Compliance with Treasury Regulations The foregoing provisions and other provisions contained herein relating to the maintenance of Book Capital Accounts and Tax Capital Accounts are intended to comply with Treasury Regulations Section 1.704-1(b), and shall be interpreted and applied in a manner consistent with such Treasury Regulations. The Trustees shall make any appropriate modifications in the event unanticipated events might otherwise cause these procedures not to comply with Treasury Regulations Section 1.704-1(b), including the requirements described in Treasury Regulations Section 1.704- 1(b)(2)(ii)(b)(1) and Treasury Regulations Section 1.704-1(b)(2)(iv). Such modifications are hereby incorporated into these procedures by this reference as though fully set forth herein.
Compliance with Section 409A of the Code All payments and benefits payable under this Agreement (including, without limitation, the Section 409A Payments) are intended to comply with the requirements of Section 409A of the Code. Certain payments and benefits payable under this Agreement are intended to be exempt from the requirements of Section 409A of the Code. This Agreement shall be interpreted in accordance with the applicable requirements of, and exemptions from, Section 409A of the Code and the Treasury Regulations thereunder. To the extent the payments and benefits under this Agreement are subject to Section 409A of the Code, this Agreement shall be interpreted, construed and administered in a manner that satisfies the requirements of Sections 409A(a)(2), (3) and (4) of the Code and the Treasury Regulations thereunder If the Company and the Executive determine that any compensation, benefits or other payments that are payable under this Agreement and intended to comply with Sections 409A(a)(2), (3) and (4) of the Code do not comply with Section 409A of the Code, the Treasury Regulations thereunder and other applicable authority issued by the Internal Revenue Service, to the extent permitted under Section 409A of the Code, the Treasury Regulations thereunder and any applicable authority issued by the Internal Revenue Service, the Company and the Executive agree to amend this Agreement, or take such other actions as the Company and the Executive deem reasonably necessary or appropriate, to cause such compensation, benefits and other payments to comply with the requirements of Section 409A of the Code, the Treasury Regulations thereunder and other applicable authority issued by the Internal Revenue Service, while providing compensation, benefits and other payments that are, in the aggregate, no less favorable than the compensation, benefits and other payments provided under this Agreement. In the case of any compensation, benefits or other payments that are payable under this Agreement and intended to comply with Sections 409A(a)(2), (3) and (4) of the Code, if any provision of the Agreement would cause such compensation, benefits or other payments to fail to so comply, such provision shall not be effective and shall be null and void with respect to such compensation, benefits or other payments to the extent such provision would cause a failure to comply, and such provision shall otherwise remain in full force and effect.
Treasury Regulations The term "Treasury Regulations" means the Income Tax Regulations, including temporary regulations, promulgated under the Code, as such regulations may be amended from time to time.
Compliance with Certain Requirements of Regulations; Deficit Capital Accounts In the event the Company is “liquidated” within the meaning of Regulations Section 1.704-1(b)(2)(ii)(g), distributions shall be made pursuant to this Article X to the Unit Holders who have positive Capital Accounts in compliance with Regulations Section 1.704-1(b)(2)(ii)(b)(2). If any Unit Holder has a deficit balance in such Member’s Capital Account (after giving effect to all contributions, distributions and allocations for all Fiscal Years, including the Fiscal Year during which such liquidation occurs), such Unit Holder shall have no obligation to make any contribution to the capital of the Company with respect to such deficit, and such deficit shall not be considered a debt owed to the Company or to any other Person for any purpose whatsoever. In the discretion of the Liquidator, a pro rata portion of the distributions that would otherwise be made to the Unit Holders pursuant to this Article X may be: (i) distributed to a trust established for the benefit of the Unit Holders for the purposes of liquidating Company assets, collecting amounts owed to the Company, and paying any contingent or unforeseen liabilities or obligations of the Company, in which case the assets of any such trust shall be distributed to the Unit Holders from time to time, in the reasonable discretion of the Liquidator, in the same proportions as the amount distributed to such trust by the Company would otherwise have been distributed to the Unit Holders pursuant to Section 10.2 of this Agreement; or (b) withheld to provide a reasonable reserve for Company liabilities (contingent or otherwise) and to reflect the unrealized portion of any installment obligations owed to the Company, provided that such withheld amounts shall be distributed to the Unit Holders as soon as practicable.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
