Equivalence Factors definition

Equivalence Factors means the factors, tables, rates, or formulas used to calculate a Deferred Participant’s Annuity Payment amount based on their election.
Sample 1Sample 2

Examples of Equivalence Factors in a sentence

  • Dioxins & Furans and Dioxin-like PCB’s shall be reported as multiplied by the Toxic Equivalence Factors as specified in Table 6.5.

  • Table 1 in the Appendix lists the BaP Relative Potency Equivalence Factors used to determine cancer risk associated with cPAH mixtures.

  • The EPA’s Provisional Guidance for Quantitative Risk Assessment of Polycyclic Aromatic Hydrocarbons (USEPA, 1993b) should be consulted for Toxicity Equivalence Factors (TEFs) to utilize in this assessment.

  • PCDD: polychlorinated dibenzo-p-dioxins; PCDF: polychlorinated dibenzofurans; PCB-DL: dioxin-like polychlorinated biphenyls; TEQ: toxic equivalents according to the World Health Organisation 2005 Toxic Equivalence Factors.

  • Special caution is advised to evaluate as many factors as possible that indicate system stability and the possible sources of interference for their contribution to positive interference in those analytes with the highest Toxicity Equivalence Factors (TEF), (i.e., TCDD and PeCDD in the 2005 WHO mammalian TEFs).

  • Their toxicity, as estimated at this time, is relatively much less than the toxicity of the native 2,3,7,8-substituted isomers listed in TableA.6. Hence, only the 2,3,7,8-substituted tetra- through octa- isomers are included in the Toxic Equivalent Quantity (TEQ) or Toxicity Equivalence Factors (TEF)-adjusted concentration calculations.

  • When a sample result of TCDD or DLC is reported as detected, but less than the minimum level (or interim minimum level), the sample result should be reported as the value mid-way between the method detection level and the minimum level (or interim minimum level), this value must be used to derive the TEQ for each compound (see Recommended Toxicity Equivalence Factors (TEFs) for Human Health Risk Assessments of 2,3,7,8- Tetrachlorodibenzo-p-dioxin and Dioxin-Like Compounds, December 2010, EPA/100/R 10/005).

  • The test procedure specified by the instrument manufacturer shall be followed and the acceptance limit applied shall be as follows in Table A2.1. (3) An example of a typical test procedure is outlined in A2.7APP 2 -2 PTC 223: 2004 Table A2.1 Equivalence Factors for Testing Ionic Contamination Method A2.4Inspection lot for cleanliness verification(1) An inspection lot for cleanliness verification shall consist of all PWA's processed through the cleaning process during a single production shift.

  • As discussed later, hazard indices are not strictly calculations of risk, but rather regulatory or policy constructs related as much to a qualitative sense of margins of safety as they are to probabilities and se- verities of effect.A variant with more scientific complexity, and related more directly to risk than is a hazard index, is the use of Toxicity Equivalence Factors [7,28-31], such as those used in the class of dioxin-like compounds, or amongst classes of pesticides.

  • This in turn includes emission limit values for mixtures of dioxins and furans that are based on the toxicological concept of Toxic Equivalence Factors (TEF).

Related to Equivalence Factors

  • Performance Factors means any of the factors selected by the Committee and specified in an Award Agreement, from among the following objective measures, either individually, alternatively or in any combination, applied to the Company as a whole or any business unit or Subsidiary, either individually, alternatively, or in any combination, on a GAAP or non-GAAP basis, and measured, to the extent applicable on an absolute basis or relative to a pre-established target, to determine whether the performance goals established by the Committee with respect to applicable Awards have been satisfied:

  • Technique factors means the following conditions of operation:

  • Performance Factor means any matter that could or will significantly affect a party’s ability to fulfill its obligations under this Agreement;

  • equivalence means the state wherein mandatory requirements applied in the exporting Party, though different from the mandatory requirements applied in the importing Party, meet the legitimate objective of the mandatory requirements applied in the importing Party;

  • Weighting factor wT for an organ or tissue (T) means the proportion of the risk of stochastic effects resulting from irradiation of that organ or tissue to the total risk of stochastic effects when the whole body is irradiated uniformly. For calculating the effective dose equivalent, the values of wT are:

  • Sustainability Factors means environmental, social and employee matters, respect for human rights, anti‐corruption and anti‐bribery matters.

  • Multiplier means 1.0.

  • Applicable Multiplier means, with respect to any Rate Period for any Series of RVMTP Shares, the percentage set forth opposite the applicable credit rating most recently assigned to such Series by the Rating Agency in the table below on the Rate Determination Date for such Rate Period: Long-Term Ratings* Fitch Applicable Multiplier AAA to AA- 100% A+ to A- 000% BBB+ to BBB- 140% *And/or the equivalent ratings of any other Rating Agency then rating the RVMTP Shares utilizing the highest of the ratings of the Rating Agencies then rating the RVMTP Shares.

  • Leverage Factor means the leverage factor in respect of a Series of ETP Securities as specified in the relevant Final Terms.

  • Weighting with respect to an Underlying means the weighting in relation to the relevant Underlying as specified in the table in the definition of such Underlying.

  • Loss Factor means the scaling factor determined in accordance with clause 7 and applied by the reconciliation manager to volumes of electricity measured or estimated in respect of ICPs on the Network, in order to reflect the impact of the ICP on Losses within the Network;

  • Leakage technique factors means the technique factors associated with the diagnostic or therapeutic source assembly which are used in measuring leakage radiation. They are defined as follows:

  • Daily Measurement Value means the Specified Dollar Amount (if any), divided by 40.

