Input power definition

Input power means the rate of electricity consumption, in watts, of an illuminated exit sign.
Sample 1Sample 2Sample 3
Input power means the full-load power input required to operate the motor. “Multi-voltage electric motor” means an electric motor that is capable of operating at:
Sample 1Sample 2Sample 3
Input power means the full-load power input required to operate the motor.
Sample 1Sample 2

Examples of Input power in a sentence

  • Input power to the environmental enclosure shall be either 115 VAC 60 Hertz or 24 VAC/DC 60 Hertz.

  • Input power factor shall be 0.98 lagging at 100% load with out the use of passive filters.

  • Input power factor shall be 0.98 lagging at 100% load without the use of passive filters.

  • Input power to the environmental enclosure shall be 110 VAC and either 50 or 60 Hz as an option.

  • Input power failure occurs when voltage and frequency are outside rated steady-state and transient tolerance bands or when distortion or interruptions are outside the limits specified for the UPS.

  • Input power and processor utilization measurements must be sampled internally to the computer server at a rate of greater than or equal to measurement per contiguous 10 second period.

  • Input power measurements must be reported with accuracy within ±5% of the actual value for measurements greater than 200 W, through the full range of operation.

  • Input power cabling and over-current protection devices must be chosen to match the current consumption.

  • This operation will continue until:a) The battery capacity expires and the inverter turns off, orb) Input power is restored after which the converter will power the inverter and critical load and simultaneously recharge the batteries.

  • Input power for both systems is provided by the commercial power supply system, which is backed up by stand-by generator(s).


More Definitions of Input power

Input power means the actual total power used by all lamp(s) and ballast(s) of the light kit during operation, expressed in watts (W) and measured using the lamp and ballast packaged with the kit.
Sample 1Sample 2
Input power means the power provided to the ballast, typically line alternating-current power as determined by 10 C.F.R., section 2.5.1.6 of Appendix Q of Ssubpart B of part 430.‌
Sample 1
Input power means the direct current (DC) input power to the radio frequency power output stage immediately preceding the antenna;
Sample 1
Input power of a ceiling fan light kit means the actual total power used by all lamp(s) and ballast(s) of the ceiling fan light kit during operation, expressed in watts and measured using the lamp and ballast packaged with the kit.‌
Sample 1

Related to Input power

  • net power means the power obtained on a test bench at the end of the crankshaft or its equivalent at the corresponding engine or motor speed with the auxiliaries, tested in accordance with Annex XX (Measurements of net power and the maximum 30 minutes power of electric drive train), and determined under reference atmospheric conditions;

  • Market power means the ability to impose on customers a sustained price for a product or service above the price that would prevail in a competitive market.

  • Station Power means energy used for operating the electric equipment on the site of a generation facility located in the PJM Region or for the heating, lighting, air-conditioning and office equipment needs of buildings on the site of such a generation facility that are used in the operation, maintenance, or repair of the facility. Station Power does not include any energy (i) used to power synchronous condensers; (ii) used for pumping at a pumped storage facility; (iii) used in association with restoration or black start service; or (iv) that is Direct Charging Energy.

  • relevant power means any power, whether exercisable by voting or otherwise and whether excisable alone or in association with others-

  • maximum net power means the highest value of the net power on the nominal full-load power curve for the engine type;

  • Solar Power means power generated from the Solar Photovoltaic Power Project;

  • Active Power has the meaning given to it in the Grid Code;

  • Reactive Power means the power component which does not produce work but is necessary to allow some equipment to operate, and is measured in kiloVolt Amperes Reactive (kVAR);

  • Infirm Power means electricity injected into the grid prior to the commercial operation of a unit or block of the generating station;

  • Power boiler means a boiler in which steam or other vapor is generated at a pressure of more than 15 psig for use external to itself or a boiler in which water is heated and intended for operation at pressures in excess of 160 psig and/or temperatures in excess of 250 degrees F by the direct application of energy from the combustion of fuels or from electricity, solar or nuclear energy.

  • Repower means to replace an existing engine with a newer, cleaner engine or power source that is certified by EPA and, if applicable, CARB, to meet a more stringent set of engine emission standards. Repower includes, but is not limited to, diesel engine replacement with an engine certified for use with diesel or a clean alternate fuel, diesel engine replacement with an electric power source (e.g., grid, battery), diesel engine replacement with a fuel cell, diesel engine replacement with an electric generator(s) (genset), diesel engine upgrades in Ferries/Tugs with an EPA Certified Remanufacture System, and/or diesel engine upgrades in Ferries/Tugs with an EPA Verified Engine Upgrade. All-Electric and fuel cell Repowers do not require EPA or CARB certification.

  • Fixed wing turbine powered aircraft means an aircraft that:

  • Electric power supplier means a person or entity that is duly

  • Electric power generator means an entity that proposes to

  • Capacity Interconnection Rights means the rights to input generation as a Generation Capacity Resource into the Transmission System at the Point of Interconnection where the generating facilities connect to the Transmission System.

  • resolution power means a power referred to in Articles 63 to 72;

  • Power System means all aspects of generation, transmission, distribution and supply of electricity and includes one or more of the following, namely:-

  • prescribed authority means the authorities specified in Rule 12 of Plastic Waste Management and Handling Rules, 2016, and Commissioner, Municipal Corporations, Chief Executive Officer/Executive Officer, Urban Local Bodies ;

  • Road authority means each governmental agency with jurisdiction over public streets and highways. Road authority includes the department, any other state agency, and intergovernmental, county, city, and village governmental agencies responsible for the construction, repair, and maintenance of streets and highways. When a street railway operates or seeks to operate a street railway system over public streets and highways over which more than 1 road authority possesses jurisdiction, road authority includes each road authority with jurisdiction over public streets and highways upon which the street railway operates or seeks to operate a street railway system.

  • Electric power train means the electrical circuit which includes the traction motor(s), and may also include the REESS, the electrical energy conversion system, the electronic converters, the associated wiring harness and connectors, and the coupling system for charging the REESS.

  • Joint Powers Agreement means that certain Joint Powers Agreement dated June 27, 2017, as amended from time to time, under which Buyer is organized as a Joint Powers Authority in accordance with the Joint Powers Act.

  • Power sweeper means an implement, with or without motive

  • Capacity Market Buyer means a Member that submits bids to buy Capacity Resources in any Incremental Auction.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Bail-in Power means any statutory cancellation, write-down and/or conversion power existing from time to time under any laws, regulations, rules or requirements relating to the resolution of banks, banking group companies, credit institutions and/or investment firms, including but not limited to any such laws, regulations, rules or requirements that are implemented, adopted or enacted within the context of a European Union directive or regulation of the European Parliament and of the Council establishing a framework for the recovery and resolution of credit institutions and investment firms, or any other applicable laws or regulations, as amended, or otherwise, pursuant to which obligations of a bank, banking group company, credit institution or investment firm or any of its affiliates can be reduced, cancelled and/or converted into shares or other securities or obligations of the obligor or any other person.

  • Heat input means the product (expressed in mmBtu/time) of the gross calorific value of the fuel (expressed in Btu/lb) and the fuel feed rate into the combustion device (expressed in mass of fuel/time) and does not include the heat derived from preheated combustion air, recirculated flue gases, or ex- haust from other sources.