The Facilities Subject to the terms of this Agreement, the Lenders make available to the Borrowers:
Other Factors The Employer may provide for additional formal and informal evaluations as it shall determine to be necessary for the proper conduct of the educational program and the utilization of its employees. The evaluation opinions of the Employer shall not be subject to the Grievance Procedure if the procedures herein set forth have been followed.
The Facility Subject to the terms of this Agreement, the Lenders make available to the Borrower a term loan facility in an aggregate amount equal to the Total Commitments.
The FTPS Unit Servicing Agent shall distribute to redeeming FTPS Unit holders of record on its books redemption proceeds it receives pursuant to Section 5.02 of the Standard Terms and Conditions of Trust from the Trustee as the sole record owner of FTPS Units on the Trustee's books.
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
ADJUSTMENT FACTORS The Contractor will perform any or all Tasks in the Construction Task Catalog for the Unit Price appearing therein multiplied by the following Adjustment Factors. See the General Terms and Conditions for additional information.
The Front end Fee payable by the Borrower shall be equal to one quarter of one percent (0.25%) of the Loan amount.
Performance Evaluations 34.1. The Contractor is subject to an annual performance evaluation to be conducted by NYCDOT pursuant to the PPB Rules.