Steelhead Planned Spawning Flow Sample Clauses

Steelhead Planned Spawning Flow. During the steelhead spawning period, Planned Spawning Flows shall not exceed the flows indicated by the most current Spawning Control Curve, which is determined as shown in Appendix E (Shaping of Flows During Steelhead Spawning). Further, to the extent Xxxx Xxxx has sufficient storage volume to contain and shape the forecast runoff without causing spill, Planned Spawning Flows shall be less than the following amounts: 5,000 cfs for March steelhead, 5,000 cfs for April steelhead, and 4,000 for May through June 15 steelhead, unless the forecasted inflow and storage is great enough to provide incubation flows for higher Season Spawning Flows. Any Planned Spawning Flows greater than the flow ranges above shall not be implemented prior to discussion in the FCC. Spawning flows shall be shaped such that they result in reservoir elevations greater than or equal to the Spawning Control Curve and less than the Spill Control Curve as described in Appendix E. The City shall endeavor to provide uniform Season Spawning Flows over the entire spawning period as described in Appendix E. The actual Season Spawning Flow for each subperiod shall be defined as the average of the highest ten (10) Daily Spawning Flows at the Newhalem gage during each spawning subperiod. Daily Spawning Flow shall be calculated as shown in Appendix A, Part 1 (Calculation of Spawning Flow).
AutoNDA by SimpleDocs

Related to Steelhead Planned Spawning Flow

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Summer Session A. All ASEs employed in the Summer Session shall receive the same general range adjustment as ASEs received in the preceding Fall term.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • GARBAGE DISPOSAL, RECYCLING, AND BIODEGRADABLE MATERIALS A. Concessionaire shall be responsible for maintaining the cleanliness of the Concession Premises. Concessionaire shall ensure placement of all garbage and trash generated by the Concession Operation in designated containers and that said containers are emptied daily, or as more frequently required by Department, at a location within the Area designated by Department. Disposal costs from this latter location shall be borne by Department. Concessionaire shall provide such additional trash containers as may be required to keep the immediate Concession Premises clean at all times. The type of trash containers provided by Concessionaire shall be approved by Department prior to use.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Business Continuity Planning Supplier shall prepare and maintain at no additional cost to Buyer a Business Continuity Plan (“BCP”). Upon written request of Buyer, Supplier shall provide a copy of Supplier’s BCP. The BCP shall be designed to ensure that Supplier can continue to provide the goods and/or services in accordance with this Order in the event of a disaster or other BCP-triggering event (as such events are defined in the applicable BCP). Supplier’s BCP shall, at a minimum, provide for: (a) the retention and retrieval of data and files; (b) obtaining resources necessary for recovery, (c) appropriate continuity plans to maintain adequate levels of staffing required to provide the goods and services during a disruptive event; (d) procedures to activate an immediate, orderly response to emergency situations; (e) procedures to address potential disruptions to Supplier’s supply chain; (f) a defined escalation process for notification of Buyer, within two (2) business days, in the event of a BCP-triggering event; and (g) training for key Supplier Personnel who are responsible for monitoring and maintaining Supplier’s continuity plans and records. Supplier shall maintain the BCP and test it at least annually or whenever there are material changes in Supplier’s operations, risks or business practices. Upon Xxxxx’s written and reasonable request, Supplier shall provide Buyer an executive summary of test results and a report of corrective actions (including the timing for implementation) to be taken to remedy any deficiencies identified by such testing. Upon Xxxxx’s request and with reasonable advance notice and conducted in such a manner as not to unduly interfere with Supplier’s operations, Supplier shall give Buyer and its designated agents access to Supplier’s designated representative(s) with detailed functional knowledge of Supplier’s BCP and relevant subject matter.

Time is Money Join Law Insider Premium to draft better contracts faster.