Compliance with IRC Section 409A This Agreement is intended to comply with Section 409A of the Internal Revenue Code of 1986, as amended (the “Code”) and will be interpreted accordingly. References under this Agreement to the Employee’s termination of employment shall be deemed to refer to the date upon which the Employee has experienced a “separation from service” within the meaning of Section 409A of the Code. Notwithstanding anything herein to the contrary, (i) if at the time of the Employee’s separation from service with the Company or any of its affiliates the Employee is a “specified employee” as defined in Section 409A of the Code (and any related regulations or other pronouncements thereunder) and the deferral of the commencement of any payments or benefits otherwise payable hereunder or payable under any other compensatory arrangement between the Employee and the Company or any of its affiliates as a result of such separation from service is necessary in order to prevent any accelerated or additional tax under Section 409A of the Code, then the Company will defer the commencement of the payment of any such payments or benefits hereunder (without any reduction in such payments or benefits ultimately paid or provided to the Employee) until the date that is six months following the Employee’s separation from service (or the earliest date as is permitted under Section 409A of the Code), at which point all payments deferred pursuant to this Section 24 shall be paid to the Employee in a lump sum and (ii) if any other payments of money or other benefits due to the Employee hereunder could cause the application of an accelerated or additional tax under Section 409A of the Code, such payments or other benefits shall be deferred if deferral will make such payment or other benefits compliant under Section 409A of the Code, or otherwise such payment or other benefits shall be restructured, to the extent possible, in a manner that does not cause such an accelerated or additional tax. To the extent any reimbursements or in-kind benefits due to the Employee under this Agreement constitute “deferred compensation” under Section 409A of the Code, any such reimbursements or in-kind benefits shall be paid to the Employee in a manner consistent with Treasury Regulation Section 1.409A-3(i)(1)(iv). Without limiting the generality of the foregoing, the Employee shall notify the Company if he believes that any provision of this Agreement (or of any award of compensation, including equity compensation, or benefits) would cause the Employee to incur any additional tax under Code Section 409A and, if the Company concurs with such belief after good faith review or the Company independently makes such determination, then the Company shall use reasonable efforts to reform such provision to comply with Code Section 409A through good faith modifications to the minimum extent reasonably appropriate to conform with Code Section 409A. For purposes of Section 409A of the Code, each payment made under this Agreement shall be designated as a “separate payment” within the meaning of Section 409A of the Code.
Compliance with Section 409A of the Internal Revenue Code Payments and benefits provided under this Agreement as a result of Employee's termination of employment are intended to fall within the exception in U.S. Treasury Regulation 1.409A -1(b)(4) for short term deferrals or other applicable exceptions and will be interpreted and administered accordingly. However, to the extent that any payment under this Agreement is subject to Section 409A of the Code, it is intended to comply with Section 409A and this Agreement shall be interpreted and construed accordingly and in a manner that avoids the imposition of taxes and other penalties under Section 409A (such taxes and other penalties referred to collectively as "409A Penalties"). In the event that Klondex G&S determines that the terms of this Agreement would subject the Employee to 409A Penalties, Klondex G&S and the Employee shall cooperate diligently to amend the terms of this Agreement to avoid such 409A Penalties, to the extent possible; provided, however, that this Section 6.15 shall not create any obligation on the part of Klondex G&S to adopt any such amendment or take any such other action. All references in this Agreement to the Employee's termination of employment shall mean a "separation from service" within the meaning of Section 409A of the Code, to the extent required to comply with Section 409A of the Code. Any payment that is "deferred compensation" within the meaning of and subject to Section 409A of the Code that becomes payable as a result of the Employee's separation from service and that is conditioned upon the Employee's execution of a Release will be paid within 90 days following the Employee's separation from service and if such period begins in one taxable year and carries over into a second taxable year, payment shall be made in the second taxable year, and in no event shall the Employee have the ability to influence the year in which payment will occur. Notwithstanding any other provision in this Agreement, if on the date of the Employee's "separation from service" the Employee is a "specified employee," as defined in Section 409A of the Code, then to the extent any amount payable under this Agreement upon the Employee's separation from service would be a prohibited distribution under Section 409A(a)(2)(B)(i) of the Code, such payment shall be delayed until the earlier to occur of (x) the first day of the seventh month following the Employee's separation from service or (y) the date of the Employee's death.
