rate, the Operating Advisor Fee Rate, the Asset Representations Reviewer Ongoing Fee Rate, the CREFC® Intellectual Property Royalty License Fee Rate and the Trustee/Certificate Administrator Fee Rate.

  • CPI Daily Inflation Reference Index means (A) in relation to the first day of any given month, the CPI Monthly Reference Index of the third month preceding such month, and (B) in relation to a day (D) (other than the first day) in any given month (M), the linear interpolation of the CPI Monthly Reference Index pertaining respectively to the third month preceding such month (M - 3) and the second month preceding such month (M - 2) calculated in accordance with the following formula:

  • Auction Rate means the rate of interest per annum that results from implementation of the Auction Procedures and is determined as described in Section 2.02(a)(iii)(B) of this Appendix A.

  • Lowest achievable emission rate or “LAER” means, for any source, the more stringent rate of emissions based on the following:

  • Compounded Daily Reference Rate means, with respect to an Interest Period, the rate of return of a daily compound interest investment in the Specified Currency (with the applicable Reference Rate (as indicated in the relevant Final Terms and further provided for below) as the reference rate for the calculation of interest) and will be calculated by the Calculation Agent on the Interest Determination Date, as follows, and the resulting percentage will be rounded, if necessary, to the fifth decimal place, with 0.000005 being rounded upwards:

  • Administrative Fee Rate The sum of the Servicing Fee Rate, the Trustee/Certificate Administrator Fee Rate and the CREFC® Licensing Fee Rate.

  • Minimum Credit Enhancement Test With respect to any Payment Date, a test that will be satisfied if the Subordinate Percentage is greater than or equal to 6.00%.

  • Cash Interest Coverage Ratio With respect to any Loan for any Relevant Test Period, either (a) the meaning of “Cash Interest Coverage Ratio” or comparable definition set forth in the Underlying Instruments for such Loan, or (b) in the case of any Loan with respect to which the related Underlying Instruments do not include a definition of “Cash Interest Coverage Ratio” or comparable definition, the ratio of (i) EBITDA to (ii) Cash Interest Expense of such Obligor with respect to the applicable Relevant Test Period, as calculated by the Borrower and Collateral Manager in good faith.

  • First Lien Net Leverage Ratio means, with respect to any Test Period, the ratio of (i) Consolidated Total Indebtedness secured on a first lien basis, net of Unrestricted Cash, as of the last day of such Test Period, to (ii) Consolidated EBITDA for such Test Period.

  • Bondable stranded costs rate order means one or more

  • Swap Provider Trigger Event A Swap Termination Payment that is triggered upon: (i) an Event of Default under the Interest Rate Swap Agreement with respect to which the Swap Provider is a Defaulting Party (as defined in the Interest Rate Swap Agreement), (ii) a Termination Event under the Interest Rate Swap Agreement with respect to which the Swap Provider is the sole Affected Party (as defined in the Interest Rate Swap Agreement) or (iii) an Additional Termination Event under the Interest Rate Swap Agreement with respect to which the Swap Provider is the sole Affected Party.

  • Emission Rate for a given pollutant means the number of pounds of that pollutant emitted per million British thermal units of heat input (lb/mmBTU), measured in accordance with this Consent Decree.

  • emission limit value means the mass, expressed in terms of certain specific parameters, concentration and/or level of an emission, which may not be exceeded during one or more periods of time;

  • Expense Rate As to each Mortgage Loan, the sum of the Master Servicing Fee Rate and the Trustee Fee Rate.

  • Reference Cut-Off Date means the eighth Scheduled Trading Day immediately following the Scheduled Reference Date or, if earlier, the Scheduled Trading Day falling on or immediately preceding the second Business Day immediately preceding the due date on which payment of any amount or delivery of any assets may have to be made pursuant to any calculation or determination made on such Reference Date, provided that the Reference Cut-Off Date shall not fall prior to the original date on which such Reference Date was scheduled to fall.

  • Trustee Fee Rate 0.0025% per annum.

  • Defined Contribution Dollar Limitation means, for any Limitation Year, $46,000, as adjusted for increases in the cost-of-living under Code section 415(d). If a short Limitation Year is created because of a Plan amendment changing the Limitation Year to a different 12-consecutive month period, the Defined Contribution Dollar Limitation for the short Limitation Year will not exceed the amount determined in the preceding sentence multiplied by a fraction, the numerator of which is the number of months in the short Limitation Year and the denominator of which is 12.

  • Term SOFR Reference Rate means the forward-looking term rate based on SOFR.