Plug in Hybrid definition

Plug in Hybrid means a vehicle that can be charged from an external source and can generate, store, and utilize electric power to reduce the vehicle’s consumption of fossil fuel. These vehicles typically include a larger battery pack to allow an extended range of operation without the use of the gasoline or diesel engine.
Sample 1Sample 2Sample 3
Plug in Hybrid means: An electric motor vehicle which is originally equipped so that the vehicle draws propulsion form an internal combustion engine and a battery with at least 5 kilowatt hours of capacity, which can be recharged from an external source of electricity, has at least four wheels, and is manufactured primarily for use on public streets, roads and highways.
Sample 1

Examples of Plug in Hybrid in a sentence

  • Loss of battery energy or power over time or due to or resulting from battery usage, is NOT covered under this Hybrid, Plug- in Hybrid, and Electric Vehicle System Warranty.

  • The City (Mayor and City Council) shall require City Departments to purchase Full Hybrid Electric Vehicle (FHEV), Plug in Hybrid Electric Vehicles (PHEV) or Electric Vehicles (EV) for Light-Duty Vehicles (sedans, vans, SUVs) as much as practical, unless the option is not available or is cost prohibitive.

  • In 2016 as part of the replacement cycle of fleet cars, all fleet cars were replaced with 57 electric range extended or Plug in Hybrid Electric Vehicles.

  • For a comparison against conventional gasoline vehicles, we employed the California Household Travel Survey and for ordinary electric vehicles we employed the Plug- in Hybrid & Electric Vehicle (PH&EV) multi-year panel survey of over 14,000 respondents to derive a generalized profile of electric vehicle travel patterns.

  • Beauregard, Report of Investigation: Hybrids Plus Plug in Hybrid Electric Vehicle, U.S. Department of Energy, Idaho National Laboratory, 2008.

  • The draft Bill allows a CP that is not an eligible licensee to satisfy their obligations by meeting the supply requirements of the PRDE (Model 1).

  • It covers hybrid & electric technologies like Mild Hybrid, Strong Hybrid, Plug in Hybrid & Battery Electric Vehicles.

  • Air Quality Management District (AQMD) recommending the Board, acting as the AQMD Board of Directors, approve amendments to the Drive Clean program that:1) Increase the Plug in Hybrid Electric Vehicle (PHEV) minimum all electric range (AER) eligibility requirement from 23 miles to 30 miles, and2) Increase the amount of time allowed between the pre-approval and the vehicle purchase/lease dates.

  • This group of technologies includes Plug in Hybrid Electric Vehicles (PHEVs).3 Getting power from the electrical grid to the EV’s batteries can take a varying amount of time, although new technologies are speeding up the process.

  • Each manufacturer that produces and delivers for sale in Colorado for model year 2023 and beyond will have to meet the requirement by selling a percentage of their vehicles as ZEVs. ZEVs expected to be offered in Colorado in model year 2023 through 2030 are Battery Electric Vehicles (BEVs) and Plug in Hybrid Electric vehicles (PHEVs).

Related to Plug in Hybrid

  • Plug-in Hybrid Electric Vehicle (PHEV) means a vehicle that is similar to a Hybrid but is equipped with a larger, more advanced battery that allows the vehicle to be plugged in and recharged in addition to refueling with gasoline. This larger battery allows the car to be driven on a combination of electric and gasoline fuels.

  • Epinephrine auto-injector means a device for immediate self-administration or administration by another trained person of a measured dose of epinephrine to a person at risk of anaphylaxis.

  • Pump spray means a packaging system in which the product ingredients within the container are not under pressure and in which the product is expelled only while a pumping action is applied to a button, trigger or other actuator.

  • Low-solids coating means a coating containing 0.12 kilogram or less of solids per liter (one pound or less of solids per gallon) of coating material.

  • Nuclear coating means any protective coating used to seal porous surfaces, such as steel or concrete, that otherwise would be subject to intrusion by radioactive materials. These coatings must be resistant to long term (service life) cumulative radiation exposure (ASTM D4082-83**), relatively easy to decontaminate (ASTM D4256-83**), and resistant to various chemicals to which the coatings are likely to be exposed (ASTM 3912-80**). General protective requirements are outlined by the Department of Energy (formerly United States Atomic Energy Commission Regulatory Guide 1.54**).

  • Injection means the pressurized placement of septage waste below the surface of soil.

  • Certified scale weigh ticket means a weigh ticket that has been issued by a

  • Modern Slavery has the meaning given to that term or, if “Modern Slavery” is not used, similar terms (such as forced labor), in the Modern Slavery Laws. Seller confirms that it does not use any Forced Labor, it conducts its business in compliance with the applicable Modern Slavery Laws, and it is not subject to any investigation, enforcement or conviction involving Modern Slavery. Seller shall promptly notify Buyer of any actual or suspected breaches by Seller or its Subcontractors of the applicable Modern Slavery Laws, and Seller agrees to provide Buyer immediately upon request any information and assistance that Buyer may require for compliance with the applicable Modern Slavery Laws.

  • Heat input means the product (expressed in mmBtu/time) of the gross calorific value of the fuel (expressed in Btu/lb) and the fuel feed rate into the combustion device (expressed in mass of fuel/time) and does not include the heat derived from preheated combustion air, recirculated flue gases, or ex- haust from other sources.

  • Exfiltration means any unauthorized release of data from within an information system. This includes copying the data through covert network channels or the copying of data to unauthorized media.

  • generating station or “station” means any station for generating electricity, including any building and plant with step-up transformer, switch yard, switch-gear, cables or other appurtenant equipment, if any used for that purpose and the site thereof, a site intended to be used for a generating station, and any building used for housing the operating staff of a generating station, and where electricity is generated by water-power, includes penstocks, head and tail works, main and regulating reservoirs, dams and other hydraulic works, but does not in any case include any sub-station;

  • Clear coating means a transparent coating designed to provide the final gloss and resistance properties of the coating system;

  • Seat Belt means a properly installed:

  • Electrostatic spray means a method of applying a spray coating in which opposite electric charges are applied to the substrate and the coating. The coating is attracted to the substrate by the electrostatic potential between them.

  • Touch-up coating means a coating used to cover minor coating imperfections appearing after the main coating operation.

  • broadcasting station means a station in the broadcasting service.

  • Dietitian or “licensed dietitian” means a person who maintains a license granted by the Iowa board of dietetic examiners.

  • AT&T-12STATE means the AT&T owned ILEC(s) doing business in Arkansas, California, Illinois, Indiana, Kansas, Michigan, Missouri, Nevada, Ohio, Oklahoma, Texas and Wisconsin.

  • Semitrailer means every vehicle of the trailer type so designed and used in conjunction with a

  • Hybrid electric vehicle (HEV) means a hybrid vehicle where one of the propulsion energy converters is an electric machine.

  • General purpose radiographic x-ray system means any radiographic x-ray system which, by design, is not limited to radiographic examination of specific anatomical regions.

  • Off-highway implement of husbandry means the same as that term is defined in Section 41-22-2.

  • Nitrogen oxides means nitric oxide and nitrogen dioxide, expressed as nitrogen dioxide (NO2);

  • Self-contained breathing apparatus or "SCBA" means an atmosphere-supplying respirator for which the breathing air source is designed to be carried by the user.

  • Cord means the strands forming the fabric of the plies in the tyre;

  • Pretreatment coating means a coating which contains no more than 12% solids by weight, and at least 0.5% acid by weight, is used to provide surface etching, and is applied directly to metal surfaces to provide corrosion resistance, adhesion, and ease of stripping.