  • Accrual Components As specified in the Preliminary Statement.

  • NET INVESTMENT FACTOR The Net Investment Factor is an index applied to measure the investment performance of a Subaccount from one Valuation Period to the next. The Net Investment Factor for any Subaccount for any Valuation Period is determined by dividing (1) by (2) and subtracting (3) from the result, where:

  • Stress Factor means 2.25.

  • Fully Diluted Weighted Average Basis means, when calculating the number of Outstanding Units for any period, a basis that includes (a) the weighted average number of Outstanding Units during such period plus (b) all Partnership Interests and Derivative Partnership Interests (i) that are convertible into or exercisable or exchangeable for Units or for which Units are issuable, in each case that are senior to or pari passu with the Subordinated Units, (ii) whose conversion, exercise or exchange price, if any, is less than the Current Market Price on the date of such calculation, (iii) that may be converted into or exercised or exchanged for such Units prior to or during the Quarter immediately following the end of the period for which the calculation is being made without the satisfaction of any contingency beyond the control of the holder other than the payment of consideration and the compliance with administrative mechanics applicable to such conversion, exercise or exchange and (iv) that were not converted into or exercised or exchanged for such Units during the period for which the calculation is being made; provided, however, that for purposes of determining the number of Outstanding Units on a Fully Diluted Weighted Average Basis when calculating whether the Subordination Period has ended or Subordinated Units are entitled to convert into Common Units pursuant to Section 5.7, such Partnership Interests and Derivative Partnership Interests shall be deemed to have been Outstanding Units only for the four Quarters that comprise the last four Quarters of the measurement period; provided further, that if consideration will be paid to any Group Member in connection with such conversion, exercise or exchange, the number of Units to be included in such calculation shall be that number equal to the difference between (x) the number of Units issuable upon such conversion, exercise or exchange and (y) the number of Units that such consideration would purchase at the Current Market Price.

  • Valuation Percentage means, for any item of Eligible Collateral, the percentage specified in Paragraph 13.

  • Adjustment Factor means, with respect to a share of the Fund (or one unit of any other security for which a Fund Closing Price must be determined), 1.0, subject to adjustment in the event of certain events affecting the shares of the Fund. See “—Anti-dilution Adjustments Relating to the Fund; Alternate Calculation —Anti-dilution Adjustments” below.

  • Class Factor As to any date of determination and any Class of Certificates (other than the Interest Only Classes and the Residual Certificates), a fraction the numerator of which is (i) the aggregate of the denominations of all Certificates of such Class plus, in the case of each Accrual Class, all interest that has accrued on the Certificates of such Class prior to such date of determination and been added to the Class Balance thereof, less (ii) the aggregate amount of all Principal Distribution Amounts, if any, allocable thereto prior to such date of determination and the denominator of which is the original Class Balance of such Class. As to any date of determination and any Interest Only Class, a fraction, the numerator of which is the percentage of the balance specified for such purpose under “Reference Sheet–Notional Classes” in the Prospectus Supplement (or, if applicable, the sum of the applicable percentages of the balances so specified) and the denominator of which is the original Class Balance thereof. Code: The Internal Revenue Code of 1986, as amended, including any successor or amendatory provisions.

  • Specific Nomination Factors means the nomination factors set out in clause 4.3.

  • Significance Percentage With respect to any Distribution Date, and in accordance with Item 1115 of Regulation AB, shall be a percentage equal to the Significance Estimate divided by the aggregate outstanding Certificate Principal Balance of the Certificates, prior to the distribution of the Principal Distribution Amount on such Distribution Date.

  • Relative TSR means the Company’s TSR relative to the TSR of the Peer Companies. Following the calculation of the TSR of the Company and each Peer Company for the Performance Period, the Company and each Peer Company will be ranked in order of maximum to minimum according to their respective TSR for the Performance Period. After this ranking, the percentile performance of the Company relative to the Peer Companies will be determined as follows:

  • Power Factor means the ratio of usage power measured in kW to total power measured in kVA;

  • Performance Measure means one or more of the following selected by the Committee to measure Company, Affiliate, and/or business unit performance for a Performance Period, whether in absolute or relative terms (including, without limitation, terms relative to a peer group or index): basic, diluted, or adjusted earnings per share; sales or revenue; earnings before interest, taxes, and other adjustments (in total or on a per share basis); basic or adjusted net income; returns on equity, assets, capital, revenue or similar measure; economic value added; working capital; total shareholder return; and product development, product market share, research, licensing, litigation, human resources, information services, mergers, acquisitions, sales of assets of Affiliates or business units. Each such measure shall be, to the extent applicable, determined in accordance with generally accepted accounting principles as consistently applied by the Company (or such other standard applied by the Committee) and, if so determined by the Committee, and in the case of a Performance Compensation Award, to the extent permitted under Code Section 162(m), adjusted to omit the effects of extraordinary items, gain or loss on the disposal of a business segment, unusual or infrequently occurring events and transactions and cumulative effects of changes in accounting principles. Performance Measures may vary from Performance Period to Performance Period and from Participant to Participant, and may be established on a stand-alone basis, in tandem or in the alternative.

  • Applicable Measurement Period means the most recently completed four consecutive fiscal quarters of the Issuer immediately preceding the Applicable Calculation Date for which internal financial statements are available.