Supply Agreement Seller and Buyer, or their Affiliates, shall have executed the Supply Agreement.
Supply of Products During the term of this Agreement and any extension hereof, the Seller shall sell and supply the products as set out in Schedule 1 hereto (“Products”) to SiPM and SiPM shall buy from the Seller such Products on a non-exclusive basis. The specifications of the Products are set out in Schedule 2 hereto. SUPPLY AGREEMENT - SiPM A Supply Agreement is a document between two parties, a Supplier and a Purchaser. The Supplier can be an individual or business and is the party that " supplies," or sells, the goods to the Purchaser. The Purchaser can also be an individual or a business and is the party that purchases for its use the goods that the Supplier provides.
Supply of Product 3.1 In accordance with the terms of this Agreement, GENSIA SICOR (through SICOR) shall supply all of PURCHASER'S ordered requirements for Product in bulk form for use by PURCHASER in the Territories in accordance with the provisions of this Agreement. The right and license of PURCHASER to obtain, use and distribute Product (including, without limitation, the right to make or have made Product) from GENSIA SICOR and SICOR shall be (i) non-exclusive in the Non-exclusive Territory, and (ii exclusive in the Exclusive Territory; provided, however, that the rights and licenses set forth in clause (ii) above shall be co-exclusive in each jurisdiction in which GENSIA SICOR (or ALCO or SICOR, as the case may be) has binding written agreements, or binding written commitments that will lead to binding written agreements, to sell Product on the Restatement Date (which is limited to only those [ * ] and the [ * ] with whom GENSIA SICOR has commitments that are in existence on the Restatement Date), but only with respect to such third parties and only until the earlier of expiration or termination of such agreements; and provided, further that GENSIA SICOR shall use all diligent efforts (without any obligation to violate or alter the terms of such agreements existing on the Restatement Date) to provide PURCHASER with exclusive rights and licenses to sell the Products in the Territory as soon as possible. All Product hereunder shall be manufactured at SICOR's GMP facilities at Rho, Italy, the facility identified in Exhibit 9 hereto, the Santxx Xxxility and additional (as necessary and as provided in Section 6 below) GMP qualified facilities that are approved in advance by PURCHASER (which approval will not be unreasonably withheld). In addition, all Product shall be manufactured (A) in accordance with drug substance manufacturing and quality control procedures existing on the Effective Date, which drug substance manufacturing and quality control procedures have been included in manufacturer's Abbreviated Antibiotic Drug Application ("AADA") submitted to the FDA in 1996, and that will be submitted to other Regulatory Authorities in the Territory (which AADA shall include at least the elements set forth in the Drug Master File) in accordance with U.S. FDA current Good Manufacturing Practices, and (B) to the Q/C Specifications. GENSIA SICOR shall cause SICOR to use its diligent efforts to [ * ] in order to produce and supply all Product ordered by Purchaser hereunder and to meet the Product [ * ] that will be set forth in Schedule 1 hereto within [ * ] after the Restatement Date. In addition, GENSIA SICOR agrees to the following (and GENSIA SICOR agrees to cause SICOR to undertake):
EVENTS CONSTITUTING MATERIAL BREACH OF AGREEMENT The Applicant shall be in Material Breach of this Agreement if it commits one or more of the following acts or omissions (each a “Material Breach”):
Reimbursements and Purchase Orders Expense reimbursement is not guaranteed and, when possible, Board members should seek pre- approval of expenses by providing an estimation of expenses on the Board's standardized estimated expense approval form, except in situations when the expense is diminutive. When pre-approval is not sought, Board members must seek reimbursement on the Board's standardized expense reimbursement form. Expense reimbursements and purchase orders shall be presented to the Board in its regular bill process. Credit and Procurement Cards
Marking of Licensed Products To the extent commercially feasible and consistent with prevailing business practices, Company shall xxxx, and shall cause its Affiliates and Sublicensees to xxxx, all Licensed Products that are manufactured or sold under this Agreement with the number of each issued patent under the Patent Rights that applies to such Licensed Product.
Supply of Materials The following materials will be supplied by the department Name of Materials Rate. Place of delivery 1.
Xxxxx of License; Limitations The Engineer is granted a limited revocable non-exclusive license to use the registered TxDOT trademark logo (TxDOT Flying “T”) on any deliverables prepared under this contract that are the property of the State. The Engineer may not make any use of the registered TxDOT trademark logo on any other materials or documents unless it first submits that request in writing to the State and receives approval for the proposed use. The Engineer agrees that it shall not alter, modify, dilute, or otherwise misuse the registered TxDOT trademark logo or bring it into disrepute.
AUDIT OF LICENSED PRODUCT USAGE Contractor shall have the right to periodically audit, no more than annually, at Contractor’s expense, use of licensed Product at any site where a copy of the Product resides provided that: (i) Contractor gives Licensee(s) at least thirty (30) days advance written notice, (ii) such audit is conducted during such party’s normal business hours, (iii) the audit is conducted by an independent auditor chosen on mutual agreement of the parties. Contractor shall recommend a minimum of three (3) auditing/accounting firms from which the Licensee will select one (1). In no case shall the Business Software Alliance (BSA), Software Publishers Association (SPA), Software and Industry Information Association (SIIA) or Federation Against Software Theft (FAST) be used directly or indirectly to conduct audits, or be recommended by Contractor; (iv) Contractor and Licensee are each entitled to designate a representative who shall be entitled to participate, and who shall mutually agree on audit format, and simultaneously review all information obtained by the audit. Such representatives also shall be entitled to copies of all reports, data or information obtained from the audit; and (v) if the audit shows that such party is not in compliance, Licensee shall be required to purchase additional licenses or capacities necessary to bring it into compliance and shall pay for the unlicensed capacity at the NYS Net Price in effect at time of audit, or if none, then at the Contractor’s U.S. Commercial list price. Once such additional licenses or capacities are purchased, Licensee shall be deemed to have been in compliance retroactively, and Licensee shall have no further liability of any kind for the unauthorized use of the software.
Supply Agreements For a period of three years from the consummation of the IPO, Odetics shall not unilaterally terminate or assign its guarantee obligation with respect to any supply agreement pursuant to which it has guaranteed the performance by ATL of ATL's obligations, unless such suppliers have consented to the termination or assignment of such guarantee.
