Host-Remote When a CenturyLink Wire Center is served by a Remote Switch, CLEC may deliver traffic to the host Central Office or to the Tandem Switch. CLEC may not directly trunk to a Remote Switch. 7.2.2.10 Testing
Synchronous Generation The Interconnection Customer shall design its Small Generating Facility to maintain a composite power delivery at continuous rated power output at the Point of Interconnection at a power factor within the range of 0.95 leading to 0.95 lagging, unless the NYISO or the Transmission Owner in whose Transmission District the Small Generating Facility interconnects has established different requirements that apply to all similarly situated generators in the New York Control Area or Transmission District (as applicable) on a comparable basis, in accordance with Good Utility Practice.
Remote Work Remote work is the practice of performing required job functions from home or another management-approved location. Any employee who believes that all or part of their position is suitable for remote work may request to work remotely by submitting a written request to their supervisor. The Employer will evaluate the employee's request, and will approve or deny the request in writing. Employees whose requests to work remotely are approved may be required to sign an agreement confirming expectations regarding their schedule, timekeeping, remote work environment, data/information security and other matters specific to their position.
Non-Synchronous Generation The Interconnection Customer shall design its Small Generating Facility to maintain a composite power delivery at continuous rated power output at the high-side of the generator substation at a power factor within the range of 0.95 leading to 0.95 lagging, unless the NYISO or the Transmission Owner in whose Transmission District the Small Generating Facility interconnects has established a different power factor range that applies to all similarly situated non-synchronous generators in the control area or Transmission District (as applicable) on a comparable basis, in accordance with Good Utility Practice. This power factor range standard shall be dynamic and can be met using, for example, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors, or a combination of the two. This requirement shall only apply to newly interconnecting non-synchronous generators that have not yet executed a Facilities Study Agreement as of September 21, 2016.
Remote Access Access to and use of the Data over the State Governmental Network (SGN) or Secure Access Washington (SAW) will be controlled by DSHS staff who will issue authentication credentials (e.g. a Unique User ID and Hardened Password) to Authorized Users on Contractor’s staff. Contractor will notify DSHS staff immediately whenever an Authorized User in possession of such credentials is terminated or otherwise leaves the employ of the Contractor, and whenever an Authorized User’s duties change such that the Authorized User no longer requires access to perform work for this Contract.
Violations - Remote Scaling Requirement If PURCHASER violates any of the log accountability requirements of this contract, STATE may require all logs from timber sold under the terms and conditions of this contract to be scaled at a ramp provided by PURCHASER, in a location designated by STATE. All costs associated with this additional scaling requirement shall be paid by PURCHASER. Cost of Scaling. All costs of scaling and all costs in connection with reports furnished to STATE shall be paid by PURCHASER. PURCHASER shall require the scaling organization to furnish copies each week to STATE of all scaled certificates showing gross and net volumes, by species and grade, of all logs scaled during the week. Upon request by STATE, PURCHASER shall also require the scaling organization to furnish and attach a log detail listing to each weekly scale certificate showing all STATE logs included on the certificate. Scaling Instructions. PURCHASER agrees that STATE shall provide instructions to the approved third-party scaling organization for the scaling practices to be used for timber removed from the timber sale area. Instructions shall conform to the terms of this contract, including special scales as necessary. PURCHASER shall acknowledge and sign such instructions and shall be provided a copy. Minimum Products Specifications and Special Scale information are shown on Exhibit G. Logs Damaged During Handling. Mechanical damage to logs shall be prevented during log handling. Deductions for handling damage shall not be allowed. Add-Back Volume. Scaling deduction for deterioration due to abnormal delay in removal of logs from the timber sale area shall not be allowed in determining net volume. Volume of material deteriorated due to delay in removal shall be reported to STATE and paid for at the contract price. Cost for separate reports shall be paid by PURCHASER. Special Scaling Instructions. Segment scaling or grading of logs in excess of 40 feet in gross scaling length shall use actual taper. Procedures are set forth in "Segment Scaling and Grading of Long Logs - All Species - State Forestry Department Scaling Instructions" (Westside).
Remote Terminal Unit Prior to the Initial Synchronization Date of the Large Generating Facility, a Remote Terminal Unit, or equivalent data collection and transfer equipment acceptable to the Parties, shall be installed by Developer, or by Connecting Transmission Owner at Developer’s expense, to gather accumulated and instantaneous data to be telemetered to the location(s) designated by Connecting Transmission Owner and NYISO through use of a dedicated point-to-point data circuit(s) as indicated in Article 8.1. The communication protocol for the data circuit(s) shall be specified by Connecting Transmission Owner and NYISO. Instantaneous bi-directional analog real power and reactive power flow information must be telemetered directly to the location(s) specified by Connecting Transmission Owner and NYISO. Each Party will promptly advise the appropriate other Party if it detects or otherwise learns of any metering, telemetry or communications equipment errors or malfunctions that require the attention and/or correction by that other Party. The Party owning such equipment shall correct such error or malfunction as soon as reasonably feasible.
Inventory Report – Remote Premises The locations of the Remote Premises (e.g., Feeder Distribution Interfaces, "FDI") and the End User Customer addresses served by each Remote Premises are available to CLEC through the Raw Loop Data Tool. Remote Premises with digital loop carrier and pair gain equipment will be provided on the web site in the ICONN database. (ICONN is available through the Qwest web site located at xxxx://xxx.xxxxx.xxx/iconn.) If CLEC is unable to determine the information it seeks regarding the Remote Premises after using such database tools, Qwest will provide CLEC with a report that contains the information. The Parties agree that a charge may apply to such report, based on time and material, unless the database information is inaccurate or unusable for the Remote Premises then no charge would apply. Qwest will provide CLEC access to relevant plats, maps, engineering records and other data in accordance with Section 10.8.2.4. In addition, CLEC can request a copy of Qwest's distribution area map associated with the Remote Premises, with a charge for time and material.
We provide Message Boards for the use of Our Website users The Message Boards may not be used to promote Websites or any commercial or business activity. We are not responsible for any of the opinions expressed in the Message Boards. By posting a message to the message board You agree to take full legal responsibility and liability for your comments, including for offensive or defamatory statements. Feedback: Feedback is provided for the purpose of facilitating trading by You on Our Website. Feedback provided on other parties must not contain offensive, defamatory, retaliatory or inappropriate language or content. We may remove any feedback that is considered to be offensive, defamatory, retaliatory or inappropriate. You may only give feedback that relates to a specific transaction. You must not post feedback on a transaction that does not relate to that specific transaction. You must not post feedback about Yourself or include any contact details or Personal Information in Your feedback.
Remote Support 3.11.1 Remote Support, covering telephone support at minimum, is mandatory, when and throughout the period the Software is being used at Live State, unless otherwise agreed in writing between HW and the Licensee.