Compliance with Code Section 409A The intent of the parties is that payments and benefits under this Agreement comply with or are exempt from Section 409A of the Code and this Agreement shall be interpreted and construed in a manner that establishes an exemption from (or compliance with) the requirements of Code Section 409A. Any terms of this Agreement that are undefined or ambiguous shall be interpreted in a manner that complies with Code Section 409A to the extent necessary to comply with Code Section 409A. Notwithstanding anything herein to the contrary, (i) if, on the date of termination, the Executive is a “specified employee” as defined in Section 409A of the Code, and the deferral of the commencement of any payments or benefits otherwise payable hereunder as a result of such termination of employment is necessary in order to prevent any accelerated or additional tax under Code Section 409A, then the Company will defer the commencement of the payment of any such payments or benefits hereunder (without any reduction in such payments or benefits ultimately paid or provided to the Executive) until the date that is the first business day of the seventh month following the date of termination (or the earliest date as is permitted under Code Section 409A), and (ii) if any other payments of money or other benefits due to the Executive hereunder could cause the application of an accelerated or additional tax under Code Section 409A, such payments or other benefits shall be deferred if deferral will make such payment or other benefits compliant under Code Section 409A. In the event that payments under this Agreement are deferred pursuant to this Section in order to prevent any accelerated tax or additional tax under Code Section 409A, then such payments shall be paid at the time specified under this Section without any interest thereon. Notwithstanding anything to the contrary herein, to the extent required by Code Section 409A, a termination of employment shall not be deemed to have occurred for purposes of any provision of this Agreement providing for the payment of amounts or benefits upon or following a termination of employment unless such termination is also a “separation from service” within the meaning of Section 409A of the Code and, for purposes of any such provision of this Agreement, references to a “termination,” “termination of employment” or like terms shall mean separation from service. Each payment made under this Agreement shall be treated as a separate payment and the right to a series of installment payments under this Agreement is to be treated as a right to a series of separate payments.
Compliance with Federal Law, Regulations, and Executive Orders This is an acknowledgement that FEMA financial assistance will be used to fund all or a portion of the contract. The contractor will comply with all applicable Federal law, regulations, executive orders, FEMA policies, procedures, and directives.
Compliance with Internal Revenue Code Section 409A The Employer and the Executive intend that their exercise of authority or discretion under this Agreement shall comply with section 409A of the Internal Revenue Code of 1986. If when the Executive’s employment terminates the Executive is a specified employee, as defined in section 409A of the Internal Revenue Code of 1986, and if any payments under this Agreement, including Articles 4 or 5, will result in additional tax or interest to the Executive because of section 409A, then despite any provision of this Agreement to the contrary the Executive shall not be entitled to the payments until the earliest of (x) the date that is at least six months after termination of the Executive’s employment for reasons other than the Executive’s death, (y) the date of the Executive’s death, or (z) any earlier date that does not result in additional tax or interest to the Executive under section 409A. As promptly as possible after the end of the period during which payments are delayed under this provision, the entire amount of the delayed payments shall be paid to the Executive in a single lump sum. If any provision of this Agreement does not satisfy the requirements of section 409A, the provision shall be applied in a manner consistent with those requirements despite any contrary provision of this Agreement. If any provision of this Agreement would subject the Executive to additional tax or interest under section 409A, the Employer shall reform the provision. However, the Employer shall maintain to the maximum extent practicable the original intent of the applicable provision without subjecting the Executive to additional tax or interest, and the Employer shall not be required to incur any additional compensation expense as a result of the reformed provision. References in this Agreement to section 409A of the Internal Revenue Code of 1986 include rules, regulations, and guidance of general application issued by the Department of the Treasury under Internal Revenue Code section 409A.
